Safety Instructions
Please observe the following safety instructions to avoid personal injury and property loss.
1) Do not operate any air scrubber with a damaged cord or Plug.
2) Do not move or adjust air scrubber while in operation
3) Keep this unit out of the reach of children
4) Do not alter or modify your air scrubber in any way. Only authorized Global Industrial replacement parts can
be used. Use of any unauthorized parts could cause hazards and void the unit’s warranty
5) Always store unit in a clean, dry environment when not in use. Care should be taken to prevent water from
entering the unit’s motor. In the case that the unit’s motor does become wet, ensure that the motor is dried
thoroughly before use.
6) Do not allow water near or inside the unit while in use to avoid risk of electric shock. Handle unit with care to
avoid causing damage or personal injury.
7) Always operate the air scrubber on a flat, level surface. Operating the unit where it could slip or fall increases
the risk of injury, fire, or electrical shock.
8) Never operate the air scrubber without the factory-installed safety screens in place. This will prevent liquids,
gases, and other materials from entering the air scrubber.
9) Do not use air scrubber near combustible gas or flammable materials in order to avoid fire or electrical
hazards.
10) Do not attempt to disassemble or repair unit on your own. Instead, bring to the attention of your distributor or
a certified repair center. Never attempt to disassemble or repair unit while air scrubber is plugged in.
11) Prior to use, ensure the air intake and outlet are free of obstructions to prevent the air scrubber from
overheating and causing a shock or fire hazard.
12)
Operating Procedures
The Global Industrial Air Scrubber is a portable filtration system that removes airborne particles including mold,
pet dander, dust, pollen, drywall dust, and other miscellaneous debris as small as 0.3 microns. The air scrubber
utilizes up to 4 stages of filtration including a Pre-pad filter, a pre-filter, optional 2nd stage, and a HEPA filter. The
air scrubber will create cleaner air in any environment. The pre-pad filter and pre filter capture larger particles and
the HEPA filter captures smaller particles.
1) Ensure that the unit is on a stable, level surface, and remains stationary while in use.
2) Plug the air scrubber into a grounded outlet with the correct voltage(115v) and amperage. Ensure that the
unit is plugged into a grounded outlet with voltage and wattage outputs that correspond with the unit’s
specifications. For maximum protection against electrical shock, ALWAYS use a circuit that is protected by a
ground fault circuit interrupter. If you are unsure about the outlet, check with a qualified electrician.
Controls
The air scrubber equip the 1 speed light led switch
Control fan by press the switch knob
OFF-Turn off the air scrubber
ON- Turn on the air scrubber
The air scrubber equip the Circuit breaker to protect the
Motor not over load. To reset, unplug the appliance
Causing the breaker to trip and push the reset buttom.
