Gioteck VX-1 Technisches Datenblatt
12
3
45 6
VX-1 QUICK SETUP
1. Connect the VX-1 to your console via its charging lead.
2.Insert the usb dongle into a usb port on the console.
3. The LED on the dongle will flash quickly (slow flashing is
receiving mode not pairing mode).
4. Immediately press the home button on your controller.
5. All the LEDs on the controller will flash, and aer a short
time one (or two) will remain solid.
6. Immediately disconnect the charging lead from the
controller and the LEDs will flash again.
7. Repeat steps 4 & 5. (Sometimes pushing the home button
again will speed up this process. If the controller fails
to respond, repeat the process but make sure that you
disconnect the dongle and reinsert.)
8. To add multiple controllers (up to 7) or assign your
controller to a dierent port go to:
Accessory settings > Reassign controller.
Important Notices:
•Make sure that the battery is fully charged before
first use.
•For the first few weeks your controller may need more
frequent and longer periods on charge.
•Use of the vibration feature will shorten the gaming time.
•Resetting your controller
If your controller loses connection with its dongle and
will not pair, take a small pointed object and insert it
into the hole found on the back of the controller.
Pushing down on the button inside will reset the
controller. Remove the dongle from the PS3 and switch
o the console, remove the PS3’s power cord from the
electrical socket, wait 15 seconds then plug in and turn
on the console. Then follow the pairing instructions.
RESET
Inhaltsverzeichnis
Andere Gioteck Spielkonsole Handbücher
