GE 25993 Bedienungsanleitung

Low-Profile HD

Amplified Antenna

User’s Manual

25993 v1

02/02/15 RT

Introduction:

The Low-Proﬁle HD Ampliﬁed Antenna is specially

designed to receive digital and analog terrestrial

broadcasted TV signals. The compact and stylish

design will blend in with any décor.

Important Safety Instructions:

•Use only the supplied UL-listed power adapter

•This antenna is for indoor use only

•Do not install in wet locations or

locations that can get wet

Features:

•VHF/UHF/HDTV

•Impedance 75 Ohm

•Low noise USB-powered ampliﬁer

•Stylish slim proﬁle

Package Contents:

•Digital indoor antenna

•Antenna stand

•In-line low noise USB-powered ampliﬁer

•Micro USB cable

•UL-listed power adapter

•Users manual

•Wall mounting hardware

Antenna

StandDigital Indoor Antenna

Wall Mounting

For best reception, you will likely want to mount

the antenna above your television. Please follow

the instructions below for proper wall mounting.

1. Locate the mounting hardware

2. Locate the tools below (tools not included)

a. Some tools you will need are:

i. Tape measure

ii. Pencil or pen to mark your holes

iii. 1/8” drill bit and drill

iv. Hammer

v. Phillips screwdriver

3. Identify where you want to mount the antenna

4. Use your tape measure and a pencil, mark

two places on the wall exactly 7 inches apart

(as shown on the back of your antenna)

USB adapterMicro USB cable

Mounting hardware Users manual Power Ampliﬁer

5. Use a 1/8" drill bit and carefully drill

the two holes marked in step 4.

6. Use your hammer and lightly tap in

the supplied drywall anchors until

they are ﬂush with receptacle.

7. Use your Phillips screwdriver. Screw in

the screws provided until they

stick out about 1/16".

8. Mount the antenna onto the screws by

lining up the keyhole slots on the back

of the antenna with the screws.

Be sure you have routed the coax cable in the

direction you want the cable to go by using the

cable channel on the bottom of the antenna.

Installation:

1. Attach the coax cable from the antenna

to the power ampliﬁer “Antenna”

2. Connect the attached coax

cable from the ampliﬁer labeled

“Receiver” to the back of the TV

3. For televisions equipped with USB ports:

Connect the supplied USB cable to the USB

port on the ampliﬁer, then connect the

other end to your television’s USB port.

For televisions without USB ports:

Connect the supplied USB cable to the USB

port on the ampliﬁer, then connect the

other end to the supplied AC adapter. Plug

the AC adapter into an available outlet.

4. Turn on your TV

5. Scan for your local TV channels following the

instructions found in your TV’s users manual

For televisions equipped with USB ports:

For televisions without USB ports:

Made in China

GE is a trademark of the General Electric Company

and is under license by Jasco Products Company LLC,

10 E. Memorial Road, Oklahoma City, OK 73114.

This Jasco product comes with a limited lifetime warranty.

Visit www.jascoproducts.com for details.

Questions? Contact us at 1-800-654-8483

between 7:30AM—5:00PM CST.

Antenna helpful tips

Maximize the number of channels you receive by

placing the antenna in several different locations

to see which location provides the best reception

and the maximum number of channels. Be sure

to run a new channel scan on your TV in each

position. Refer to the instruction manual that came

with your TV if you are not sure how to do this.

Position or mount the antenna as high as possible

or near a window for best performance.

Connect the antenna to your TV using the

ampliﬁer provided as described in the installation

section. This will enhance reception for most

users. However, depending on your location and

signal environment, the antenna may work best

without the ampliﬁer. If you are having trouble with

reception, you may try removing the ampliﬁer and

connecting the antenna directly to the TV.

Visit www.antennaweb.org or www.dtv.gov and

look for the DTV Reception Maps to determine the

available television stations and location of the

broadcast towers in your area.

FOR FURTHER ASSISTANCE CALL,

(800) 654-8483 FOR TECHNICAL SUPPORT.

