3—General Information
Only use filtered water in this appliance.
Unpack the appliance carefully and retain the packaging for possible future use, in the event of moving or returning
the fire to your supplier.
Always ensure that the appliance is sitting on a level surface.
The appliance is a flame effect only.
The appliance is designed to be built into a surround or built into a wall.
Before connecting the appliance, check that the supply voltage is the same as that stated on the appliance.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is
related to the operation of the flame effect. This is normal and should not be a cause for concern.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.
The water tank, sump, sump lid, tank cap and air filters must be cleaned once every two weeks, particularly in hard
water areas.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and dry the
sump.
The sump and the water tank in this product are treated with a biocidal product, Silver Biocide. This conforms with the
latest relevant ISO standard.
Do not drink the water from the sump or from the water tank(s).
This appliance is intended to be permanently connected to the water mains and not connected by a hose-set.
4—Installation Instructions
This section describes how to set up your fire.
4.1—Before You Start
1. Ensure that all packing items are removed (read any warning labels carefully) and retain all packing for possible
future use .
2. Before connecting to the mains supply, check that the supply voltage is the same as that stated on the appliance
and assemble all supplied components (Water tank, control panel, etc.).
3. Ensure that the appliance is sitting on a level surface
4. Lift off the metal top plate to gain access to the appliance. Keep the top plate with the packing for possible future
use. (Fig.2)
4.2—Installation
This product can be built into a wall, surround or structure. Please take note of the product dimensions in Fig.1 and
build your wall, surround or structure accordingly. You are required to leave a minimum of 400mm from the base of
the fuelbed to any shelf/enclosure above the product. This will allow enough space above the product to allow the
flames to form fully and not to be obstructed.
This product needs free ventilation from underneath to operate correctly. The free ventilation helps keep the elec-
tronic components cool, allow the mist to evacuate the sump and lift out of the product effortlessly.
THE AREA OF FREE VENTILATION THE KIT GLAMM 3D PLUS500 REQUIRES IS A MINIMUM OF
210CM2.
THE AREA OF FREE VENTILATION THE KIT GLAMM 3D PLUS1000 REQUIRES IS A MINIMUM OF
420CM2.
SEE Fig 14 AND Fig 15 FOR EXAMPLES OF THE REQUIRED VENTILLATION.
