GE Cync CFIXCNLR4S1 Bedienungsanleitung

Wafer Downlight

Installation Guide

4-in & 6-in Integrated LED Recessed Fixture

GE and C by GE is a trademark of General Electric Company. Used under trademark license.

Gettings Started

STEP 1

Download the Cync App, powered

by Savant, on your smartphone

STEP 2

Determine your Wafer Downlight

location and complete installation

STEP 3

Add your Wafer Downlight to the

Cync App

For set up help, visit cyncsupport.gelighting.com

or call 1-844-302-2943

*DIRECTLY CONNECT TO AMAZON ALEXA

Complete installation and turn on light.

If Alexa says, “New light found”, you can begin using your light with Alexa.

Otherwise say, “Alexa, discover my devices” and then use Alexa to control your light.

Let’s Do It

INCLUDED SOLD

SEPARATELY

YOU’LL NEED

Hammer LadderFlathead

Screwdriver

Junction Box Integrated

LED Trim

Wire Nuts (3)

Drywall Saw or

Hole Saw

(4-1/4” or 6-1/4”

diameter)

Safety

Glasses

Hole Template

Needle

Nose Pliers

Strain Relief

MODEL INPUT VOLTAGE

(Vac, Hz)

CURRENT

(mA)

WATTAGE

(W)

CFIXCNLR4S1

CFIXCNLR6S1

CFIXCNLR4C1

CFIXCNLR6C1

120, 60

110

130

110

130

Dimming Capability

NOT FOR USE WITH DIMMER SWITCHES. Compatible with only

CYNC and C by GE smart dimmers that provide dimming at the

switch or through the CYNC App.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Speciﬁcations

Warning

• Risk of ﬁre or electric shock. Installation requires knowledge of

luminaire electrical systems. If not qualiﬁed, do not attempt

installation. Minimum 90°C Conductors, if uncertain contact a

qualiﬁed electrician.

• To prevent wiring damage or abrasion, do not expose wiring to

edges of sheet metal or other sharp objects.

• These products are intended to be used in dry, damp or wet locations.

• IC rated for direct contact with insulation.

Prepare Electrical Wiring

Electrical Requirements

The LED ﬁxture must be supplied with 120VAC 60Hz

Grounding Instructions

The grounding and bonding of the overall system shall be

done in accordance with National Electric Code(NEC)

Article 410 and local codes.

BEFORE YOU DO ANYTHING:

Turn Oﬀ Power

STEP 1

Turn oﬀ power source at

the main circuit breaker or

fuse box.

ON OFF

Mark the Location on the Ceiling

& Cut the Hole

STEP 2

Determine the position of

your downlight:

• Maximum distance from

junction box to the

downlight is 16 inches.

• Location must be within

range of 2.4GHz Wi-Fi to

enable smart control.

Once determined, use the

hole template to trace the

hole size. Cut the hole using

a drywall or hole saw.

4” wafer requires a 4-1/4

inch hole

6” wafer requires a 6-1/4

inch hole

Remove the Knockout

& Wire the Wafer Downlight

STEP 3

Remove the knockout using

a hammer and screwdriver.

Open the junction box cover.

Attach the strain relief (not

included) into the knockout

hole.

Route the wires through the

strain relief.

Connect the wires:

• black to black

• white to white

• green to green or bare

copper wire

Secure the wires with the

three provided wire nuts.

Close the cover of the

junction box.

Place Junction Box in the Ceiling

& Install the Fixture

STEP 4

Place the junction box in the ceiling

through the hole.

Connect the light to junction box

using the connector.

Screw the connector together to

complete the connection.

STEP 5

Hold the spring clips against the

ﬁxture and gently guide into the

ceiling until the clips snap into

place.

Complete setup in the Cync App.

Additional Information and Warnings

FCC Compliance Statement Compliance Notice:

Warning: Changes or modiﬁcations to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment oﬀ and on, the user

is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit diﬀerent from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help

The device must not be co-located or operating in conjunction with any other

antenna or transmitter.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere GE Beleuchtungsausrüstung Handbücher

GE 17421 Bedienungsanleitung

GE Versaflood II Bedienungsanleitung

GE Tetra GEPS24-300U-GL Bedienungsanleitung

GE 75976 Bedienungsanleitung

GE Tetra PowerMAX Bedienungsanleitung

GE LED Puck Lights Bedienungsanleitung

GE RTL-FPC-2835-2.5cm-19.6FT-120V-Ex-B Bedienungsanleitung

GE Lumination 93047465 Bedienungsanleitung

GE Arize Element Series Bedienungsanleitung

GE NHL Tree LED 700 LIGHTS Bedienungsanleitung

GE DSN-XM-MK0288-5FT-120V-M Bedienungsanleitung

GE Evolve EWLS Series Bedienungsanleitung

GE HO HO HO Bedienungsanleitung

GE Evolve Leitfaden

GE RTL-FPC-2835-2.5cm-19.6FT-120V-Ex-R Bedienungsanleitung

GE 77006LO Bedienungsanleitung

GE Arize Factor Bedienungsanleitung

GE Arize Element Top Light Bedienungsanleitung

GE NHL Tree 23009LO Bedienungsanleitung

GE current Tetra miniMAX GEMM71-W1 Bedienungsanleitung

GE Tetra PowerGrid-Gen 3 Bedienungsanleitung

GE ProSys DEH40212 Bedienungsanleitung

GE 19005LO Bedienungsanleitung

GE LED-C6-150 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung