Gateway FPD1975W Bedienungsanleitung

SETTING UP YOUR GATEWAY MONITOR

2 Connect your monitor to your computer

Follow the instructions that came with your computer.

2Connect your monitor to your computer

Follow the instructions that came with your computer.

1 Connect the monitor base

Slide the neck onto the base until it snaps into place.

1Connect the monitor base

Slide the neck onto the base until it snaps into place.

3 Plug in the monitor

To protect your monitor from power ﬂuctuations, use a surge protector.

3Plug in the monitor

To protect your monitor from power ﬂuctuations, use a surge protector.

4 Turn on the monitor and install software.

Insert the Ez Tune™ CD into your computer and follow the on-screeen instructions.

4Turn on the monitor and install software.

Insert the Ez Tune™ CD into your computer and follow the on-screeen instructions.

© 2006 Gateway, Inc. All rights reserved. Gateway is a trademark or registered trademark of Gateway, Inc. in the U.S. and other countries. Product speciﬁcations subject to change without notice. Actual product may vary from image shown.

2 Connect the USB

power cord to a USB

port on your computer.

1 Tilt the screen back,

center the speaker bar

below the screen, then

tighten the thumb

screws.

3 Connect the speaker

bar’s headphone and

microphone cables to

your computer, then

turn on the speaker.

Digital DVI

(optional*)

AnalogVGA

(supplied)

ConnectingYour Flat Panel LCD Speaker Bar (optional)*

* Available at www.gateway.com

MAN FPD1975W SETUP POSTER R0 3/06

5 Remove the bracket from the adjustable stand. Remove the

four screws from the back of the LCD panel and use those to

attach the stand’s mounting bracket to the monitor.

5 Remove the bracket from the adjustable stand. Remove the

four screws from the back of the LCD panel and use those to

attach the stand’s mounting bracket to the monitor.

6 Slide the neck bracket’s slot onto the bracket’s mounting tab,

push the bracket lever to the right and hold it, then lower

the neck into place and release the lever.

6 Slide the neck bracket’s slot onto the bracket’s mounting tab,

push the bracket lever to the right and hold it, then lower

the neck into place and release the lever.

4 Slide the adjustable stand’s neck onto the base, then tighten

the thumbscrew under the base to secure the neck into place.

4 Slide the adjustable stand’s neck onto the base, then tighten

the thumbscrew under the base to secure the neck into place.

2 Remove the screw from the neck hinge, then remove the

neck from the LCD panel. Save the screw for Step 3.

2 Remove the screw from the neck hinge, then remove the

neck from the LCD panel. Save the screw for Step 3. 3 Attach the hinge cover to the monitor using the screw

removed in Step 2.

3 Attach the hinge cover to the monitor using the screw

removed in Step 2.

1 Place the monitor face-down on a soft, non-marring surface.

Allow the base to hang down over the edge of the table.

1 Place the monitor face-down on a soft, non-marring surface.

Allow the base to hang down over the edge of the table.

Attaching your height-adjustable monitor stand (optional)*

Phillips screwdriver required

* Available at www.gateway.com

For additional help, see the documentation that came with your computer or go to gateway.com for online documentation. You can also visit gateway.com for help on common technical issues.

Andere Handbücher für FPD1975W

Andere Gateway Monitor Handbücher