Frost Fighter IDH1000 Bedienungsanleitung
IDH1000 FEATURES AND OPERATION MANUAL
VER. 1.3.2 SEPT. 2019 2019
Table of Contents
- Fuel Fill Location & Filling Precautions
- Door latches, Compartments and Hitch/Tongue Details
- External Power Connections
- Heater Access Doors and Slide Out System
- Basic Features of Heaters (See heater manual for full operating & servicing information)
-
-
-
-
Engine/Generator Layout and Identification (See engine manual for engine type specific detailed information)
Rear Compartment Controls & Functions
Fuel Level Sending Unit
Compartment Lighting Control Timers - Function & Adjustment
-Basic Starting Instructions for the Kubota or Isuzu Diesel Engine
-Isuzu Engine Basic Spare Parts List
-Kubota Engine Basic Spare Parts List
-Kubota Engine Oil Requirements
-Location of Rating Plate Information and Serial Number Identification - List of Important Warnings & Precautions
-Optional LED Status Beacon
-120VAC & 12VDC Standard Circuit Wiring Diagram
-Recommended Maintenance / Service Intervals
-Operating Tips and Specifics
-Overall Exterior Dimensions
Page 2
Page 3-4
Page 5
Page 6 - 8
Page 9
Page 10
Page 11 - 12
Page 13
Page 14 - 15
Page 16
Page 17
Page 18
Page 19
Page 20
Page 21
Page 22 - 24
Page 25
Page 26
APPENDIX A
Fuel Fill Point
CAUTION:
Filling the fuel tank too quickly or overfilling the tank can increase the risk of spills, backsplash or fuel discharging from the tank vent or fill point due to fuel expansion, etc.
Page 2
EXTERIOR FUEL FILL AREA LIGHT
Activated with compartment light button located on main control panel
FUEL LEVEL FILL WARNING INDICATOR
This indicator can assist with eliminating the risk of overfilling or splash-back.
-Green LED begins flashing when fuel level reaches 75% of full tank capacity
-Green LED Illuminates steady when fuel level reaches 85% to 90% of full tank capacity
(Engine must be stopped and key switch must be ON to activate this feature)
The fuel tank is filled on the side of unit near the rear.
Maximum fuel tank capacity is 190 US gal (718 Litres)
Caution: Do not fill tank above 95% of maximum capacity to allow for fuel expansion.
Refer to rating plate in rear compartment for specific details.
Approximate maximum run time for IDF1000 with full tank is approx. 30 hours.
Positive Lock Access Door Latches
Door Latches in Closed Position Press Bottom of Latches to Open
Page 3
Left front storage compartment access door.
Trailer tongue area illustrating various components
Always ensure tow vehicle has sufficient tow ratings and reduce speed when towing
Break-away switch
battery.
Check battery
condition
annually
Tongue jack
7 Pin trailer
connector to vehicle
for exterior lights and
electric brakes
Break-away switch
Safety chains
Height adjustable hitch
Pintle or 2-5/16” ball
available
Page 4
External Power Connections
•
120VAC 15A "shore power" inlet to supply engine block heater
and battery charger/maintainer.
•
120VAC 15A GFCI protected auxiliary power
outlet
Page 5
Swing Open Side Access Doors
Access to Heater Discharges
Heater discharge doors have safety interlock switches
and each door must be open in order for the respective
heater to operate.
Access to Heater Controls
Heater inlet doors provide access to the heater
controls and should normally remain open
during operation.
Catches are provided to
secure doors in the open
position
Page 6
Heaters are mounted onto poly lined slides rails permitting slide out access for service or complete removal from
enclosure.
IDH500QR heaters can slide out toward the burner end only and IDF500HS heaters can slide out from both the burner
end or the air discharge end.
Illustration of "Lock Bolts" which secure slide rails in locked position. These must be removed in order to slide heaters)into service position
Page 7
SLIDE LOCK BOLT
Illustration of a heater pulled into access positions.
Heater travel is limited by "slide limit stop bolts". The heaters can be completely
removed from the enclosure by unfastening the slide limit safety stop bolt.
Note: IDH models slide-out from the burner side of the trailer only & require lifting of the clearance cover.
Page 8
IDH500QR HEATER SHOWN
SLIDE STOP BOLT
REMOVE 2
“CLEARANCE COVER”
BOLTS
SWING “CLEARANCE COVER”
OPEN
OPENING CLEARANCE COVER TO
SLIDE OUT HEATERS
IDF500HS and IDH500QR Heaters
PRESSURE GAUGE
KEEP VALVE CLOSED DURING NORMAL OPERATION & OPEN TO
ONLY TO CHECK PRESSURE.
FUEL FILTER
FUEL
SOLENOID
AIR
ADJUSTMENTS
IGNITION
TRANSFORMER
GENISYS CONTROL
RED “LOCKOUT” INDICATOR
AND RESET BUTTON
FUEL SOLENOID VALVE
“ENERGIZED” INDICATOR
POWER SUPPLY
INDICATOR
BURNER OPERATION SELECTOR
SWITCH.
OFF / MANUAL / THERMOSTAT
BURNER CIRCUIT
BREAKER
GENISYSY 7505
CONTROL
REMOTE
THERMOSTAT
CONNECTION
Burner Controls and Functions
See heater manual for complete operation and maintenance information
Page 9
Andere Handbücher für IDH1000
1
Andere Frost Fighter Heizung Handbücher
Frost Fighter
Frost Fighter IHS700P LP Datenblatt
Frost Fighter
Frost Fighter IDF500HS Datenblatt
Frost Fighter
Frost Fighter IDH400QR LP/NG Datenblatt
Frost Fighter
Frost Fighter DF 400 Bedienungsanleitung
Frost Fighter
Frost Fighter IHS700P LP Datenblatt
Frost Fighter
Frost Fighter IHS 1500 Handbuch
Frost Fighter
Frost Fighter IDH1000 Bedienungsanleitung
Frost Fighter
Frost Fighter IDH200QR OIL Leitfaden
Frost Fighter
Frost Fighter IDHQR Series Datenblatt
Frost Fighter
Frost Fighter IDH200QR OIL Datenblatt
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung