Furuno SC-33 Bedienungsanleitung
SATELLITE COMPASS
SC-33
OPERATOR'S MANUAL
www.furuno.com
Model
i
IMPORTANT NOTICES
General
• This manual has been authored with simplified grammar, to meet the needs of international users.
• The operator of this equipment must read and follow the descriptions in this manual. Wrong oper-
ation or maintenance can cancel the warranty or cause injury.
• Do not copy any part of this manual without written permission from FURUNO.
• If this manual is lost or worn, contact your dealer about replacement.
• The contents of this manual and equipment specifications can change without notice.
• The example screens (or illustrations) shown in this manual can be different from the screens you
see on your display. The screens you see depend on your system configuration and equipment
settings.
• Save this manual for future reference.
• Any modification of the equipment (including software) by persons not authorized by FURUNO will
cancel the warranty.
• The following concern acts as our importer in Europe, as defined in DECISION No 768/2008/EC.
- Name: FURUNO EUROPE B.V.
- Address: Ridderhaven 19B, 2984 BT Ridderkerk, The Netherlands
• All brand and product names are trademarks, registered trademarks or service marks of their re-
spective holders.
How to discard this product
Discard this product according to local regulations for the disposal of industrial waste. For disposal in
the USA, see the homepage of the Electronics Industries Alliance (http://www.eiae.org/) for the cor-
rect method of disposal.
How to discard a used battery
Some FURUNO products have a battery(ies). To see if your product has a battery, see the chapter
on Maintenance. Follow the instructions below if a battery is used. Tape the + and - terminals of bat-
tery before disposal to prevent fire, heat generation caused by short circuit.
In the European Union
The crossed-out trash can symbol indicates that all types of batteries
must not be discarded in standard trash, or at a trash site. Take the
used batteries to a battery collection site according to your national
legislation and the Batteries Directive 2006/66/EU.
In the USA
The Mobius loop symbol (three chasing arrows) indicates that Ni-Cd
and lead-acid rechargeable batteries must be recycled. Take the
used batteries to a battery collection site according to local laws.
In the other countries
There are no international standards for the battery recycle symbol. The number of symbols can in-
crease when the other countries make their own recycle symbols in the future.
Cd
Ni-Cd Pb
ii
SAFETY INSTRUCTIONS
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
can result in minor or moderate injury.
Warning, Caution
Mandatory Action
Prohibitive Action
WARNING
Do not open the equipment.
Only qualified personnel should work
inside the equipment.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
.
Safety instructions for the operator
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
Steering
compass
0.45 m 0.40 m
SC-33
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Be sure that the power supply is
compatible with the voltage rating of the
equipment.
Connecting an incompatible power supply
can cause fire or damage the equipment.
The voltage rating appears on the inlet
of power.
WARNING
Safety instructions for the installer
Warning Label
A warning label is attached to the equipment.
Do not remove the label. If the label is missing
or illegible, contact a FURUNO agent or dealer
about replacement.
Name: Warning Label(1)
Type: 86-003-1011-3
Code No.: 100-236-233-10
CAUTION
WARNING
CAUTION
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Do not use high-pressure cleaners to
clean this equipment.
This equipment has the waterproof rating
outlined in the specifications, at the back
of this manual. However, the use of
high-pressure cleaning equipment can
cause water ingress, resulting in damage
to, or failure of, the equipment.
.
iLi
TABLE OF CONTENTS
FOREWORD ................................................................................................................. iv
SYSTEM CONFIGURATION ......................................................................................... v
1. MOUNTING ............................................................................................................. 1
1.1 Equipment Lists........................................................................................................... 1
1.2 Mounting Considerations ............................................................................................ 3
1.3 Mounting Procedure.................................................................................................... 8
2. WIRING ................................................................................................................. 10
2.1 NMEA 2000 Network Connection ............................................................................. 10
2.2 NMEA 0183 Network Connection ............................................................................. 11
2.2.1 How to connect the Cable Assembly (FRU-NMEA-NFF-R15/30)...................... 11
2.2.2 How to connect the Cable Replacement Kit (OP20-50) .................................... 12
2.2.3 How to secure and waterproof the cable connections ....................................... 15
3. ADJUSTMENTS.................................................................................................... 16
3.1 Initial Setting Menu.................................................................................................... 16
4. NMEA 2000 I/O DATA .......................................................................................... 21
4.1 Input Data.................................................................................................................. 21
4.2 Output Data............................................................................................................... 22
5. MAINTENANCE, TROUBLESHOOTING.............................................................. 25
5.1 Preventive Maintenance............................................................................................ 25
5.2 Troubleshooting ........................................................................................................ 25
MENU TREE ............................................................................................................AP-1
WHAT IS SBAS? .....................................................................................................AP-5
SPECIFICATIONS ................................................................................................... SP-1
PACKING LISTS........................................................................................................ A-1
OUTLINE DRAWING ................................................................................................. D-1
INTERCONNECTION DIAGRAM .............................................................................. S-1
iv
FOREWORD
A Word to the Owner of the SC-33
Congratulations on your choice of the FURUNO SC-33 Satellite Compass. We are confident you
will see why the FURUNO name has become synonymous with quality and reliability.
Since 1948, FURUNO Electric Company has enjoyed an enviable reputation for quality marine
electronics equipment. This dedication to excellence is furthered by our extensive global network
of agents and dealers.
This equipment is designed and constructed to meet the rigorous demands of the marine
environment. However, no machine can perform its intended function unless installed properly.
Please carefully read and follow the recommended procedures for installation.
Thank you for considering and purchasing FURUNO equipment.
Features
The SC-33 Satellite Compass outputs highly accurate heading, GNSS position data and speed
and motion data for AIS, Tracked Target (TT) radar, autopilots, etc. Data is output in NMEA 2000®
(NMEA2000 is a trademark of National Marine Electronic Association (the United States)) format,
and with connection of the optional interface unit the data can be converted to NMEA 0183 format.
Setting time is within three minutes and the follow-up performance is an excellent 45°/s.
• Heading accuracy of 0.4° RMS
• Perfect heading sensor for radar/TT, AIS, scanning sonar, etc.
• Outputs accurate heading, position, time, speed, course.
• Pitch and roll output in digital format for ship's motion correction
• A new Satellite Compass™ designed with FURUNO advanced GNSS kinematic technology.
• Data can be output in NMEA 2000 format
• Free from regular maintenance
• Aesthetically pleasing antenna fits nicely on recreational boats
• Outputs acceleration speed and angular velocity at installation
Software used in this product
This equipment uses the following open source software.
This product includes software to be licensed under the GNU General Public License (GPL) ver-
sion 2.0, GNU Lesser General Public Software License (LGPL) version 2.0, Apache, BSD and oth-
ers. The program(s) is/are free software(s), and you can copy it and/or redistribute it and/or modify
it under the terms of the GPL version 2.0 or LGPL version 2.0 as published by the Free Software
Foundation. Please access to the following URL if you need source codes.
https://www.furuno.co.jp/en/contact/cnt_oss_e01.html
Program No.
OS : 2051593-01.**
APL : 2051594-01.**
GNSS: 48505230**
** denotes minor modifications.
v
SYSTEM CONFIGURATION
SC-33
Satellite Compass
12-24 VDC
: Standard supply
: Optional supply
: Local supply
IF-NMEASC
INTERFACE UNIT
Video Plotter
Radar
Autopilot
Current Indicator
Scanning Sonar
Video Sounder
AIS
NavNet Series, etc,.
NMEA2000
NMEA0183
Marine Instrument
Junction Box
IF-NMEASC
1
1. MOUNTING
1.1 Equipment Lists
Standard supply
* See packing list at back of manual for details.
Name Type Code No. Qty Remarks
Satellite
Compass SC-33 - 1
Installation
Materials
CP20-04400 000-035-094
1
(Select)
For NavNet Series, etc,.
With cable FRU-NMEA-PMMFF-060 (6 m)
and Installation materials CP20-04401
CP20-04410 000-035-095 For connecting IN-NMEASC,
With cable FRU-NMEA-NFF-R15 (15 m)
and Installation materials CP20-04401
CP20-04401 001-508-130 No cable
1. MOUNTING
2
Optional supply
Name Type Code No. Remarks
Interface Unit IF-NMEASC - See OME-72651-x attached to
the Interface Unit.
Cable Assembly
FRU-NMEA-NFF-R15 001-507-080 For IF-NMEASC, 15m, φ6.7
FRU-NMEA-NFF-R30 001-507-090 For IF-NMEASC, 30m, φ6.7
Cable
Conversion kit OP20-50 001-506-810
Replacement kit for SC-30
ࠉ(MJ-A10SPF0015-xxxC)
Contents
- Waterproof relay box
(JPBS 06)
- 120 ΩLead resistance
ࠉ(03S9939)
- FRU-NMEA-PFF-060
- Vinyl tape
(0.2X19X10000MM Black,
000-172-691-10)
- Self-bonding tape
(No.15, 000-174-646-10)
Bird-Repellent
Fixture
OP20-36 004-380-830 Four pieces
OP20-37 004-380-840 Single
Cable for
NMEA2000
(Micro)
FRU-NMEA-PMMFF-010 001-506-820 w/connectors (Light), 1m
FRU-NMEA-PMMFF-020 001-506-830 w/connectors (Light), 2m
FRU-NMEA-PMMFF-060 001-507-000 w/connectors (Light), 6m
FRU-NMEA-PFF-010 001-507-010 w/connector (Light), 1m
FRU-NMEA-PFF-020 001-507-030 w/connector (Light), 2m
FRU-NMEA-PFF-060 001-507-040 w/connector (Light), 6m
Connector for
NMEA2000
FRU-MM1MF1MF1001 001-507-050 T-Connector, Micro Style: 3
FRU-MF000000001 001-507-060 Micro Style, female,
termination resistor
FRU-MM100000001 001-507-070 Micro Style, male,
termination resistor
1. MOUNTING
3
1.2 Mounting Considerations
In addition to the considerations described in this section, keep the length of the satellite compass
cable in mind when selecting a mounting location.
General considerations
Mount the satellite compass above radar mast
As shown in the figure below, mount the SC-33 satellite compass above a radar mast. This pro-
vides an unobstructed path between the satellite compass and the satellite, regardless of vessel
heading. Follow the procedure on the next page to choose an installation site.
Satellite compass mounted above antennas and structures
If satellite compass cannot be installed above radar mast
If absolutely impossible to do otherwise, the satellite compass may be installed below a radar
mast. However, certain guidelines must be followed to prevent the shading and multipath prob-
lems which occur as shown in the figure below. Follow the procedure on the next page to choose
an installation site.
Problems associated with mounting satellite compass below a radar mast
SC-33 Satellite Compass
Mast
Radar Antenna
Bridge
Radar Antenna
SC-33
Satellite Compass
Reception blocked by mast.
Location influenced
by reflected wave.
Andere Handbücher für SC-33
3
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Furuno Auto-Navigationssystem Handbücher
Beliebte Auto-Navigationssystem Handbücher anderer Marken
Sanyo
Sanyo NVM-4030 - Easy Street - Automotive GPS... Bedienungsanleitung
Kenwood
Kenwood DNN991HD Bedienungsanleitung
AvMap
AvMap Geosat 2C Bedienungsanleitung
Eonon
Eonon GE01B Bedienungsanleitung
Pioneer
Pioneer AVIC-Z920DAB Bedienungsanleitung
Nextar
Nextar M3-MX - Automotive GPS Receiver Bedienungsanleitung
Furrion
Furrion NV2200 Bedienungsanleitung
Mio
Mio MOOV 200-Series Bedienungsanleitung
Prestigio
Prestigio GeoVision 5150 Bedienungsanleitung
Hummer
Hummer 2006 H3 Bedienungsanleitung
Magellan
Magellan Maestro 4210 - Automotive GPS Receiver Konfigurationshandbuch
Garmin
Garmin StreetPilot c510 Bedienungsanleitung