Fridja f1500 Bedienungsanleitung
FRIDJA
www.fridja.com
INSTRUCTION MANUAL
ENGLISH 02 | FRANÇAIS 20 | DEUTSCH 38
ESPAÑOL 56 | iTALIANO 74
2
ENGLISH
3
F1500 FRIDJA HIGH PRESSURE GARMENT STEAMER
INTRODUCTION
Thank you for purchasing this Fridja f1500 high pressure garment steamer!
This product has been designed and manufactured to give you years of
trouble free service.
Please take time to read these instructions prior to use - they have been
written to ensure you get the very best from your purchase.
As with any new electrical product please allow several hours of
use before all components have acclimatised themselves with your
surroundings and settled into optimum operation.
TECHNICAL SPECIFICATIONS
Model Number: f1500
Net Weight: 7.75 kg
Water Tank Capacity: 3.8 Litres
Input Voltage: 220-240 V 50/60 Hz
Output Power: 2200W
Instruction Booklet: 1.1
4
ENGLISH
CONTENTS
SAFETY INFORMATION ............................................4
YOUR FRIDJA STEAMER ...........................................7
HOW TO ASSEMBLE ..............................................8
HOW TO OPERATE ...............................................10
ACCESSORIES ....................................................11
DESCALING MODE............................................... 14
TROUBLESHOOTING .............................................15
PLUG SAFETY ...................................................16
GUARANTEE ....................................................18
SAFETY INFORMATION
Please retain these instructions for future reference. Only use the
appliance as described in this manual to avoid re or electric shock. Do not
use the appliance for any purpose other than that for which it is designed.
When using electrical appliances basic safety precautions should
always be followed. Check that the voltage indicated on the rating plate
corresponds with that of the local network before connecting the appliance
to the mains power supply.
If the supply cord is damaged, it must be replaced by a qualied engineer
in order to avoid a hazard. Ensure that the supply cord is kept away from
heat or sharp edges that could cause damage.
Steam produced by the unit is hot. Care must be taken to avoid scalding
or other injuries. Do not shake the appliance during use to avoid hot water
splashing out.
5
F1500 FRIDJA HIGH PRESSURE GARMENT STEAMER
The appliance must be unplugged from the power supply after use and
during any maintenance or setting up, such as cleaning, relling tank or
attaching accessories. Avoid tilting the appliance during operation to
prevent water spillage. Never immerse the unit, power cord or plug in
water or any other types of liquid.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience or
knowledge, unless they have been given supervision and instruction in the
use of the appliance by a person responsible for their safety.
Do not add chemicals or detergents (other than those ocially approved
by Fridja) to the water as this may damage the appliance or make it unsafe.
Distilled or demineralised water is recommended.
Do not leave the appliance unattended whilst connected to the mains
power supply. Children should be supervised to ensure they never play
with the appliance.
Never attempt to steam clothing while it being worn. Always point the
appliance away from the body and never aim at other people or animals.
Never operate the steamer without lling the water storage tank. Always
check the water level before use and during operation.
Never fold the hose or lay it on the ground.
The steamer head and accessories will become hot during use. Do not
touch them or attempt to change the accessories until they have cooled
suciently. The appliance must be used on a stable heat-resistant surface.
Only move the appliance by the base unit. Do not force the wheels if they
are stuck. If this happens, turn the unit o, drain the water tank and water
reservoir before inspecting the wheels. Always allow the appliance to cool
completely and drain the water tank and water reservoir before re-lling
with water, cleaning or storing.
Do not use on suede, velvet, leather, vinyl, plastic or any steam sensitive
materials. If unsure, test rst on a small, discreet part of the material.
6
ENGLISH
Never aim steam at a
human or animal. Never disconnect the
hose during operation.
Never add or remove
attachments during
operation.
Never add detergents
into the water storage
tank.
Always disconnect the
plug before adding water
or cleaning the steamer.
Never tip the steamer or
spill water out whilst in
operation.
7
F1500 FRIDJA HIGH PRESSURE GARMENT STEAMER
16 17
YOUR FRIDJA STEAMER
1. Head Hanger
2. Steamer Head
3. Clothes Hanger
4. Clothes Hanger Slot
5. Supporting Brackets
6. Telescopic Pole
7. Steam Hose
8. Ironing Board
9. Ironing Board Fixture
10. Pole Nut
11. Hose Connector
12. Water Storage Tank
13. Power On/O Button
14. Pressure Gauge
15. Wheel
16. Steam Trigger (on Steamer Head)
17. Ironing Glove
18. Folding Clothes Hanger
19. Delicate Material Guard Attachment
20. Bristle Brush Attachment
21. Collar and Cu Support
18
8
ENGLISH
HOW TO ASSEMBLE
Carefully unpack all parts of the steamer including those in the
polystyrene packaging.
1. The stainless steel pole consists of four sections. Fully extend
and tighten all segments of telescope pole by rotating the pole
clockwise (Figure A). Always keep pole at full height when steaming.
2. Unfold the hanger and place on the top of the telescopic pole.
3. From the bottom of the pole, add the ironing board support xture.
Ensure this is the correct way up according to the arrows (Figure C).
Figure A
Figure C
Figure B
9
F1500 FRIDJA HIGH PRESSURE GARMENT STEAMER
4. Making sure the pole nut is in place, position the telescopic pole into the
main body of the steamer and turn the pole nut clockwise until tightened.
5. Unlock the supporting brackets on the ironing board and hang the ironing
board onto the clothes hanger. Secure the ironing board to the ironing board
support xture ensuring the ironing board is taut.
6. Install the steam hose with steamer head by plugging the hose connector
into the main unit and hanging the steamer head onto the head hanger.
Figure D
CAUTION:
Make sure that when you insert the steamer hose into the main unit
that you hear a click! Once you’ve heard a click, the steamer hose has
been successfully inserted.
10
ENGLISH
HOW TO OPERATE
1. Ensure the power cord is disconnected from the power outlet.
2. Unscrew the water tank’s valve cap and ll with water. Screw the valve
cap back in place and place the water tank on to the unit (it will not
click). Never turn the steamer on with an empty tank.
3. Plug the unit in to a suitable power outlet and press the on button.
4. The light will illuminate blue and the steamer will begin heating the
water and build pressure.
5. Please wait for 120 seconds or until the pressure is at 5 bars.
6. In the meantime hang your clothes onto the clothes hanger, or use your own
clothes hanger in the clothes hanger slot.
7. Once the f1500 is ready to use, take the steamer head out of the head hanger
and with one hand hold the material taut. Using the steamer head in the other
hand, press the steam trigger and soften the material by blasting steam at it.
8. After applying some steam, use the steamer head without the steam to iron
the material either by holding the material taut, or ironing against the ironing
board. Glide the steamer head over garment until the creases are removed.
9. The steamer is in operational mode anywhere from 2 to 5 bars of
pressure. If pressure dips to below 2, wait for the pressure to build
up again. Please note it is not best practice to keep the steam trigger
pressed, instead use short sharp bursts and follow through using the
iron without steam.
10. For collars and cus, do not forget to use the collar and cu accessories.
11. When you are nished, switch the f1500 o by pressing the on/o button.
Unplug the unit and turn o the power supply outlet switch.
Hang the steamer head on the head hanger when not in use. Never fold
the hose. Never pull the hose with excessive force. The hose can be easily
removed by pressing the button on the hose connector. Do not move the
appliance by pulling the hose.
CAUTION:
When using your f1500, it is not necessary or best practice to hold
the steam trigger down continuously. Instead, use in short sharp
bursts. Blast the area with creases and follow through using gliding
the hot iron over the taut material. Doing this will keep the pressure
of the steam high and ensures the creases disappear quickly.
Inhaltsverzeichnis
Sprachen:
