Getac T800 ANDROID Bedienungsanleitung
Using the T800 RFID and Smart Card
Reader
Introduction
This snap-on module is a 2-in-1 card reader that can read:
Smart cards
RFID (Radio-frequency identification) tags of 14443-A, 14443-B,
and 15693 types.
Hardware Installation
1. Align the module with the back of T800, engage the module’s
bottom tab first and then snap the top tab into place.
2. Firmly press the connector area to ensure the connection. The
module has an icon indicating where to press.
3. Tighten four screws.
Inserting Smart Cards
CAUTION: Do not insert smart cards
when the temperature of T800 is high.
1. Open the cover of the smart card
slot.
2. With the smart card’s chip facing the
module and pointing toward the slot,
insert the card into the slot until
reaching the end.
3. Close the cover.
Reading RFID Tags
You can use the Getac Smart Tag program to read UID numbers
from RFID tags. The program is provided on T800 Driver Disc for
you to install. See the program’s online help to know how to use
the program.
This icon on the module indicates where the RFID antenna is.
For optimal reading of RFID tags, position T800 appropriately.
561812210001 R01
Chip on the
other side
Andere Handbücher für T800 ANDROID
6
Inhaltsverzeichnis
Andere Getac Kartenleser Handbücher
Beliebte Kartenleser Handbücher anderer Marken
Rosslare
Rosslare DR-6255 Bedienungsanleitung
Lindy
Lindy 51541 Bedienungsanleitung
Diapro T?bbi Ürünler
Diapro T?bbi Ürünler Across System Bedienungsanleitung
Johnson Controls
Johnson Controls Kantech tyco ioSmart Bedienungsanleitung
ACS
ACS ACR122L Bedienungsanleitung
Secukey
Secukey S2-MF Bedienungsanleitung
