GE 31GT720 Bedienungsanleitung

WARNING

To reduce the risk of fire or

electric shock, do not expose

this TV to rain or moistgre.

Cable "IV Installer:

To reduce the risk of electric shock, do not remove

RISK.OFELECTRIC cover (or back). No user-serviceable parts inside.

SHOCKDONOTOPEN Refer servicing to qualified service personnel.

,_ This symbol indicates

"dangerous voltage" inside the

product that presents a risk of

electric shock or personal injury.

This symbol indicates

important instructions

accompanying the

product.

Caution: To prevent electric shock, match wide blade of

plug to wide slot, fully insert.

Attention: Pour eviter les chocs electriques, introduire

la lame la plus large de la fiche dans la borne

correspondante de la prise et pousser jusq_ au fond.

Refer to the identification/rating label located on the back panel of your

product for its proper operating voltage.

FCC Regulations state that unauthorized changes or modifications to this

equipment may void the user's authority to operate it.

If fixed (non-moving) images are left on the screen for long periods, they

may be permanently imprinted on the screen. Such images include

network Iogos, phone numbers, and video games. This damage is not

covered by your warranty. Extended viewing of channels displaying

these images should be avoided.

This reminder is provided to call your attention to Article 820-40 of the

National Electrical Code (Section 54 of the Canadian Electrical Code, Part

1) which provides guidelines for proper grounding and; in particular,

specifies that the cable ground shall be connected to the grounding

system of the building as close to the point of cable entry as practical.

Product Registration

Please fill out the product registration card and return it immediately. Returning the card allows us to contact you if

needed.

Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach it here and record the serial

and model numbers in case you need them. The numbers are located on the back of the product.

Model No.

Serial No.

Purchase Date:

Dealer/Address/Phone:

G-LINK, VCR Plus+, C3, PlusCode, GUIDE Plus+, and GUIDE Plus+ Gold are trademarks of Gemstar Development

Corporation.

Thomson Consumer Electronics and Gemstar are not in any way liable for the accuracy of the program information

provided by the GUIDE Plus+ System. In no event shall Thomson Consumer Electronics or Gemstar be liable for any

amount representing loss of profits, loss of business, or indirect, special, or consequential damages in connection

with the provision or use of any information equipment, or services relating to the GUIDE Plus+ System.

Interactive Setup ................................................................... 3

Step 1: Unpack the IV ..................................................................... 4

Step 2: Connect Your TV ................................................................. 4

TV Only ....................................................................................... 4

The Basic Connection ............................................................... 5

Advanced Connections ............................................................. 6

Step 3: Connect the G-LINK Cable .................................................. 9

How to Find the Remote Control Sensor ................................ 9

Step 4: Plug in the TV .................................................................... 10

Step 5: Place Batteries in Remote ................................................ 10

Step 6: Turn On the TV .................................................................. 10

On-Screen Program Guide ..................................................... 10

Step 7: Program the TV ................................................................. 10

Interactive Setup ................................................................. 11

Using Point and Select .................................................................. 12

Entering Setup ............................................................................... 12

Selecting a Language .................................................................... 13.

Auto Channel Search ..................................................................... 13

Setting up the GUIDE Plus+ System ............................................ 14

Setting the _me ............................................................................. 16

Setting the vcR1 Channel (Auto Tuning): .................................... 17

Setting the VCR2 Channel (Auto Tuning) ..................................... 17

Setting the DVD Channel (Auto Tuning) ...................................... 18

Setting the SAT/CABLE Channel (Auto Tuning) .......................... 18

Labeling the Channels ................................................................... 19

What Now? ..................................................................................... 20

Program the Remote ................................................................ 20

Using the Remote ............................................................... 21

Remote Buttons ............................................................................. 22

Using the WHO.INPUT Button ............................................... 23

Programming the Remote ............................................................ 24

Testing the Remote ................................................................. 24

Programming the Remote ...................................................... 24

Using the Remote to Control a Device .................................. 25

Front Panel ..................................................................................... 25

MenusandControlPanels ............................................................ 28

Menus ....................................................................................... 28

Control Panels ......................................................................... 29

Audio Menu .................................................................................... 30

Using the Remote to Select an Audio Processor ........................ 31

Picture Quality Menu ..................................................................... 32

Screen Menu .................................................................................. 33

Using Closed Captioning ........................................................ 34

Channel Menu ................................................................................ 35

"l]me Menu ...................................................................................... 36

Features and Controls ......................................................... 37

GUIDE Plus+ Menu ........................................................................ 38

About the GUIDE Plus+ System ................................................... 38

Getting In & Out of the Guide Plus+ System ........................ 39

Downloading Data ................................................................... 39

