4
Set EOC for conventional bake at 350oF/177oC. Using a portable thermocouple, obtain an average oven tempera-
ture after a minimum of 5 cycles. Press CANCEL to end bake mode. Touch the BAKE pad. Set temperature to
maximum (550oF/288oC). Quickly (within two seconds), press and hold the BAKE pad until the special two digit
display appears. Release the BAKE pad.
NOTE: The display indicates the offset temperature from original factory setting. Original setting will read "00".
The temperature can now be adjusted up or down 35oF/21oC, in 5oF/3oC increments, by pressing the up or down
arrow pad. Press the pad until the desired amount of offset appears in the display. A minus sign (-) will appear
before the number to indicate the oven will be cooler by the displayed number of degrees.
NOTE: Changing calibration effects both conventional and convection modes.
PREHEAT (some models)
During a preheat mode, the oven uses the bake element to reach the ERCIII set point. The element uses full
power when it's on. When the set point is reached, the preheat mode is converted in a normal bake mode.
During a normal bake mode, the ERC III preheats the oven with the bake element. When the desired
temperature is reached, the ERC III adds top heat by cycling the broil element on for 5 to 15 seconds per minute .
The bake element is on for the remaining time of the minute. Both elements use full power when they are on but
they are never on at the same time.
NORMAL BAKE
CLEAN
During a cleaning process, the oven uses the bake element.
CLEAN AND TIMED CLEAN
When these modes are called, the door locks right after start button is pushed.
OVEN CALIBRATION
ERC III ELECTRONIC OVEN CONTROL FAULT CODES
FAULT
CODE
F1
LIKELY FAILURE CONDITION/CAUSE
Shorted keypad (more than 30 seconds).
Control’s internal checksum may have become
corrupted.
Controlhassensedapotentialrunawayovencondition.
Control may have shorted relay, RTD sensor probe may
have gone bad.
Doormotorfailure/jammed.Latchmotorswitchfailure.
SUGGESTED CORRECTIVE ACTION
Replace EOC.
Disconnectpower,wait30secondsandreapplypower.
If fault returns upon power-up, replace EOC.
CheckRTDsensorprobeandreplaceifnecessary.IFoven
is overheating, disconnect power. If oven continues to
overheat when the power is reapplied, replace EOC.
Severe overheating may require the entire oven to be
replaced, should damage be extensive.
With the unit in either the fully locked or fully unlocked
position, only one of the switches should be closed. If
both switches are closed, replace the latch motor
assembly or replace the control.
