Important Safety Information. Read the following warnings
carefully before installing or operating the Energy Logger.
• The logger must only be used as intended and in accordance
with the instructions in this manual. Failure to do so may
impair the safety features of the logger.
• Never attempt to use the logger or accessories if they appear
to be damaged or malfunctioning. Disconnect the mains
supply and contact your supplier.
• The logger is for indoor use only. Do not use in damp or wet
environments.
• Installation of this logger may expose the operator to
hazardous voltages. If in doubt, refer to a qualied electrician.
• The mains input of the logger (see page 6) must only be
connected to an AC mains socket using the supplied lead. Do
not exceed the maximum rated input voltage for the logger.
• The current measurement inputs must only be connected
to approved exible coil current transducers, Gemini part
number ACS-002X. Any other type of connection may
damage the logger and expose the user to hazardous
voltages.
• An earthed mains connection is required for correct
operation, not for device safety.
• When changing batteries, make sure the mains lead is
removed from the logger.
• Only use 4 x Alkaline AA batteries, observing the correct
polarity.
• The logger must only be operated with the battery cover
tted.
• The logger contains no user-serviceable parts. Do not
open (except to remove the battery cover when replacing
batteries).
• The logger contains hazardous voltages and a lithium battery.
Servicing must be carried out by an authorised service centre
only. Please contact your supplier for further information.
02 Warnings & PAT Testing Instructions
04