The Different GUIDE Plus+ System Menus ........................... 39

Grid Guide....,: .......................................................................... 40

Sort ........................................................................................... 41

Schedule .................................................................................. 42

Messages ................................................................................. 43

Editor ........................................................................................ 44

Expanded Information ............................................................ 45

Troubleshooting ...................................................................... 45

Channel Marker .............................................................................. 46

Parental Controls and V-Chip ........................................................ 47

V-Chip TV Rating Limit ............................................................ 48

V-Chip Movie Rating Limit ...................................................... 52

V-Chip Unrated Program Block .............................................. 53

Channel Block .......................................................................... 53

Front Panel Block ..................................................................... 53

Lock/Unlock Parental Controls .................................... i.......... 53

Reference .............................................................. ............. 54

Troubleshooting ............................................................................. 54

Care and Cleaning ................................................................... 55

Warranty ......................................................................................... 56

Accessory Information .................................................................. 58

Index .................................................................................. 61

Getting Started

This manual is designed to get you started

qSickly. The first five sections of the manual

show you how to get your TV Setup and

Connected, run the Interactive Setup, Program

the Remote, and use all of the menus, features,

and controls of your TV.

The Reference section in the back of the book

contains troubleshooting tips, care and cleaning

instructions, accessory ordering information

and your warranty.

Well... if your TV's out of the box, let's get

started.

SETUP AND

CONNECTIONS

Iheck out the notes that have been

added throughout the manual in

these tip boxes. There are some

important tips that will help you get

the most from your TV,

Step 1: Unpack the TV

Make sure to locate the remote control.

Step 2: Connect Your TV

There are three types of connections outlined in this section:

TV Only: If you're only going to connect the

TVto your home antenna or cable

system,

The Basic Connection: If you're going to connect the TV to a

VCR or satellite receiver.

Advanced Connections: If you're going to make multiple

connections, hooking up the TV to a

VCR and a satellite receiver.

Cable information and illustrations are given for each type of

connection. Once you have completed your desired connection

you may skip forward to Step 3,

This is abasic connection from an antenna or cable system to

your TV. Connect the cable into the Cable/Antenna jack as shown.

Cables

You will use the following cable to make your connection:

Coaxial Cable: These cables carry audio and

video signals to the TV from an antenna,

cable, or cable box.

Important Stand Information

CAUTION: Choose the location for

your TV carefully. Take precautions

that the stand or other furniture on

which the TV is placed is properly

located (see Important Safeguards

sheet) and of adequate size and

strength to prevent the TV from

accidentally being tipped over,

pushed off, or pulled off, This could

cause damage to the TV and/or

personal injury.

Before You Connect

Protect against power surges:

• Connect all components before

plugging any power cords into the

wall outlet,

• Turn off the TV and/or component

before connecting or disconnecting

any cables,

•Make sure all antennas and cables

are properly grounded. Refer to the

Important Safeguards sheet

packed with your TV,

CABLE, CABLEBOX, OR ANTENNA

IOnce you have completed this 1

connection you may skip to Step 3.

The Basic Connection

The basic connection below (TV and VCR) is the most common

connection and is therefore used to illustrate asingle"

component connection with your TV. For better sound and

picture quality and multiple component connection information

refer to the next section, Advanced Connections.

Cables

You will use the following type of cable to make your

connection:

Coaxial Cables: In this connection, two

coaxial cables are used: one connects from

an antenna, cable, or cable box to the VCR,

and one connects from the VCR to the TV.

These cables carry both audio and video

signals.

CABLE,CABLEBOX,ORANTENNA

VCR1

INFROMANT CH3 I

VIDEO AUDIO

VIDEO R AUDIO L )_=

leo el" /

OUT

G-LINK CABLE/

How to View the VCR

To watch the VCR in this connection,

tune the TV to Channel 3 or 4.

Later, in the Interactive Setup section

you will program the TV to automatically

tune to Channel 3 or 4 when you turn.on

the VCR.

Once you have completed this connection you may skip to

Step 3, "Connect the G-LINK Cable."

Advanced Connections

Advanced connections give you better sound and video by

separating the audio and video signals and enabling you to

connect multiple components.

This section describes the types of inputs available on the back

of your TV and suggests ways you can use them for optimum

performance. r 1

Once you have made your

connections you will need to

program the TV to tune to the

correct video input channel in order

to see and hear audio and video from

the component. You will program

this later in the Interactive Setup.

Back of the TV

The diagram below describes each of the back panel jacks.

When connecting A/V cables, be sure to connect corresponding

OUTPUTS and INPUTS (Video to Video, Right Audio to Right

Audio, etc.).

