Gilson HM-65 Bedienungsanleitung

7. Report the results as the dierential between K and W, i.e.,

(e.g., K3.0 - W2.5 = 0.5).

8. Wash the tester with water.

9. The rst reading is approximately equivalent to the actual

ordinary slump, while the second reading (W) is a measure

of workability and compaction. The greater the value (W) is,

the better the workability and compaction of the concrete

will be.The dierential between K and W should NOT exceed

2.0 so as to minimize segregation.

10. The tester can be inserted in a compacted 6x12in (15x30cm)

cylinder, in buckets, wheelbarrows, ready-mix truck chutes,

slabs, columns, beams and any other desired location where

the fresh concrete is placed. Make sure there is a minimum of

6in (15cm) of concrete around the tester and that the oater

rests freely on the surface of the concrete. When the tester is

used in buckets, wheelbarrows and ready-mix truck chutes,

tamping gives a more uniform result.

11. If a tester is used ina standardcylinder,tap the cylinder lightly

(about 20 times) with the compacting rod or the tester to

close the hole that was left in the concrete upon removal

of the tester. The strength of the cylinder will be altered by

about 2% only.

OPERATING INSTRUCTIONS

1. Wet the tester with water and shake o the excess.

2. Raise the measuring rod, tilt slightly and let it rest on the pin

located inside the tester.

3. Level the surface of the concrete and insert the tester verti-

cally down until the disc oater rests at the surface of the

concrete.

NOTE: DONOTrotatethetesterwhile insertingorremov-

ing it from the concrete.

4. After 60 seconds, lower the measuring rod slowly until it rests

on the surface of the concrete that entered the tube and read

the“K-Slump”directly on the scale of the measuring rod.This

is the “K” value.

5. Raise the measuring rod AGAIN and let it rest on its pin.

6. Remove the tester from the concrete vertically up, and AGAIN

lower the measuring rod slowly until it touches the surface

of the concrete retained in the tube and read the workability

directly on the scale of the measuring rod.This is the“W”value.

HM-65

(Continued on back.)

“K-Slump”Tester

HM-65

OPERATING MANUAL

Rev: 01/2019

PHONE: 800-444-1508 P.O. Box 200, Lewis Center, Ohio 43035-0200

740-548-7298 E-mail: customerservice@gilsonco.com Product Web Page: www.globalgilson.com

FAX: 800-255-5314

740-548-5314

Inhaltsverzeichnis

Andere Gilson Prüfgeräte Handbücher

Gilson

Gilson TS-2 Bedienungsanleitung

Gilson

Gilson MS-398 Bedienungsanleitung

Gilson

Gilson Aqua-Check MA-26X Bedienungsanleitung

Gilson

Gilson Gilson Test-Master TM-6 Bedienungsanleitung

Gilson

Gilson HM-397 Bedienungsanleitung

Gilson

Gilson Aqua-Check MA-26X Bedienungsanleitung

Gilson

Gilson MC-250CS Bedienungsanleitung

Gilson

Gilson HM-353 Bedienungsanleitung

Gilson

Gilson HM-399 Bedienungsanleitung

Gilson

Gilson ASTM D4791 Bedienungsanleitung

Gilson

Gilson Pipetman Fixed Bedienungsanleitung

Gilson

Gilson SS-18 Bedienungsanleitung

Gilson

Gilson TS-1 Bedienungsanleitung

Gilson

Gilson HM-397B Bedienungsanleitung

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Vernier

Vernier Go Direct Voltage Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung