Franke FTC632XSAU Bedienungsanleitung

Instructions for use and installation

Rangehood

FTC632XSAU

INDEX

SAFETY INFORMATION .....................................................................................................................................................3

CHARACTERISTICS ...........................................................................................................................................................6

INSTALLATION ....................................................................................................................................................................7

USE .....................................................................................................................................................................................9

MAINTENANCE .................................................................................................................................................................10

SAFETY INFORMATION

For your safety and correct operation of the appliance, read this manual

carefully before installation and use. Always keep these instructions

with the appliance even if you move or sell it. Users must fully know the

operation and safety features of the appliance.

The wire connection has to be done by specialized technician.

•The manufacturer will not be held liable for any damages resulting from

incorrect or improper installation.

•The minimum safety distance between the cook top and the extractor

hood is 650 mm (some models can be installed at a lower height,

please refer to the paragraphs on working dimensions and installation).

•If the instructions for installation for the gas cooktop specify a greater

distance, this must be respected.

•Check that the mains voltage corresponds to that indicated on the

rating plate fixed to the inside of the hood.

•Means for disconnection must be incorporated in the fixed wiring in

accordance with the wiring rules.

•For Class I appliances, check that the domestic power supply

guarantees adequate earthing.

•Connect the extractor to the exhaust flue through a pipe of minimum

diameter 120 mm. The route of the flue must be as short as possible.

•Regulations concerning the discharge of air have to be fulfilled.

•Do not connect the extractor hood to exhaust ducts carrying

combustion fumes (boilers, fireplaces, etc.).

•If the extractor is used in conjunction with non-electrical appliances (e.g.

gas burning appliances), a sufficient degree of aeration must be

guaranteed in the room in order to prevent the backflow of exhaust gas.

When the rangehood is used in conjunction with appliances supplied

with energy other than electric, the negative pressure in the room must

not exceed 0,04 mbar to prevent fumes being drawn back into the room

by the rangehood.

•The air must not be discharged into a flue that is used for exhausting

fumes from appliances burning gas or other fuels.

•If the supply cord is damaged, it must be replaced from the manufac-

turer or its service agent.

•Connect the plug to a socket complying with current regulations, locat-

ed in an accessible place.

•With regards to the technical and safety measures to be adopted for

fume discharging it is important to closely follow the regulations provid-

ed by the local authorities.

WARNING: Before installing the Hood, remove the protective films.

•Use only screws and small parts in support of the hood.

WARNING: Failure to install the screws or fixing device in accordance

with these instructions may result in electrical hazards.

•Allow disconnection of the appliance from the supply after installation.

This disconnection may be achieved by having the plug accessible or by

incorporating a switch in the fixed wiring in accordance with the wiring

rules

•Do not look directly at the light through optical devices (binoculars,

magnifying glasses…).

•Do not flambè under the range hood; risk of fire.

•This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities or lack of

experience and knowledge unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for

their safety.

•Cleaning and user maintenance shall not be made by children without

supervision.

•Children should be supervised to ensure that they do not play with the

appliance.

•

The appliance is not to be used by persons (including children) with re-

duced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction.

Accessible parts may become hot when used with cooking appliances.

•Clean and/or replace the Filters after the specified time period (Fire

hazard). See paragraph Care and Cleaning.

•There shall be adequate ventilation of the room when the range hood is

used at the same time as appliances burning gas or other fuels (not

applicable to appliances that only discharge the air back into the room).

•The symbol on the product or on its packaging indicates that this

product may not be treated as household waste. Instead it shall be

handed over to the applicable collection point for the recycling of elec-

trical and electronic equipment. By ensuring this product is disposed of

correctly, you will help prevent potential negative consequences for the

environment and human health, which could otherwise be caused by

inappropriate waste handling of this product. For more detailed infor-

mation about recycling of this product, please contact your local city of-

fice, your household waste disposal service or the shop where you pur-

chased the product.

CHARACTERISTICS

Dimensions

Min.

450mm

Min.

650mm

Components

Ref. Q.ty Product Components

1 1 Hood Body, complete with: Controls, Light, Blower,

Filters

8 1 Directional Air Outlet grille

20 1 Closing element

Ref. Q.ty Installation Components

12a 4 Screws 4,2 x 44,4

12b 2 Screws 4,2 x 12,7

12e 2 Screws 2,9 x 12,7

Q.ty Documentation

1 Instruction Manual

12b

INSTALLATION

Drilling the Support surface and Fitting the Hood

SCREW FITTING

• The hood support surface must be 135 mm above the bottom

surface of the wall units.

• Drill the support with a ø 4,5 mm drill bit, using the drilling

template provided.

• Cut a hole ø 125 mm in size on the support surface, using the

drilling template provided.

• Fix using the 4 screws 12a (4,2 x 44,4) provided.

12a

135

125125

SNAP-ON FITTING

• The hood can be installed either directly on the bottom surface

of the wall units using snap-on side supports.

