GE DCVH680GJ Handbuch
For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
Specification Revised 1/08 360453
Listed by
Underwriters
Laboratories
Dimensions and Installation Information (in inches)
Exhaust Options: 3-way via rear, left, and bottom.
Circuit Requirements: An individual, properly grounded
branch circuit, protected by a 15-20 amp circuit breaker
or a time-delay fuse, is required.
Note: Dryer wall outlet must be located within 36”
of service cord entry and accessible when dryer is
mounted in position.
Installation Information: For complete information, see
installation instructions packed with your dryer.
27 1-5/8
41-1/2
31-1/8
5-1/2
3-3/4
Gas Dryer Rating
120V 60Hz, 6A
DCVH680GJ
GE®7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
360453
Specification Revised 1/08
Special Installation Requirements:
Stacked Installation:
• Brackets for stacking dryer over washer are included with the washer.
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side, 3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with
a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.
Minimum Clearance other than Alcove or Closet Installations:
• Minimum clearances to combustible surfaces 0" both sides, 3" rear.
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
Stacked Dimensions (in inches)
80-1/8
DCVH680GJ
GE®7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
Listed by
Underwriters
Laboratories
Specification Revised 1/08 360453
Dryer Exhausting Information – Metal Duct Only
For complete information, see installation instructions packed with your dryer.
Ducting Materials: For best performance, this dryer should be vented with 4” diameter all
rigid metal exhaust duct. If “all rigid metal” duct cannot be used, then “flexible all metal”
venting can be used, but it will reduce the maximum recommended duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the
side or bottom of dryer, add one turn.
2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is
shown in the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be
treated as a 90° elbow.
A turn over 45° should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts
of moisture and lint from being blown into the room. Gas dryers or any dryer located in a
closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire
hazard or moisture could cause damage. Never terminate the exhaust into a common duct
or plenum with a kitchen exhaust, since the combination of lint and grease could create a
fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird
nesting, etc. The wall cap must also be located at least 12" above the ground or any other
obstruction with the opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are
equivalent to a 4" opening dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
DCVH680GJ
GE®7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
Listed by
Underwriters
Laboratories
Best Performance
Maximum Length
of 4" Dia.
Rigid Metal Duct
Maximum Length
of 4" Dia.
Flexible Metal Duct
Number
of
90°
Turns
Exhaust Hood Type Exhaust Hood Type
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
B
2-1/2"
Opening
Front Loading
Dryers
0
1
2
3
90 ft.
60 ft.
45 ft.
35 ft.
60 ft.
45 ft.
35 ft.
25 ft.
55 ft.
40 ft.
30 ft.
20 ft.
45 ft.
30 ft.
20 ft.
15 ft.
A
B
2-1/2
4
GE Dryer Vent
Specification Revised 1/08 360453
DCVH680J
Features and Benefits
• 7.0 Cu. Ft. Super Capacity - Handles large-size items and family-size loads
• Sensor Dry Plus™- Continually monitors moisture levels to help clothes look
better longer
• Rotary Electronic Controls with Cycle Countdown Display and LED Indicators -
Simplify the cycle selection and provide accurate cycle times
• Interior Dryer Light - Lets you see everything inside for easy loading and unloading
• Deluxe Quiet - Provides near-silent performance with a quiet-engineered motor
and components, plus an extra layer of insulation
• Adjustable End-Of-Cycle Signal - Alerts you when cycle is done, saving time
between loads
• Multiple Dry Cycles - Deliver optimal drying results
• Anti-Bacteria Option - Certified by the NSF®to reduce up to 99% of certain types
of bacteria
• 5 Heat Selections - Offer enhanced drying performance and fabric care
• DuraDrum™- Provides long-lasting dependability and durability
• Damp Dry Signal - Reminds you when to remove select items for hang-drying
• Delay Start - Lets you do the laundry on your terms
• Model DCVH680GJBB – Black on black
• Model DCVH680GJMR – Metallic red
• Model DCVH680GJMS – Metallic silver
• Model DCVH680GJWW – White on white
DCVH680GJ
GE®7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
Dieses Handbuch passt für folgende Modelle
4
Andere GE Trockner Handbücher
GE
GE DBL333 Anleitung zur Verwendung
GE
GE Spacemaker DSKP333EC Handbuch
GE
GE GTD58GBSVWS Bedienungsanleitung
GE
GE Profile DPSE810 Bedienungsanleitung
GE
GE DDE8107M Bedienungsanleitung
GE
GE GFDS355EL1MS Bedienungsanleitung
GE
GE Appliances Profile PFDS450 Originalbetriebsanleitung
GE
GE DDE6407L Bedienungsanleitung
GE
GE DDE5100M Bedienungsanleitung
GE
GE DCLR333H Bedienungsanleitung
GE
GE DCVH480 Bedienungsanleitung
GE
GE GFDN160GJWW Bedienungsanleitung
GE
GE 175D1807P596 Bedienungsanleitung
GE
GE Profile DPGT650 Betriebsanleitung
GE
GE DCCB330GJWC Bedienungsanleitung
GE
GE GFDS175 Bedienungsanleitung
GE
GE DRSR483EG Handbuch
GE
GE DPSB613GD Bedienungsanleitung
GE
GE GTDP220EFWW Bedienungsanleitung
GE
GE DSKS433EB0WW Bedienungsanleitung
Beliebte Trockner Handbücher anderer Marken
Indesit
Indesit IDV 75 Bedienungsanleitung
Infiniton
Infiniton SD-DG85C Bedienungsanleitung
BOMANN
BOMANN WT 5019 Bedienungsanleitung
Alliance Laundry Systems
Alliance Laundry Systems TMB795C Bedienungsanleitung
Asko
Asko T793C Bedienungsanleitung
Kenmore
Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Bedienungsanleitung