GE Spacemaker DSKP333EC Handbuch
For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
360430
Specification Revised 9/07
Listed by
Underwriters
Laboratories
DSKP333EC
GE Spacemaker® Portable Dryer
Dimensions and Installation Information (in inches)
Dryer Note:
Dryer wall outlet must be locted within 36" of service cord entry and accessible
when dryer is mounted in position.
80
100
120
140
OFF
10
20
30
OFF
OFF
EXTRA
DRY
OPTIMUM
REGULAR HEA
T
60
50
40
30
20
10
cool down
cool
down
AUTOMATIC C YCLE
NO HEA
T
FLUFF CYCLE
PUSH TO S TART
HIGH HEA
T
*
PREFERRED SETTING
TIMED CYCLE
DSKP333ECWW
33-1/4
24-1/2
23-7/8
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on
a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.
• Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open
area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with
a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
• Minimum clearances to combustible surfaces
0" both sides
3" rear
For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
360430
Specification Revised 9/07
Listed by
Underwriters
Laboratories
DSKP333EC
GE Spacemaker® Portable Dryer
Dimensions and Installation Information (in inches) For complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4" diameter all rigid metal
exhaust duct. If “all rigid metal” duct cannot be used, then “flexible all metal”
venting can be used, but it will reduce the maximum recommended duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to
the side or bottom of dryer, add one turn.
2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be
tolerated is shown in the table. The maximum length for flexible ducts are less
than for rigid duct.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should
be treated as a 90° elbow. A turn over 45° should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large
amounts of moisture and lint from being blown into the room. Gas dryers or any
dryer located in a closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any
enclosed house floor (crawl space), or into an attic, since the accumulated lint could
create a fire hazard or moisture could cause damage. Never terminate the exhaust
into a common duct or plenum with a kitchen exhaust, since the combination of lint
and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts,
bird nesting, etc. The wall cap must also be located at least 12" above the ground or
any other obstruction with the opening pointed down.
Other terminations, such as louvered wall boxes, are acceptable provided they are
equivalent to a 4" opening dampered wall cap.
For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
360430
Specification Revised 9/07
Listed by
Underwriters
Laboratories
DSKP333EC
GE Spacemaker® Portable Dryer
Features and Benefits
• 3.6 Cu. Ft. Capacity
• 3 Dry Cycles: Cottons – Automatic regular, timed dry
(150 mins.) and quick fluff (no heat) - 30 mins.
• 3 Heat Selections (Timer)
• DuraDrum™Interior
• Quiet-By-Design™
• Portable Model
• Model DSKP333ECWW – White on white
80
100
120
140
OFF
10
20
30
OFF
OFF
EXTRA
DRY
OPTIMUM
REGULAR HEA
T
60
50
40
30
20
10
cool down
cool
down
AUTOMATIC C YCLE
NO HEA
T
FLUFF CYCLE
PUSH TO S TART
HIGH HEA
T
*
PREFERRED SETTING
TIMED CYCLE
DSKP333ECWW
Dieses Handbuch passt für folgende Modelle
1
Andere GE Trockner Handbücher
GE
GE DLSR483GG Handbuch
GE
GE DRSR495EG Handbuch
GE
GE DWSR483EG Handbuch
GE
GE DPSR513 Konfigurationshandbuch
GE
GE GTD33GASKWH Bedienungsanleitung
GE
GE GTX22GASKWW Bedienungsanleitung
GE
GE Profile UPVH890 Originalbetriebsanleitung
GE
GE DDE7209R Montageanleitung
GE
GE DNCD450GGWC Handbuch
GE
GE GFDS355GL1MV Bedienungsanleitung
GE
GE Spacemaker DSKS433EB Handbuch
GE
GE GFDS260EFWW Handbuch
GE
GE DNCD450GG9WC Bedienungsanleitung
GE
GE DBL333 Bedienungsanleitung
GE
GE DBXR463ED Handbuch
GE
GE DCVH640GJ Handbuch
GE
GE DVLR223EG Handbuch
GE
GE DDC4400SKMWH Bedienungsanleitung
GE
GE GFD55 Originalbetriebsanleitung
GE
GE GTX42GASJWW Bedienungsanleitung
Beliebte Trockner Handbücher anderer Marken
Indesit
Indesit IDV 75 Bedienungsanleitung
Infiniton
Infiniton SD-DG85C Bedienungsanleitung
BOMANN
BOMANN WT 5019 Bedienungsanleitung
Alliance Laundry Systems
Alliance Laundry Systems TMB795C Bedienungsanleitung
Asko
Asko T793C Bedienungsanleitung
Kenmore
Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Bedienungsanleitung