Engine Run Procedure 10
•Ensure car is sat on High stands or Air jack safeties. Skates as a minimum (Not hub stands, wheels or Air jacks)
•Install run up hubs. Rear wheels as a minimum
•Check engine coolant level
•Ensure water header tank, engine oil and engine oil catch tank caps are installed
•Turn master switch on
•Plug in jump battery
•ABS to position 12, TC to position 0
•Cycle through to main dash warm up page
•Crank for oil pressure (No ignition)
•Ignition on (Check for fuel pressure)
•Crank for engine start
•Let engine idle and systematically check the following systems for leaks: Fuel, Engine oil, Engine coolant, Transmission oil
•Run engine until engine oil temp reaches 75°C (+/- 5°C)
•Water radiator fans will turn on at 90 °C coolant temp, and turn off at 85 °C (Fans will not run when wheels are rotating)
•Hold engine speed at 4000 rpm for 10 seconds
•Kill engine using “STOP” button
•Measure engine oil level as quickly as possible
•Adjust the oil level and re-fit cap (Repeat oil dip procedure if required)
•“START” car and let the engine idle for 10 seconds
•Shift through all forward gears
•Hold 6th to build gearbox temperature (Ensure not to exceed 93-95 °C coolant temperature)
•Shift back to neutral
•Kill engine using “STOP” button
•Leave master switch on for 1-2 mins after engine stop. (Keeps water pumps running to prevent internal hot/cold spots)
