Franklin Wireless R526 Bedienungsanleitung

Table of Contents

Care and Maintenance

Part 1. Getting to know the R526

1.1 Package Contents

1.2 Hardware Features of R526

Part 2. Setting up the R526

2.1 Charging the battery

2.2 Battery Tips

2.3 Using a LAN cable

Part 3. Using the R526

3.1 Connecting the R526

3.2 Opening the Browser Interface

3.3 Device Activation(Windows)

3.4 Device Activation(Mac users only)

Part 4. Technical Specications, Regulatory

and Safety Information, Warranty,

Trademarks & Copyright

4.1 LED Overview

4.2 Technical Specication

4.3 Safe Information

4.4 Warranty

4.5 Trademarks

4.6 Copyright

Thank you for choosing Franklin R526.

•

This manual briey explains the preparation, the process for

installing and safety precautions for using R526 router.

•

We recommend you read this manual before using the R526.

Note

•

Use your wireless device and accessories with care and in clean environment.

•

Keep the wireless device away from an open ame, dust, and dirt.

•

Protect your device and accessories from water and vapor and keep them dry.

•

Do not drop, throw or bend your device.

•

Clean your device with a piece of damp and soft antistatic cloth.

•

Do not use any chemical agents (such as alcohol and benzene),

chemical detergent, or powder to clean it.

•

Do not leave your device and accessories in a place with a considerably low

or high temperature.

•

Use only accessories of the wireless device approved by the manufacturer.

•

Contact the authorized service center for any abnormity of the device or

accessories.

•

Do not dismantle the device or accessories. Otherwise, the device and

accessories are not covered by the warranty.

Care and Maintenance

Part.1

Getting to know the R526

1.1 Package Contents

•

Franklin R526 Mobile Hotspot Router

•

QSG (Quick Start Guide)

•

AC-DC Travel Adaptor

•

Carrying Pouch

•

Li-ion 1,350mAh battery

•

RJ45 port cover

1.2 Hardware Features of R526

Factory Reset Button

Power/Reset Button

Micro USB port

RJ45 LAN port

Air holes

2.1 Charging the battery

1. The battery compartment is located on the

bottom of the device.

Slide open the battery compartment door

by rmly pressing in the direction of the arrows.

2. Insert the battery by lining up the gold

contact points on the battery with the gold

contact points in the battery compartment.

Then press down gently until the battery

is seated.

3. Replace the battery cover and slide it closed

while pressing gently until it locks into place.

4. Connect the micro USB end of the AC-DC

adaptor to the micro USB port of the device.

Note

• You must have a fully charged battery the rst

time you use the R526.

•After the rst use, you may use the device while

it is connected to the AC-DC adaptor.

•When using battery power, the device lasts up to

3 hours (when connected to a single device only).

•The battery will discharge more rapidly as

additional devices access the R526.

2.2 Battery Tips

Warning

Use only Franklin Wireless approved batteries and chargers with your device.

The failure to use a Franklin Wireless-approved battery and charger may increase the risk that your

device will overheat, catch re, or explode, resulting in serious bodily injury, death, or property

damage.

Battery life depends on the network, signal strength, temperature, features, and accessories

you use.

•

If you connect your device to your computer using a USB data cable, the battery will charge.

However, the device will not function as a wireless access point while connected to your

computer.

•

It normally takes at least 2 hours to fully charge the battery with an AC-DC adaptor.

•

New batteries or batteries stored for a long time may take more time to charge.

•

When charging your battery, keep it near room temperature.

•

Never expose batteries to temperatures below 32°F (0°C) or above 113°F (45°C).

Never leave the device in an unattended vehicle due to uncontrollable temperatures that

may be outside the desired temperature for this device.

•

It is normal for batteries to gradually wear down and require longer charging times.

If you notice a change in your battery life, it is probably time to purchase a new battery.

2.3 Using a LAN cable (RJ45)

If you want to connect to RJ45 LAN cable

to the R526, plug the cable to the RJ45

slot located between Micro USB port and

power button.

Inhaltsverzeichnis

Andere Franklin Wireless WLAN-Router Handbücher

Franklin Wireless

Franklin Wireless R774 Bedienungsanleitung

Franklin Wireless

Franklin Wireless T9 Bedienungsanleitung

Franklin Wireless

Franklin Wireless R526A Bedienungsanleitung

Franklin Wireless

Franklin Wireless 910 Handbuch

Franklin Wireless

Franklin Wireless R850 Bedienungsanleitung

Franklin Wireless

Franklin Wireless R850 Technisches Datenblatt

Franklin Wireless

Franklin Wireless RG1000 Bedienungsanleitung

Franklin Wireless

Franklin Wireless R872 Bedienungsanleitung

Franklin Wireless

Franklin Wireless U301 Bedienungsanleitung

Franklin Wireless

Franklin Wireless C774 Bedienungsanleitung

Franklin Wireless

Franklin Wireless R871 Bedienungsanleitung

Beliebte WLAN-Router Handbücher anderer Marken

Milesight

Milesight UG67 Bedienungsanleitung

Airlogic

Airlogic AirSync Class 1 Betriebsanleitung

Samsung

Samsung WCH730B Bedienungsanleitung

TELEFONICA

TELEFONICA USB Adapter Bedienungsanleitung

NETGEAR

NETGEAR PowerLINE WiFi 1000 Series Bedienungsanleitung

Askey

Askey RAC2V1K Bedienungsanleitung

Alloy

Alloy WLF2454AP-S Bedienungsanleitung

TP-Link

TP-Link TL-WR542G Bedienungsanleitung

NETGEAR

NETGEAR WNR2000v4 Bedienungsanleitung

Hama

Hama 53120 Bedienungsanleitung

Intellinet

Intellinet 524582 Bedienungsanleitung

Asus

Asus RT-N10P Bedienungsanleitung

D-Link

D-Link DIR-506L Bedienungsanleitung

Sapido

Sapido GR297n Bedienungsanleitung

Asus

Asus DSL-N55U Bedienungsanleitung

AMTC

AMTC WR7502 Bedienungsanleitung

Compaq

Compaq CP-2W - iPAQ Connection Point Bedienungsanleitung

SMC Networks

SMC Networks WBR14-N2 FICHE Bedienungsanleitung