Genesis GV60 Bedienungsanleitung
GENESIS
GV60
EMERGENCY RESCUE
MANUAL
1. Identification / recognition 1
2. Immobilization / stabilization / lifting 3
3. Disable direct hazards / safety regulations 5
4. Access to the occupants 9
5. Stored energy / liquid / gases / solids 12
6. In case of fire 15
7. In case of submersion 19
8. Towing / transportation / storage 20
9. Important additional information 23
Contents
Initial Response: Identify, Immobilize and Disable
The following procedures should be used whenever you are dealing with a GV60 at
an emergency scene. However, all operations should be consistent with your
department's standard operating procedures, guidelines, and any applicable laws.
When an EV is damaged in a crash, the high voltage safety systems may have been
compromised and present a potential high voltage electrical shock hazard. Exercise
caution and wear appropriate personal protective equipment (PPE) safety gear,
including high voltage safety gloves and boots. Remove all metallic jewelry,
including watches and rings.
1. Identification / recognition 1
Identify
The GV60 is an electric vehicle. Emergency responders should respond to
emergency scenarios involving the GV60 accordingly, exercising extreme care and
caution to avoid contact with the high voltage system within the vehicle.
The safest method is to assume that Electrified GV60 you respond to is an electric
vehicle. Using the information provided in this section, responders will be able to
differentiate between the two.
1. Identification / recognition 2
General Vehicle Description
Identifying an Electrified GV60
Charge Port Charge Port
(W/o Cap)
Charge Door
GV60
GENESIS
The next step is to immobilize the vehicle to prevent any accidental movement that
can endanger the emergency response personnel and any crash victims. Since the
Electrified GV60 doesn’t have an engine, there will be instances where the vehicle
appears to be off because of the absence of engine noise. When in its “ready” mode,
the vehicle can move almost silently using the electric motor. Responders should
approach the vehicle from the sides and stay away from the front or rear as they are
both potential paths of travel. Instructions for immobilizing the vehicle are shown
below.
2. Immobilization / stabilization / lifting 3
5. Chock the Wheels.
2. Push “P” button on the shift
selector.
1. If the “P” button is not visible,
turn the crystal sphere.
3. Engage Parking Brake 4. Press the START/STOP Button.
Immobilize
* The actual image of vehicle may differ from the illustration
2. Immobilization / stabilization / lifting 4
Extrication Operations
The extrication operations for the Electrified GV60 are similar to a conventional
vehicle. However, first responders should pay special attention when they extract
occupants in the vehicle. Before extrication operations, the first responders should
carry out “Initial Response: Identify, Immobilize and Disable” procedure section in
page 5 to 8.
Vehicle Stabilization
Use standard stabilization (cribbing) points, as shown. Always be sure to connect
to a structural member of the vehicle and avoid placing cribbing under high
voltage cables, fuel lines and other areas not normally considered acceptable.
* The actual image of vehicle may differ from the illustration
The final step in the initial response process, conducted after immobilizing the
vehicle, is to disable the vehicle, its SRS components and the high voltage electrical
system. To prevent current flow through the system, use the following procedure to
disable the vehicle.
3.1 Disabling the System –Smart Key System and “POWER”
START/STOP Button
3. Disable direct hazards / safety regulations 5
1. Confirm the status of the READY light on the
instrument panel. If the READY light is
illuminated, the vehicle is ON.
a) If the READY light is NOT illuminated, the
vehicle is off. Do not push the “POWER”
START/STOP button because the vehicle may
start (go into READY mode). EV START / STOP Button
Pressing
POWER button
Button
Position/LED Vehicle condition
One time ACC/ON Electrical accessories are operational.
Two times ON/ON The warning lights can be checked before
the vehicle is started.
Three times OFF Off
While depressing the brake pedal
Pressing
POWER button
Button
Position/LED Vehicle condition
One time -Ready to drive
Without depressing the brake pedal
b) To turn OFF the system, press the 'P' button, and press the POWER button.
2. Before disconnecting the 12V battery,
remove the Smart Key at least 2 meters away
from the vehicle to prevent accidental restart.
3. Disable direct hazards / safety regulations 6
SMART KEY
If necessary, lower the windows, unlock the doors and open the tail gate as required,
before disconnecting the 12V battery. Once the 12V battery is disconnected, power
controls will not operate.
NOTICE
3. Follow the procedure below to disconnect the 12V auxiliary battery negative (-)
terminal to prevent accidental restart.
a
B. Remove the clip①and battery cover②.
A. Open the hood and front trunk.
C. Disconnect the 12V auxiliary battery
negative(-) terminal.
1
a) Remove the Junction block upper cover “A” in the PE (Power Electric) room,
located underneath the front hood.
4. Disconnect the High voltage cut-off switch.
3. Disable direct hazards / safety regulations 7
b) Disconnect the High voltage cut-off switch “B” as below.
①: Pull the cut-off switch → ②: Disconnected
B : Cut-off Switch
3. Disable direct hazards / safety regulations 8
•Before engaging in any emergency response procedures, ensure the vehicle is
disabled and wait 5 minutes to allow the capacitor in the high voltage system to
discharge to avoid electrocution.
•Exposed cables or wires may be visible inside or outside the vehicle. Never touch the
metal chassis wires, cables, connectors, or any electric components before disabling
the system, and/or shorted to the vehicle chassis.
Failure to follow these instructions will lead to serious bodily injury or death by
electrocution.
Electrocution Risk
Andere Handbücher für GV60
2
Inhaltsverzeichnis
Andere Genesis Automobil Handbücher
Genesis
Genesis G90 2020 Bedienungsanleitung
Genesis
Genesis G80 Bedienungsanleitung
Genesis
Genesis GV80 Bedienungsanleitung
Genesis
Genesis G70 2021 Bedienungsanleitung
Genesis
Genesis G90 Technisches Datenblatt
Genesis
Genesis GV70 Bedienungsanleitung
Genesis
Genesis G90 2019 Bedienungsanleitung
Genesis
Genesis G70 2022 Bedienungsanleitung
Genesis
Genesis G80 Bedienungsanleitung
Genesis
Genesis G80 2019 Bedienungsanleitung
Genesis
Genesis G80 Bedienungsanleitung
Genesis
Genesis GV80 Technisches Datenblatt
Genesis
Genesis GV60 2023 Bedienungsanleitung
Genesis
Genesis G90 2019 Bedienungsanleitung
Genesis
Genesis GV60 Bedienungsanleitung
Genesis
Genesis G90 2019 Bedienungsanleitung
Genesis
Genesis G70 Bedienungsanleitung
Genesis
Genesis G70 Bedienungsanleitung
Genesis
Genesis G80 2020 Bedienungsanleitung
Genesis
Genesis G80 2023 Bedienungsanleitung
