7
Setting Up
Connect one end of the curly cord to the handset. The other end of the
curly cord plugs into the socket on the left hand side of the CL210A unit.
Place the handset on the cradle.
Connect the line cord to the socket located at rear of telephone and
then thread it through the groove toward the back of the unit. Connect the
plug at the other end of the line cord into the wall socket (**).
Connect the power supply to the socket located at rear of the telephone
then plug into a 13amp wall socket (*). Please choose a socket near your
telephone to enable you to unplug the mains power quickly in case of a
problem.
Wall Mounting
If you mount the telephone on the wall, you can hang the receiver on the
telephone without hanging up. You will find a small hook for this purpose at
the upper end of the receiver rest.
1. Install 2 screws with wall plugs into the wall. These should be one
above the other, 83mm apart, and extending 5mm out from the wall to hold
the telephone base securely.
2. Install the long telephone line cord into the jack in the base. Thread it
through the groove and plug it into modular wall socket (**).
3. Hang the base on the screws and pull it down to lock it on.
4. Connect one end of the curly cord to the handset. The other end of the
curly cord plugs into the socket on the left hand side of the CL210A unit
5. Turn the receiver hook 180 degrees so that the receiver can be placed
on-hook.
(*) Classified “hazardous voltage” according to EN60950 standard
(**) Classified TNV-3 according to EN60950 standard.
INSTALLATION
