Graco 240054 Bedienungsanleitung

308830E

First choice when

quality counts.t

INSTRUCTIONS-PARTS LIST

Important Safety Instructions

DRead all warnings and instructions in this

manual. Save these instructions.

Frame, Roller

5000 psi (345 bar, 34.5 MPa) Maximum Working Pressure

Model 240054, Series A

3 in. (7.6 cm) length

Model 240055, Series A

12 in. (30.5 cm) length

Model 240005, Series A

9 in. (22.9 cm) length

Pressure Relief Procedure

WARNING

IN INJECTION HAZARD

The system pressure must be manually

relieved to prevent the system from

starting or spraying accidentally. Fluid

under high pressure can be injected through the

skin and cause serious injury. To reduce the risk of

an injury from injection, splashing fluid, or moving

parts, follow the Pressure Relief Procedure

whenever you:

Dareinstructedtorelievethepressure,

Dstop spraying,

Dcheck or service any of the system equipment,

Dinstall or clean the frame.

1. Lock the gun safety latch.

2. Shut off the power supply to the pump and open

any air bleed valves in the system.

3. Unlock the gun safety latch.

4. Hold a metal part of the gun firmly to the side of a

grounded metal waste container, and trigger the

gun to relieve pressure.

5. Lock the gun safety latch.

6. Open the pump drain valve to help relieve fluid

pressure in the pump, hose and gun. Triggering

the gun to relieve pressure may not be sufficient.

Have a container ready to catch the drainage.

7. Leave the drain valve open until you are ready to

spray again.

If you suspect that the frame or hose is completely

clogged or that pressure has not been fully relieved

after following the steps above, VERY SLOWLY

loosen the tip retaining nut or hose end coupling and

relieve pressure gradually, then loosen completely.

Now clear the frame or hose obstruction.

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440--1441

http://www.graco.com

Graco Inc. is registered to I.S. EN ISO 9001

7927A

2 308830

Installation

WARNING

Refer to your sprayer and spray gun manuals for

appropriate warnings and instructions for safe op-

eration of this roller frame.

Gasket (7) must be in place before installing frame

(1). If gasket is not in place there is a potential in-

jection hazard which could result in serious injury.

1. Follow Pressure Relief Procedure on page 1.

2. Prime pump.

3. Install roller frame.

Parts

Ref

No. Part No. Description Qty

1 FRAME, roller

220235 Model 240054, 3 in. (7.6 cm) 1

218582 Model 240005, 9 in. (22.9 cm) 1

224378 Model 240055, 12 in. (30.5 cm) 1

2 183420 NUT, retainer, diffuser 1

3 108808 PACKING, u-cup 1

4 DIFFUSER, roller

220233 Model 240054, 3 in. (7.6 cm) 1

218934 Model 240005, 9 in. (22.9 cm) 1

224377 Model 240055, 12 in. (30.5 cm) 1

5 101983 SCREW, set 1

6 192638 FITTING, swivel 1

7 15H622 GASKET, non-metallic 1

9 192637 NUT, retaining, 7/8--14 (f) 1

Wetted Parts: fluoroelastomer, nylon, plated........

steel polyethylene, acetal

Lips of u-cup face

roller diffuser (4)

7926b

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

This manual contains English. MM 308830

Graco Headquarters: Minneapolis

International Offices: Belgium, Korea, China, Japan

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440--1441

http://www.graco.com

12/97, Revised 08/2009

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Graco Spritzpistole Handbücher

Graco

Graco ASM Zip Spray 3400G Gebrauchs- und Pflegehandbuch

Graco

Graco Magnum TexFinish 246186 Bedienungsanleitung

Graco

Graco GMAX 258731 Bedienungsanleitung

Graco

Graco FinishPro 290 Bedienungsanleitung

Graco

Graco 330GS Bedienungsanleitung

Graco

Graco 310645K Gebrauchs- und Pflegehandbuch

Graco

Graco FLEX A Series Bedienungsanleitung

Graco

Graco GX-8 Kurzanleitung

Graco

Graco UNICARB Pro AA4500 Bedienungsanleitung

Graco

Graco ProComp HVLP 3800 Bedienungsanleitung

Graco

Graco UNICARB Pro AA4500 Bedienungsanleitung

Graco

Graco GMAX II 3900 Premium Betriebsanleitung

Graco

Graco SG2 Bedienungsanleitung

Graco

Graco HydroShield WMBL00 Stücklistenhandbuch

Graco

Graco TexSpray RTX 750 Bedienungsanleitung

Graco

Graco Optimiser 2K Bedienungsanleitung

Graco

Graco QuickShot 20B473 Betriebsanleitung

Graco

Graco Series E Bedienungsanleitung

Graco

Graco GH 130 Bedienungsanleitung

Graco

Graco 223963 Bedienungsanleitung

Graco

Graco Series D Leitfaden

Graco

Graco Ultra Max II 695 Bedienungsanleitung

Graco

Graco 310820E Bedienungsanleitung

Graco

Graco 239-766 Bedienungsanleitung

Beliebte Spritzpistole Handbücher anderer Marken

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Bedienungsanleitung

Binks

Binks SV100 Bedienungsanleitung

Fimco

Fimco LG-4-3-1 Bedienungsanleitung

AG SPRAY

AG SPRAY FS-ATV-25BL Bedienungsanleitung

Nordson

Nordson MicroMax 2 Bedienungsanleitung

Bonide

Bonide 051 Bedienungsanleitung

zogics

zogics Z-DAS Bedienungsanleitung

KISANKRAFT

KISANKRAFT KK-KBS-165 Bedienungsanleitung

Matrix

Matrix SG 650 Bedienungsanleitung

Anest Iwata

Anest Iwata SGA-3 Kurzanleitung

paasche

paasche VV Datenblatt

Carlisle

Carlisle DeVilbiss JGA-510 Bedienungsanleitung

Gardena

Gardena 11120 Bedienungsanleitung

Conrad

Conrad Hobby Airbrush K3 Bedienungsanleitung

wiwa

wiwa 14025 R/F Bedienungsanleitung

DeVilbiss

DeVilbiss LUNA2i Bedienungsanleitung

WAGNER

WAGNER W 125 Bedienungsanleitung

My Clean Buddy

My Clean Buddy PW018 Bedienungsanleitung