GE DBVH512GF Handbuch

DBVH512GF

GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer

Dimensions and Installation Information (in inches)

Gas Dryer Rating

120V 60Hz, 6A

Exhaust Options: B-way via rear,left, and bottom.

Circuit Requirements: An individual, properly grounded

branch circuit, protected by a 30-amp circuit breaker or

a time-delay fuse, is required.

Note: Dryer wall outlet must be located within 36"

of service cord entry and accessible when dryer is

mounted in position.

Installation Information: Forcomplete information, see

installation instructions packed with your dryer.

, 27

°:!!

31-1/8 1-5/8

41-1/2

For answers to your Monogram,®GE ProfileTM or

GE® appliance questions, visit our website at

ge.com or call GEAnswer Center ®service,

800.626.2000.

_ imagination atwork

Listedby

Underwriters

Laboratories

Specification Revised 3/06 360456

DBVH512GF

GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer

Special Installation Requirements:

Stacked Installation:

• Brackets for stacking dryer over washer are included with the washer.

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove orcloset, it will be

stated on a label on the dryer back.

• The dryer MUSTbe exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other

surfaces are: 0" either side,3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings,etc. is 52".

• Closetdoors must be Iouvered or otherwise ventilated and must contain a

minimum of 60 sq. in.of open area equally distributed. If this closet contains

both a washer and a dryer, doors must contain a minimum of 120 sq. in.of

open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with

a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUSTbe exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of

local codes,with the National FuelGas Code,ANSIZ223.

Minimum Clearance other than Alcove or Closet Installations:

• Minimum clearances to combustible surfaces 0" both sides,3" rear,

For more information on venting kits and accessories,

please call 1-800-GE-CARES.

For answers to your ivionogram2 GEProfild" or

GE® appliance questions, visit our website at

ge.com or call GEAnswer Center ®service,

800.626,2000.

Stacked Dimensions (in inches)

Pedestal Dimensions (in inches)

SBSD227FWW- white

SBSD227FGG- granite

This optional 13-3/8" pedestal

raisesthe door opening and

height of the washer or dryer.

13-3/8

_1_28.3/4 /

imagination at work

Listedby

Underwriters

Laboratories

Specification Revised 3106 360456

DBVH512GF

GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer

Drger Exhausting Information - Metal Duct Onlg

Forcomplete information, seeinstallation instructions packed with Four drFen

Ducting Materials: For best performance, this dryer should be vented with 4" diameter all

rigid metal exhaust duct. If "all rigid metal" duct cannot be used, then "flexible all metal"

venting can be used,but it will reduce the maximum recommended duct length.

Exhaust Length Calculation:

1 Determine the number of 90° turns needed for gour installation. If gou exhaust to the

sideor bottom of drger, add one turn.

2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated is

shown in the table. Themaximum length for flexible ducts are lessthan for rigid duct.

Aturn of 45° or lessmag be ignored. Two 45° turns within the duct length should be

treated as a 90°elbow.

Aturn over 45°should be treated asa 90° elbow.

Exhausting the drger to the outside isstronglg recommended to prevent largeamounts

of moisture and lint from being blown into the room, Gasdrgers or any drger located in a

closet must be exhausted to the outside.

Caution: Forpersonal safety do not terminate exhaust into a chimney, under ang enclosed

house floor (crawl space),or into an attic, since the accumulated lint could create a fire

hazard or moisture could cause damage. Neverterminate the exhaust into a common duct

or plenum with a kitchen exhaust, since the combination of lint and grease could create a

fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird

nesting, etc.The wall cap must also be located at least 12" above the ground or ang other

obstruction with the opening pointed Down.

Other terminations, such as Iouvered wall boxes,are acceptable provided theg are

equivalent to a 4" opening dampered wall cap.

For more information on venting kits and accessories, please call 1-800-GE-CARES.

Front Loading

Dryers

Number

90°

Turns

Best Performance

Maximum Length

of 4" Dia.

Rigid Metal Duct

Exhaust Hood Type

A 2-1/2"

4" Opening Opening

90 ft. 60 ft.

60 ft. 45 ft.

45 ft. 35 ft.

35 ft. 25 ft.

Haximum Length

of 4" Dia.

Flexible Metal Duct

Exhaust Hood Tgpe

A 2-i/2"

4" Opening Opening

55 ft. 45 ft.

40 ft. 30 ft.

30 ft. 20 ft.

20 ft. 15 ft.

imagination atwork

Listedby

Underwriters

Laboratories

Specification Revised 3106 360456

DBVH512GF

GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer

Features and Benefits

• 7.0 cu, ft, king-size capacity - Large enough to handle anything the washer

sends its way

• Sensor Dry Plus - Continually monitors moisture levels to help clothes look

better longer

• Dewrinkle Cycle - Tumbles clothes without heat to help reduce creasing and wrinkling

• 5 heat selections - Offer enhanced drying performance and fabric care

• Rotary electronic controls with LEDindicators - Hake it simple to select and monitor

wash cycles

• Deluxe dryer rack - Allows tumble-free drying of items like sneakers

and stuffed animals

• Custom cycles - Saves your favorite dry settings for one-touch recall

• Adjustable end-of-cycle signal - Alerts you when cycle is done, saving time

between loads

• q)uietDrum TM design - Additional sound-dampening materials minimize tumbling noise

• Removable lint filter with reminder light - Reminds you to clean the easy-to-reach

upfront filter

• Speed Dry - Delivers ready-to-go results in minutes

• Hultiple dry cycles - Deliver optimal drying results

• Dual thermistors - Combined with sensor bars, these help maintain consistent

heat and ensure the right level of dryness is reached

• Hodel DBVH512GFWW - White on white

• Model DBVHB12GFGG- Granite gray

(_ imagination at work Specification Revised 3106 360456

Andere Handbücher für DBVH512GF

Dieses Handbuch passt für folgende Modelle

Beliebte Trockner Handbücher anderer Marken

Bosch

Bosch WTA79200GB Bedienungsanleitung

Amana

Amana W10233410A Bedienungsanleitung

Miele

Miele TWH 780 WP Bedienungsanleitung

Asko

Asko T760 Bedienungsanleitung

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Bedienungsanleitung

Bosch

Bosch Logixx 10 WTB76556GB Technisches Datenblatt

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Bedienungsanleitung

Electrolux

Electrolux EW2H328R2 Bedienungsanleitung

Beko

Beko DS8433RX1M Bedienungsanleitung

Dawlance

Dawlance Spinner DS 6000 C Bedienungsanleitung

Electrolux

Electrolux TP5080TW Bedienungsanleitung

AEG

AEG TR838P4OB Bedienungsanleitung

Indesit

Indesit IDV 75 Bedienungsanleitung

Infiniton

Infiniton SD-DG85C Bedienungsanleitung

BOMANN

BOMANN WT 5019 Bedienungsanleitung

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Bedienungsanleitung

Asko

Asko T793C Bedienungsanleitung

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Bedienungsanleitung