Art.-Nr.: 700 000/710 000/730 000/740 000/741000 GfS-Day Alarm
3
MA_GfS-Tagalarm_0515_GB
Disposal
Dispose an obselet GfS Exit Control at a a colleting point for electronic
waste or at your supplier.Dispose the packaging material at a paper collect-
ing point for paper resp.plastic.You may not dispose an obsolte device the
general garbage.
Warranty
Within the legal warrenty time we intend to repair all defect devices,
whether the defect is caused by the material or assembly, or replace them.
The warenty expires after a third-party repair.
Conformity
This product complies with the essential requirements of the R&TTE guide-
line 1999/5/EG.The certificate of conformity you may request from your
supplier.
Service
In case of a system failure or a defect GfS Door Terminal please contact the
following address:
Activation
Insert key and turn clock-wise as far as it will go. The green LED lights up.
Now turn the key anticlockwise and remove it. Open the door briefly and
close it again. The red LED shines, the unit is armed.
Unauthorized use
If the door is opened, the reed contact will send a signal which is received
by the GfS Day Alarm. The red LED flashes and a visual and an accoustic
alarm is triggered. The GfS Day Alarm LC has no flash-light.
Reset GfS Day Alarm
Insert the key into the integrated cylinder and turn it clockwise as far as it
will go. Turn key anticlockwise and remove it. The alarm expires and the
LED shines green. Close the door or if it is closed already wait for 15 sec-
onds. The LED shines red and the GfS Day Alarm unit is activated again.
Authorized passage
Insert the key and turn it to the right.
The green LED lights up. Turn the key to the middle position and remove it.
Open the door and walk through. Close the door again. The red LED shines
and the the GfS Day Alarm is activated again. In case that nobody walks
through the door the green LED shines for approx. 15 sec and changes then
to red. The GfS Day Alarm is activated again.
The LED of the battery operated versions of the GfS Day Alarm (GfS Art.No.
710.000 and 741.000) expires after 10 sec. and the GfS Day Alarm is acti-
vated again.
The door is open
If the door is not closed properly after authorized use, an accoustic signal
is audible after 15 seconds of opening time and the green LED flashes. As
soon as the door is closed, the red LED shines, the accoustic alarm stops
and the units alarm function is activated.
Permanent opening
Insert the key and turn clockwise as far as it will go. The green LED is
switched on. Leave in this postion until the LED switches o. After that turn
key anticlock and remove. Now the door can be freely used without trigger-
ing the alarm. The green LED flashes, which signals “door permanently
open”. To switch the alarm on, turn key clockwise as far as it will go. The
green LED shines. Now turn key anticlockwise and remove. Close the door
or if the door is closed already, wait 15 seconds. Now the LED shines red
and the system is armed.
Start-up after power failure
After the power failure, the GfS Day Alarm unit switches on and an alarm
sound is emitted. This is to draw the attention of the provider of the system
to the fact that the supervision of the door was interupted and the door
might still be open!
To switch o the alarm, turn key clockwise as far as it will go. The LED is
green and the alarm switches o. Now turn key anticlockwise and remove.
Open the door once and close it again. The LED switches to red and the unit
is armed.If the door was in the “permanently open position” before the
power failure, it will remain in this mode.
FUNCTIONS