Antena ampliﬁcada

HD de bajo perﬁl

Manual del usuario

25993

Introducción:

La antena ampliﬁcada HD de bajo perﬁl está

diseñada especialmente para recibir señales de

difusión televisiva terrestre tanto digital como

analógica. El elegante y compacto diseño quedará

bien con cualquier estilo de decoración.

Medidas de seguridad importantes:

•Solo use el adaptador de corriente

homologado por UL provisto.

•Esta antena es solo para uso en interiores.

•No instale esta antena en lugares

húmedos o expuestos a la humedad

Características:

•VHF/UHF/HDTV

•Impedancia: 75 Ohm

•Ampliﬁcador de bajo ruido con

alimentación por USB

•Diseño delgado y moderno

Contenido del paquete:

• Antena digital para interiores

• Base para la antena

• Ampliﬁcador en línea de bajo ruido

con alimentación por USB

• Cable micro USB

• Adaptador de corriente homologado por UL

• Manual del usuario

• Accesorios para el montaje en la pared

Montaje en la pared

Para obtener la mejor recepción, le conviene

instalar la antena por encima del televisor. Siga las

siguientes instrucciones de montaje de la antena

para instalarla en la pared correctamente.

1. Localice los accesorios de montaje.

2. Busque las herramientas abajo especiﬁcadas

(las herramientas no se incluyen).

a. Algunas de las herramientas que

necesitará son las siguientes:

Base para

la antenaAntena digital para interiores

Adaptador USBCable micro USB

Artículos de ferretería

para el montaje

Manual del

usuario

Ampliﬁcador

de potencia

i. Cinta métrica

ii. Lápiz o lapicero para marcar el lugar en

donde hará los oriﬁcios

iii. Broca de 1/8” (3,5 mm) y taladro

iv. Martillo

v. Destornillador Phillips

3. Identiﬁque el lugar en dónde

desea instalar la antena.

4. Use la cinta métrica y un lápiz, marque

dos puntos en la pared a 7 pulgadas

de distancia (como se muestra en la

parte posterior de la antena).

5. Use una broca de 1/8” y cuidadosamente haga

los dos agujeros que marcó en el paso 4.

6. Con el martillo coloque los anclajes para

pared de yeso provistos hasta que queden

al ras del tomacorriente de pared.

7. Use el destornillador Phillips. Atornille los tornillos

provistos hasta que queden a 1/16” de la pared.

8. Para instalar la antena, alinee las ranuras en la

parte posterior de la antena con los tornillos.

Asegúrese de que el cable coaxial haya quedado

en la dirección deseada utilizando el canal

de cable en la parte inferior de la antena.

Instalación:

1. Attach the coax cable from the antenna

to the power ampliﬁer “Antenna”

1. Conecte el cable coaxial de la antena a la

“Antena” ampliﬁcadora de potencia.

2. Conecte el cable coaxial del ampliﬁcador

con la etiqueta “Receiver” a la

parte posterior del televisor.

Inhaltsverzeichnis

Sprachen:

Andere GE Antenne Handbücher

GE Ultra Pro Hover HD 250 Bedienungsanleitung

GE 24700-2 Bedienungsanleitung

GE TV 24769 Bedienungsanleitung

GE Ultra Edge HD Bedienungsanleitung

GE 43452 Bedienungsanleitung

GE Quadcore HD Bedienungsanleitung

GE 33692-2 Bedienungsanleitung

GE 33691 ultra-flat digital amplified antenna Bedienungsanleitung

GE 29884 Bedienungsanleitung

GE 34140 Bedienungsanleitung

GE Crystal HD Bedienungsanleitung

GE 34137 Bedienungsanleitung

GE 34134 Bedienungsanleitung

GE 14845 Bedienungsanleitung

GE Quantum Amplified Quantum Antenna Bedienungsanleitung

GE 24763 Bedienungsanleitung

GE 14846 Bedienungsanleitung

GE 26438 Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

IWCS

IWCS iriBelt II Einrichtungshandbuch