• Cut a fitted opening in the bottom surface of the wall unit, as

shown.

• Insert the hood until the side supports snap into place.

• Lock in position by tightening the screws Vf from underneath

the hood.

Hood Type 45 50 55 60 70 80 90

L1 360 410 460 510 610 710 810

262

CLOSING ELEMENT

• The space between the edge of the hood and the rear wall can

be closed by applying the element 20 provided, using the

screws 12b.

12b

Connections

DUCTED VERSION AIR EXHAUST SYSTEM

When installing the ducted version, connect the hood to

the chimney using either a flexible or rigid pipe ø120

mm, the choice of which is left to the installer.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Remove any activated charcoal filters.

ø 120

RECIRCULATION VERSION AIR OUTLET

• Cut a hole ø 125 mm in any shelf that may be posi-

tioned over the hood.

• Connect the flange to the outlet on the shelf over the

hood using a flexible or rigid pipe ø120 mm.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Fix the directional grille 8on the recirculation air

outlet using the 2 screws 12e (2,9 x 9,5) provided.

• Ensure that the activated charcoal filters have been

inserted.

12e

125

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole switch having a contact gap of at least 3

mm.

• When opening the sliding carriage for the first time after installing the hood, pull it out

briskly until it clicks.

USE

Control panel

Light Switches the lighting system

on and off.

MMotor Switches the extractor motor

on and off.

VSpeed Sets the operating speed of

the extractor:

1. Low speed, used for a

continuous and silent air

change in the presence of

light cooking vapour.

2. Medium speed, suitable

for most operating condi-

tions given the optimum

treated air flow/noise lev-

el ratio.

3. Maximum speed, used for

eliminating the highest

cooking vapour emission,

including long periods.

Light Switches the lighting system

on and off.

MMotor Switches the extractor motor

on and off.

VSpeed Sets the operating speed of

the extractor:

1. Low speed, used for a

continuous and silent air

change in the presence of

light cooking vapour.

2. Medium speed, suitable

for most operating condi-

tions given the optimum

treated air flow/noise lev-

el ratio.

M - V

M-V

MAINTENANCE

Grease filters

CLEANING METAL CASSETTE GREASE FILTERS

• The filters must be cleaned every 2 months, or more frequently

in case of particularly heavy use of the hood. Filters can be

washed in a dishwasher.

• Pull out the sliding suction panel.

• Remove the filters one by one, after having disconnected the

relative fastening elements.

• Wash the filters, taking care not to bend them. Let them get dry

before refitting them. (The colour of the filter surface may

change throughout the time but this has no influence to the fil-

ter efficiency).

• When refitting the filters, make sure that the handle is visible

on the outside.

• Close the sliding suction panel.

Charcoal filter (Recycling version)

REPLACING CHARCOAL FILTERS

Warning: Turn the lights off and wait until the lamps cool down

before you change the odour filter.

• These filters are not washable and cannot be regenerated, and

must be replaced approximately every four months or more

frequently by particularly heavy use.

• Pull out the sliding suction panel.

• Remove the grease filters.

• Remove the saturated carbon filter by releasing the fixing

hooks

• Fit the new filter by hooking it into its seating.

• Replace the grease filters.

• Close the sliding suction panel.

Inhaltsverzeichnis

Andere Franke Dunstabzugshaube Handbücher

Franke

Franke FCS 90 NF EV8 Bedienungsanleitung

Franke

Franke FDF 9174 Bedienungsanleitung

Franke

Franke 792-14 T45 FRI Bedienungsanleitung

Franke

Franke FMY 607 BK Bedienungsanleitung

Franke

Franke 782-16 T45 Bedienungsanleitung

Franke

Franke FDP 906 I Bedienungsanleitung

Franke

Franke 1291A-10 Bedienungsanleitung

Franke

Franke FCMY 90 C WHG A 2B Bedienungsanleitung

Franke

Franke FSN 908 BK A Bedienungsanleitung

Franke

Franke FTU PLUS 3707 I BK Bedienungsanleitung

Franke

Franke FTU 3807 W Bedienungsanleitung

Franke

Franke FTC 542 Bedienungsanleitung

Franke

Franke FDF EG6 90 Bedienungsanleitung

Franke

Franke FKU 908-H I TC Bedienungsanleitung

Franke

Franke FPJ 915 V BK A Bedienungsanleitung

Franke

Franke Mythos FVMY AH BK F90 Bedienungsanleitung

Franke

Franke FDF EG6 60 Bedienungsanleitung

Franke

Franke FMY 907 FM Bedienungsanleitung

Franke

Franke FKAS A80 BK Bedienungsanleitung

Franke

Franke FGAS/3 E FX 1000 CE XS WM Bedienungsanleitung

Franke

Franke ARNO Bedienungsanleitung

Franke

Franke FDL 9065 Bedienungsanleitung

Franke

Franke FTU 3805 XS CYLINDRA E LED0 Bedienungsanleitung

Franke

Franke 1220A-10 Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch