Gasboy C08951 Bedienungsanleitung

STAR RECEIPT PRINTER

MAINTENANCE MANUAL

C08951

GASBOY INTERNATIONAL LLC



GASBOY

STAR RECEIPT PRINTER

MAINTENANCE MANUAL

C08951

Rev. 03/20/03

The information in this document is confidential and proprietary. No further disclosure shall be made without

permission from Gasboy International LLC. Gasboy International LLC believes that the information in this document

is accurate and reliable. However, we assume no responsibility for its use, nor for any infringements of patents or

other rights of third parties resulting from its use. We reserve the right to make changes at any time without notice.

GASBOY INTERNATIONAL LLC LANSDALE, PA

03/20/03 Contents-1

CONTENTS

Section 1: INTRODUCTION

Description ............................................................................................... 1-1

Section 2: SWITCHES AND SETTINGS

Printer Status Board ................................................................................. 2-1

Status Board Switches ............................................................................. 2-1

Status Board Lamps ................................................................................. 2-2

Controller Board DIP Switch Settings ....................................................... 2-2

Section 3: MAINTENANCE

Accessing the Printer For Maintenance or Service .................................. 3-1

Ordering New Paper or Ribbon................................................................. 3-1

Changing the Paper ................................................................................. 3-2

Removing the Paper ........................................................................... 3-2

Installing the Paper ............................................................................. 3-3

Changing the Ribbon ................................................................................ 3-3

Removing Old Ribbon Spools ............................................................. 3-3

Installing New Ribbon Spools ............................................................. 3-4

Adjusting Cutter Blades ............................................................................ 3-5

Adjusting After Incomplete Cuts .......................................................... 3-5

Adjusting After Paper Jam .................................................................. 3-5

Figures

1-1. Card System with Receipt Printer ............................................................ 1-1

2-1. Printer Status Board ................................................................................. 2-1

2-2. DIP Switches ............................................................................................ 2-2

3-1. Printer Side View ...................................................................................... 3-2

3-2. Ribbon Installation Sequence ................................................................... 3-4

3-3. Cutter Bar Adjustment Screw ................................................................... 3-5

Tables

2-1. Status Board Switches ............................................................................. 2-1

2-2. Status Board Lamps ................................................................................. 2-2

2-3 DIP Switch Settings .................................................................................. 2-2

03/20/03 1-1

Section 1

INTRODUCTION

DESCRIPTION

The Star Receipt Printer is a compact, multi-purpose dot-matrix printer that is used in GASBOY

CFN and Series 1000 Card Systems. This optional printer enables you to print receipts for fueling

transactions right at your card reader.

The printer is housed within the pedestal of your card reader. A printer access door is located on

the side of the pedestal. Inside, the printer is mounted on a sliding drawer that enables you to

easily slide it out for servicing or maintenance and then replace it. A receipt door on the front of

the pedestal provides customer access to receipts. Indicator lamps, on the pedestal above the

receipt door, indicate PAPER LOW or PAPER OUT conditions.

Figure 1-1 highlights the location and features of a card reader with a receipt printer. The

remainder of this manual describes the printer, its internal switches and settings, and how to

maintain it.

Figure 1-1. Card System With Receipt Printer

03/20/03 2-1

Section 2

SWITCHES AND SETTINGS

PRINTER STATUS BOARD

The printer status board (Figure 2-1) is attached to the

inside of the printer access door (See Figure 1-1) This

location provides the site attendant easy access to the

switches and indicator lamps needed to perform paper

loading, self-tests, and simple troubleshooting.

Figure 2-1. Printer Status Board

STATUS BOARD SWITCHES

Table 2-1 summarizes switches and results for the printer status board.

Table 2-1. Status Board Switches

Switch Function

SW2 SELF-TEST

Switching SW2 to the left starts a self-test of the printer. It will print a barber-pole pattern

of all the characters that may be printed on a receipt.

Switching SW2 to the right stops the printing and cuts the paper.

A short self-test should be performed whenever the paper or ribbon is changed.

SW3 PAPER FEED

Pressing SW3 causes a continuous paper feed. This is used while loading new paper.

SW4 ON LINE

Pushing this switch alternately puts the printer in the online or offline mode. The

printer must always be online (green lamp on) to print receipts or do a self-test.

GASBOY Star Receipt Printer

2-2 03/20/03

STATUS BOARD LAMPS

Table 2-2. Status Board Lamps

Lamp Function

D1 +12 VOLTS

This lamp should be lit whenever SW1 (Power) is on.

D2 ON LINE

This lamp must be on to print receipts or do a self-test. If it is not on, momentarily press

SW4.

NOTE: This lamp does not have to be lit to feed paper (SW3).

D3 ALARM

This lamp will light when a mechanical failure occurs, or when the printer runs out of paper.

CONTROLLER BOARD DIP SWITCH SETTINGS

The controller board DIP switches are set at the

factory prior to shipment. For proper operation of

the printer, the controller board switch settings

should be as follows:

Table 2-3. Dip Switch Settings

SW1 Pos SW2 Pos

1-1 ON 2-1 ON

1-2 ON 2-2 ON

1-3 ON 2-3 ON

1-4 ON 2-4 OFF

1-5 OFF

1-6 ON

1-7 ON

1-8 OFF

NOTE: DIP switches are only read by the controller

at power up. DIP switch changes should

be made with the power off.

Figure 2-2. DIP Switches

03/20/03 3-1

Section 3

MAINTENANCE

ACCESSING THE PRINTER FOR MAINTENANCE OR SERVICE

Before beginning any of the following maintenance procedures, you must first turn off all power to

the unit, then pull the printer out to a serviceable position. Follow these steps:

1. Open the printer access door and loosen the hex head screw.

2. Pivot the printer assembly to the right in order to clear the paper chute.

3. Pull the entire printer slide assembly toward you.

4. Perform any required maintenance or service. Reverse this procedure to return the printer to

normal operation.

ORDERING NEW PAPER OR RIBBON

When replacing paper or ribbon, use only GASBOY-supplied parts. Failure to do so will void the

GASBOY warranty.

• C08946 Paper, #RF-4, 5-5, Low Bulk - Star

• C08941 Ribbon, #SF-01P, Purple - Star

It is recommended, in most cases, that the ribbon be replaced every 4000-5000 receipts or 2 to 3

rolls of paper to ensure acceptable print quality. Environmental conditions, such as temperature

and humidity, may affect the life of the ribbon.

Inhaltsverzeichnis

Beliebte Drucker Handbücher anderer Marken

Lexmark

Lexmark 1400 Series Handbuch

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Samsung

Samsung BIXOLON SRP-350plusF Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Epson

Epson ET-7750 Betriebsanleitung

Canon

Canon CLBR 460ps Bedienungsanleitung

Eltron

Eltron P210 Guide Bedienungsanleitung

Ricoh

Ricoh MD-P1 Bedienungsanleitung

Epson

Epson SC-F7100 series Bedienungsanleitung

Epson

Epson Stylus C40UX Bedienungsanleitung

Canon

Canon imagePASS-A2 Bedienungsanleitung

Canon

Canon S820D Bedienungsanleitung