Video and Audio Inputs

Connect any one of the following components:

•VCR • Internet Access Device

• Laserdisc Player • DVD Player

Satellite Receiver

To view the component connected to VIDEO,

use the WHO.INPUT button on the remote.

_ VID£O

G-LINK

Aoo,o

R L

[8 81°

S-V_DEO

G-LINK

Connect the G-LINK cabl

for one-button recordin

and channel tuning from

the GUIDE Plus+ system,

S-Video

This optional

connection can be

used for better

video quality

picture.

Audio Outputs

Connect to an audio receiver

or amplifier for variable

controlled or fixed level stereo

output.

CABLE/

ANTENNA

lCable/Antenna

Takes the signal input from a cable, |

cable box, or an off-air antenna. Can also be I

used for basic component connections. J

Sample Connections

The following are sample connection scenarios you may

encounter when connecting components to your TV. Note: if you

connect an S-Video cable, you must also connect an Audio/Video

cable to the AUDIO R and L jacks.

Cables

You will use the following types of cables to make your

connection:

Coaxial Cables: Carries the signal from the antenna or

cable directly to the television or through

acable box, as needed by your cable

system.

AudioNideo Cables: Carries audio and

video from a component to the TV.

S-Video Cable: Carries video from an

S-Video capable component which

provides best picture quality.

TV and StereoVCR

Compared to the Basic Connection, using AudioNideo and

S-Video (if available) cables will enhance the sound and picture

quality from a component.

Cautions:

Position Cables to Avoid Audio Hum

or Interference

• Insert all cables firmly into jacks.

•Place the audio/video cables to the

sides of the TV's back panel

instead of straight down the

middle,

•Try not to coil any twin-lead cables

and keep them away from the

audio/video cables.

Protect Your Components From

Overheating

•Do not block ventilation holes in

any of the components. Arrange

the components so that air can

circulate freely.

• Do not stack components,

•Allow adequate ventilation when

placing your components in a

stand.

•Place an amplifier on the top shelf

of the stand so heated air rising

from it will not flow around other

components.

CABLE, CABLE BOX, OR ANTENNA

VCR 1

How to View Your VCR

To watch the VCR in this connection, press TV to put

the remote control into TV mode, then press

WHO-INPUT to toggle to the video (VID) inputs.

In the Interactive Setup section you can program the

TV to automatically tune to the VID input channel

when you turn on the VCR.

Most Audio/Video cables are combined into

one cable with three heads

on each end. We show Video(ellow)

individual cables in these RightAudio(red)

sample connections.

Either may be used, but e)

you must be sure to connect

Video to Video, Right to Right

and Left to Left.

TV, VCR and Satellite Receiver

CABLE,CABLE BOX, OR ANTENNA

SATELLITERECEIVER

VCR 1

SATELLITESfGNAL

How to View Your Components

To watch the satellite receiver in this

connection, press TV to put the remote

control into TV mode, then press

WHO*INPUT to scroll through the video input

channels until you tune to VID (or SVID)

input.

To watch the VCR in this connection, enter 03

to tune to the VCR channel.

In the Interactive Setup you can program the

TV to automatically tune to the correct input

channel when you turn on your component.

Inhaltsverzeichnis

Beliebte Fernseher Handbücher anderer Marken

Toshiba

Toshiba 27A10 Bedienungsanleitung

Philips

Philips 42PF9630A/37 Bedienungsanleitung

Hitachi

Hitachi 32FX48B Bedienungsanleitung

DAEWOO ELECTRONICS

DAEWOO ELECTRONICS DTQ-14V1FC Bedienungsanleitung

Changhong Electric

Changhong Electric uhd55b6000is Bedienungsanleitung

Philips

Philips Matchline 21CE7551 Bedienungsanleitung

Panasonic

Panasonic Genus TX-G10 Bedienungsanleitung

Toshiba

Toshiba 19A20 Bedienungsanleitung

Philips

Philips 25PT4523-16 Bedienungsanleitung

Sony

Sony XBR-100Z9D Bedienungsanleitung

Philips

Philips PR0930X3 Bedienungsanleitung

Philips

Philips Brilliance 231P4QPY Bedienungsanleitung

Samsung

Samsung 55S9 B Series Bedienungsanleitung

Philips

Philips 32HF9385D Fehlerbehebungshandbuch

Philips

Philips Colour Television Bedienungsanleitung

Sharp

Sharp LC-40FI5012E Bedienungsanleitung

Loewe

Loewe Table Stand Reference 55 Bedienungsanleitung

Philips

Philips 32PFH5300 Bedienungsanleitung