GE PGCS1R Bedienungsanleitung

Dieses Handbuch passt für folgende Modelle

3

Inhaltsverzeichnis

Andere GE Kühlschrank Handbücher

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung

Bottom Freezer with Ice & Water in Door

PGCS1R

PFCF1R

PFSS5R

PGSS5R

BJ 5/11

IMPORTANT SAFETY NOTICE

The information in this presentation is intended for use by individuals

possessing adequate backgrounds of electrical, electronic, &

mechanical experience. Any attempt to repair a major appliance may

result in personal injury & property damage. The manufacturer or seller

cannot be responsible for the interpretation of this information, nor can it

assume any liability in connection with its use.

WARNING

To avoid personal injury, disconnect power before servicing this product.

If electrical power is required for diagnosis or test purposes, disconnect

the power immediately after performing the necessary checks.

RECONNECT ALL GROUNDING DEVICES

If grounding wires, screws, straps, clips, nuts, or washers used to

complete a path to ground are removed for service, they must be

returned to their original position & properly fastened.

Dyneema®Cut

Resistant Glove

Dyneema®Cut

Resistant Glove

Safety Glasses must be

ANSI Z87.1-2003 compliant

Safety Glasses must be

ANSI Z87.1-2003 compliant

Prescription Safety GlassesPrescription Safety Glasses

Plano Type Safety GlassesPlano Type Safety Glasses

Steel Toe Work

Boot

Steel Toe Work

Boot

Electrically Rated Glove

and Dyneema®Cut

Resistant Glove Keeper

Electrically Rated Glove

and Dyneema®Cut

Resistant Glove Keeper

Brazing GlassesBrazing Glasses

GE Factory Service Employees are required to use safety glasses with

side shields, safety gloves & steel toe shoes for all repairs.

Copyright General Electric 2011

Copyright General Electric 2011

Key selling messages:

• GE’s Tallest Dispenser

• Zero Space - Pin-Point LED Lighting

• Large, Easy to Read / Use Display

• Shelf Management System (Up to 5)

•8 Models

Marketing Features

New Ice & Water Section

Copyright General Electric 2011

New Ice and Water in Door

Lift slightly “up” to remove bucket

Copyright General Electric 2011

Bucket holds approximately 4 lbs

Ice Operation

Copyright General Electric 2011

Cubes Crushed

Ice Operation

Copyright General Electric 2011

Ice Operation – Basic Logic

The new BM Ice in Door model has multiple and unique logic and calculations that are

accomplished with the board, the control settings, and feedback from thermistors.

However, the new ice door does not have its own thermistor and therefore calculations

are accomplished with input from the FF and FZ thermistors.

The new BM does utilize a dedicated blower fan to send cold air up from the freezer,

through a channel and into the ice section.

Ice Making/Harvest mode:this mode looks for water valve or dispenser action within a two

hour period of time. ( 4 minute response time) If seen, the ice section temperature should be

approximately 0° F degrees.

Ice Storage mode: if above activity is not detected, the temperature in the ice section could

raises as high as approximately 15° - 25°F.

Ice Hardening mode: this mode tries to account for high number of door openings and maintain

similar temperatures as the ice storage mode

Remember that temperature in the ice section is tied to the control settings so the

warmer the FZ section is set for, the warmer the ice section. A freezer setting below “5”

will produce the warmest ice section temperature.

NOTE: Ice stored for more than 10days could clump.