Graco RTX 1500 Bedienungsanleitung

310694C

Instructions

RTX 1500 Auxiliary Air Kit

Model 287328

• Allows use of external air supply for greater air atomization at spray gun

• Bypasses RTX internal air supply

• Requires air supply minimum of 10 cfm @ 100 psi

Patent Pending

125 psi (0.7 MPa, 6.9 bar) Maximum Working Pressure

Important Safety Instructions

Read all warnings and instructions in the RTX

Sprayer operation manual. Save these instructions.

CAUTION

• Connecting external air supply in any manner other

than following these instructions can damage sprayer.

• Use clean, regulated external air supply.

ti12373a

Installation and Operation

2310694C

Installation and Operation

Installation

1. Remove hopper and front shroud (see manual

310645).

2. Install valve.

3. Push fitting ring (A) and disconnect air line (B).

4. Cut off 2 in. of air line (B) to avoid contact with

moving parts.

5. Align elbow fitting (3) with hole on sprayer frame and

mount auxiliary air kit underneath sprayer frame.

Tighten two screws (18) to secure in place.

6. Connect air line (B) to TEE connector (16) and air

compressor. Connect line (M) to elbow fitting (K)

and TEE connector (16).

7. Install front shroud and hopper.

Installation and Operation

310694C 3

Operation

1. Connect external air supply (C) to male air fitting

valve (D).

2. Connect spray gun air line (E) to valve (F).

3. Open spray gun air valve (G) all the way.

4. Pull spray gun trigger and adjust air flow with air

pressure regulator (H) (not supplied by Graco) on

external air supply.

5. Use spray gun air valve (G) for fine adjustment.

ti4962b

Air Flow (cfm) Operating Range at gun

Connection J 1 - 6 cfm

(no additional air required)

Connection F 5 - 20 cfm

(requirement external air supply)

Air Vent

Troubleshooting

4310694C

Troubleshooting

Maintenance:

Clean valve inlet every 100 hours:

1. Remove fitting (8) and piston valve (11).

2. Rinse out valve (10) with warm water.

3. Install piston valve (11) and fitting (8); hand tighten.

PROBLEM CAUSE SOLUTION

Sprayer will not pump

material

Gun air valve (G) not open completely 1. Open gun air valve (G).

2. Regulate air flow with air regulator.

Dirty external air supply See Maintenance.

See Manual 310645 for further troubleshooting Determine cause.

Sprayer will not stop

pumping material

Spray gun or air line leaking air when gun trig-

ger is closed

Repair leak.

Air is venting when spray gun is shut off

See Maintenance.

Not enough atomization

air at spray gun

Compressor not large enough for intended use 1. Open gun air valve (G).

2. Regulate air flow with air regulator (H).

Plugged gun, air line or valve Repair or clean as needed.

Material not appropriate for system Review material specifications.

Air lines not properly connected Connect air lines as shown on page 2.

ti4964b Air Vent

Parts

310694C 5

Parts

ti5111b

610

Ref. Part Description Qty.

1 100175 COUPLING, pipe 1

2 110249 ADAPTER, male elbow, 90 degree 1

3 113321 FITTING, elbow tube 1

4 116720 COUPLER, quick-disconnect 1

5 115524 GASKET 1

6 119362 FITTING, bushing 1

7 119373 SPRING, compression 1

8 15E090 FITTING, quick-disconnect, male 1

9 15E127 NEEDLE, valve 1

10 15E128 VALVE 1

11 15E129 PISTON, valve 1

12 238341 NUT, seal 1

15 110782 o-ring 1

16 15E510 TEE, with air lines 1

17 100016 WASHER, lock 2

18 100270 SCREW, cap, hex hd 2

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

This manual contains English. MM 310694

Graco Headquarters: Minneapolis

International Offices: Belgium, China, Japan, Korea

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441

www.graco.com

Revised 05/2008

Andere Handbücher für RTX 1500

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Graco Spritzpistole Handbücher

Graco

Graco Fusion CS Series Bedienungsanleitung

Graco

Graco HydraMax 225 Betriebsanleitung

Graco

Graco 207947 Bedienungsanleitung

Graco

Graco FinishPro 311911C Betriebsanleitung

Graco

Graco 256391 Montageanleitung

Graco

Graco Wall Mount Series Datenblatt

Graco

Graco SG3 Series Bedienungsanleitung

Graco

Graco King 96A388 Bedienungsanleitung

Graco

Graco LINE LAZER A Series Datenblatt

Graco

Graco MAGNUM TRUEAIRLESS DIY Series Bedienungsanleitung

Graco

Graco 3A0149C Datenblatt

Graco

Graco Merkur 313255F Bedienungsanleitung

Graco

Graco AirPro 237409 Datenblatt

Graco

Graco Line Lazer 3500 Bedienungsanleitung

Graco

Graco Mark X 240 Volt Bedienungsanleitung

Graco

Graco HYDRA-CLEAN C Series Bedienungsanleitung

Graco

Graco ULTRA 500 231-032 Bedienungsanleitung

Graco

Graco HydroShield Bedienungsanleitung

Graco

Graco 960P Bedienungsanleitung

Graco

Graco 309092 Bedienungsanleitung

Graco

Graco BLACK MAX Bedienungsanleitung

Graco

Graco FT500 Gebrauchs- und Pflegehandbuch

Graco

Graco GM 1030 Bedienungsanleitung

Graco

Graco 309740 Bedienungsanleitung

Beliebte Spritzpistole Handbücher anderer Marken

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Bedienungsanleitung

Binks

Binks SV100 Bedienungsanleitung

Fimco

Fimco LG-4-3-1 Bedienungsanleitung

AG SPRAY

AG SPRAY FS-ATV-25BL Bedienungsanleitung

Nordson

Nordson MicroMax 2 Bedienungsanleitung

Bonide

Bonide 051 Bedienungsanleitung

zogics

zogics Z-DAS Bedienungsanleitung

KISANKRAFT

KISANKRAFT KK-KBS-165 Bedienungsanleitung

Matrix

Matrix SG 650 Bedienungsanleitung

Anest Iwata

Anest Iwata SGA-3 Kurzanleitung

paasche

paasche VV Datenblatt

Carlisle

Carlisle DeVilbiss JGA-510 Bedienungsanleitung

Gardena

Gardena 11120 Bedienungsanleitung

Conrad

Conrad Hobby Airbrush K3 Bedienungsanleitung

wiwa

wiwa 14025 R/F Bedienungsanleitung

DeVilbiss

DeVilbiss LUNA2i Bedienungsanleitung

WAGNER

WAGNER W 125 Bedienungsanleitung

My Clean Buddy

My Clean Buddy PW018 Bedienungsanleitung