Graco HVLP 2500 Handbuch

www.graco.be

HVLP 2500/3800/4900

Quick Operator’s Guide

SETUP

This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing

fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.

* check the Graco operations manual delivered with the unit for more details.

WARNING

Remove cup. Fill 3/4 full. DO NOT

OVERFILL. Reattach and latch cup.

Turn fluid control out until trigger movement is not restricted.

Caution: Turning knob too far will remove it.

Connect air hose to gun and turbine.

CHOOSE THE RIGHT FLUID NOZZLE

For low flow rates or light

viscosity fluid, select smaller

nozzle sizes.

For high flow rates or high

viscosity fluid, select larger

nozzle sizes.

Installing the Fluid Set

Use your hand to loosen and remove the air cap retaining (A) and the air cap

housing (B).

While triggering the gun, use your hand to loosen and remove the nozzle (C)

from the gun.

Use your hand to loosen and remove the fluid knob assembly (D) and com-

pression spring (E) from back of gun and remove the old needle.

Insert the needle assembly (F) into the back of the gun. Replace the nozzle

(E,D) air cap housing (C,B,A) and air cap retaining ring and tighten by hand.

NOTE: O-ring (G) should always be on the nozzle.

Material

Part Number

Orifice Size

Fluid Set #2 Fluid Set #3 Fluid Set #4 Fluid Set #5 Fluid Set #6 Turbine Unit

244123 244124 244125 244126 244127

0.032 0.051 0.071 0.087 0.098

Dye

Ink 2500

Non-Wiping Stain

Automotive Finish

Lacquer

Stain

Enamel 3800

Epoxy

Urethane

Varnish

Primer

Industrial Finishers

Latex

Multi-Spec

Butyrate 4900

Nitrate Dope

Oil Wall Paint

NOTE: read gun manual for paint reduction recommendations.

SPRAYING

Plug turbine power cord into

a grounded outlet.

GRACO N.V. • Industrieterrein Oude Bunders

Slakweidestraat 31 • B-3630 Maasmechelen

Tel. (32) 89 770 700 • Fax (32) 89 770 777 All information, illustrations, and specifications in this document are based on the latest product information

available at the time of publication. The right is reserved to make changes at any time without notice.

Graco Inc. is registered to I.S. EN ISO 9001.

Open air control valve.

Turn air cap to obtain

desired direction. Lock air cap with retaining ring.

Turn turbine on.

Wait several minutes

prior to spraying to

allow warm-up time.

Nozzle

Air Cap

Air Control

Pattern Selection

Knob

Fluid Knob

Retaining Ring

SHUTDOWN

Turn off turbine. Unlatch cup.

CLEANING

Disassemble gun from cup and clean all parts with water.

Round Pattern

Set knob to RND Vertical or horizontal Pattern

Set knob to FAN

Select spray pattern by adjusting the fluid knob

and pattern selection knob. The air control

adjusts the TOTAL air to the pattern and gun.

Hold gun perpendicular, 6-8 inches

from surface. Move gun first, then

pull gun trigger to spray.

To control over-

spray, reduce

air flow or

reduce fluid

volume.

NOTE: If fluid is

not atomizing

properly, fluid

may need to be thinned further, or

a different tip size may be used.

Andere Handbücher für HVLP 2500

Dieses Handbuch passt für folgende Modelle

Andere Graco Spritzpistole Handbücher

Graco

Graco 238256 Bedienungsanleitung

Graco

Graco Switch 3D Gun Stücklistenhandbuch

Graco

Graco AKA 420 Bedienungsanleitung

Graco

Graco GM 1030 TexSpray Bedienungsanleitung

Graco

Graco PRO 309294G Bedienungsanleitung

Graco

Graco REACTOR 246033 Bedienungsanleitung

Graco

Graco EM 380 Bedienungsanleitung

Graco

Graco 238338 Bedienungsanleitung

Graco

Graco Wall Mount Series Datenblatt

Graco

Graco AllControl 288711 Bedienungsanleitung

Graco

Graco 310645H Gebrauchs- und Pflegehandbuch

Graco

Graco Project Painter Plus Bedienungsanleitung

Graco

Graco RS Betriebsanleitung

Graco

Graco C Series Bedienungsanleitung

Graco

Graco Reactor H-40 Elite Bedienungsanleitung

Graco

Graco 965022 Bedienungsanleitung

Graco

Graco XP-hf 572407 Bedienungsanleitung

Graco

Graco GM 3500 Bedienungsanleitung

Graco

Graco GX21 Cordless Leitfaden

Graco

Graco 296984 Bedienungsanleitung

Graco

Graco EcoQuip 2 EQs Bedienungsanleitung

Graco

Graco Reactor 2 H-30 Gebrauchs- und Pflegehandbuch

Graco

Graco Series A Stücklistenhandbuch

Graco

Graco 262927 Bedienungsanleitung

Beliebte Spritzpistole Handbücher anderer Marken

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Bedienungsanleitung

Binks

Binks SV100 Bedienungsanleitung

Fimco

Fimco LG-4-3-1 Bedienungsanleitung

AG SPRAY

AG SPRAY FS-ATV-25BL Bedienungsanleitung

Nordson

Nordson MicroMax 2 Bedienungsanleitung

Bonide

Bonide 051 Bedienungsanleitung

zogics

zogics Z-DAS Bedienungsanleitung

KISANKRAFT

KISANKRAFT KK-KBS-165 Bedienungsanleitung

Matrix

Matrix SG 650 Bedienungsanleitung

Anest Iwata

Anest Iwata SGA-3 Kurzanleitung

paasche

paasche VV Datenblatt

Carlisle

Carlisle DeVilbiss JGA-510 Bedienungsanleitung

Gardena

Gardena 11120 Bedienungsanleitung

Conrad

Conrad Hobby Airbrush K3 Bedienungsanleitung

wiwa

wiwa 14025 R/F Bedienungsanleitung

DeVilbiss

DeVilbiss LUNA2i Bedienungsanleitung

WAGNER

WAGNER W 125 Bedienungsanleitung

My Clean Buddy

My Clean Buddy PW018 Bedienungsanleitung