1514
I. Easy Manual Mode: Ice Cubes Now!
1. Fill the Interior Water Reservoir with tap water to the Maximum Fill Line.
2. Place the Ice Cube Basket over the Interior Water Reservoir.
3. Plug in the Ice Machine Plus Housing plug to the outlet.
4. Press the Snowake button. The snowake icon on the LCD display should
start blinking, indicating that the unit is in Active mode.
II. Easy Automatic Mode: Pre-set Ice Cube Making
NOTE: The Ice Machine Plus runs on the“24 hour clock”or, as is commonly known,
“military time.” Hours after 12:00 pm increase to 13:00pm, 14:00pm, etc. up to 24:00pm.
At that time, the time begins again at 1:00am, 2:00am, etc.
1. Set the current hour. Press the SET button. The preset hour will ash. Press the ₳
button to set the current hour to start.
2. Set the current minutes. Press the SET button. The preset minutes will ash. Press
the ₳button to set the current minutes to start.
3. Set the Auto Start Time:
a. Press the SET button three (3) times. The hour will ash. Press the ₳button to set
the hour.
b. Press the SET button once. The minutes will ash. Press the ₳ button to set the
minutes.
4. Set the Auto Stop Time:
a. Press the SET button ve (5) times. The hour will ash. Press the ₳button to set the
hour.
b. Press the SET button once. The minutes will ash. Press the ₳button to set
the minutes.
5. Activate the timers for Easy Automatic Mode:
a. Press the A button once to activate the‘ON’timer (auto start). The‘ON’
clock icon will appear, indicating that the ‘ON’timer (auto start) is active.
Note: At this point, the‘o’ timer will not be active. Once turned on, the unit
will remain on until manually turned o.
b. Press the A button once again to activate the ‘OFF’ timer (auto stop). The
‘OFF’clock icon will appear, indicating that the ‘OFF’ timer (auto stop) is
active. Note: At this point, the‘on’ timer will not be active. Once turned o,
the unit will remain o until manually turned on.
c. Press the A button once again to activate both the‘ON’and the ‘OFF’ timer
(auto start and auto stop). Both the ‘ON’ and the ‘OFF’clock icons will appear,
indicating that the ‘ON’ and the ‘OFF’timers (auto start and auto stop) are
active.
III. Easy Self-Clean Mode
The Self-Clean Mode should be used before rst use or if there has been
a long period of time between uses. The three (3) ice cube size icons will
continuously display while the Self-Clean Mode is in use.
1. Add equal parts water and vinegar (1:1) to the Interior Water Reservoir.
Enough water and vinegar should be used to ll the reservoir at least
halfway.
2. Plug in the Ice Machine Plus. Press the Snowake icon on the panel for at
least 5 seconds to activate the Self-Clean mode. After the beep sound, the
mode will activate.
3. After the water is rinsed several times through the machine, the mode
will stop and the Ice Machine Plus will indicate Stand-by.
4. Drain the Interior Water Reservoir. Rell with water to the Maximum Fill
Line. Press the Snowake icon for at least 5 seconds to again activate
the Self-Clean mode. When done, press O and drain the reservoir
again. Dry before use.
Note: If the water falls below the Minimum Fill Line during cleaning, the Ц
button will light up. Hold the Snowake button for 5 seconds to stop the Auto-
Clean Mode.
I. Easy Manual Mode: Ice Cubes Now!
II. Easy Automatic Mode: Pre-set Ice Cube Making
III. Easy Self-Clean Mode
STEP BY STEP INSTRUCTIONS
