Page 3Light Bar 5 Assembly Instrucons
NOTE: The light bar has four height
sengs. The image above shows the
light bar in its highest seng. The highest
seng is approximately 81 inches high
from the center top of the light bar to
the oor; the other sengs are about
77 inches, 73 inches and 69 inches at
the lowest seng.
Step 1: Place six screws (item 5) through a clamp
plate (item 2). Place the plate on a work
surface such as a table or oor, with the
screws poinng up (as shown).
Step 2: Place one vercal leg boom (item 3)
over the center two screws in the plate
as shown.
NOTE: The screws go all the way through
the leg parts.
Step 3: Place one curved leg (item 4) over the
two right screws in the plate as shown.
ITEM PART # DESCRIPTION QTY
1 HG01100-100 NUT, M6 LOCKNUT CLASS 8 12
2 HG01100-602 CLAMP PLATE, LIGHT BAR 4
3 HG01100-603 VERTICAL LEG BOTTOM, LIGHT BAR 2
4 HG01100-601 CURVED LEG, LIGHT BAR 4
5 HG01100-101 SCREW, M6 X 50 SKB ZN 12
6 HG01100-609 END PLUG-LIGHT BAR (pre-assembled) 8
7 HG01100-610 BUMPER FOOT-LIGHT BAR (pre-assembled) 4
6
4
5
3
2
1
7
Secon 1: Lower Leg Assembly
Step 4: Place one curved leg (item 4) over the
two le screws in the plate as shown.
Step 5: Place one clamp plate over the legs
and screws.
Step 6: Start a locknut (item 1) onto each screw.
Step 7: Orient the leg to access the screw heads
and lock-nuts.
Step 8: Push the two curved legs ght against
the vercal leg boom, hold the lock
nut with the 10mm wrench provided. To
help prevent paint damage, ghten the
screws rmly using the 4mm hex tool
while holding the 10mm wrench rmly
in place.
Step 9: Repeat steps 1-7 to make a second lower
leg assembly.
These two holes do
not go all the way
through the leg.
Place this side down
against the work surface for
assembly, as shown in the
rst diagram at the le.
