Please read and understand instructions before attempting installation
Grifco Elite Users Manual
6
DIP SWITCH SETTINGS
Setting the expansion boards behaviour is done by adjusting 16 dipswitches located on it (refer page 5-K8). To adjust the
expansion boards settings follow the table below.
EB setting Dipswitches Setting
EB mode source SW1
Factory Set> OFF AUTO with MCB Over-ride
ON Use MANUAL-OFF-AUTO Switch
Auto Close Disable SW2
Factory Set> OFF Auto Close ENABLED
ON Auto Close DISABLED
Obstruction Behaviour SW3 SW4
Factory Set> OFF OFF Stop and retract to last upper limit then auto close if enabled*
OFF ON Stop and retract while obstruction remains*
ON OFF Stop with 2 second retract only, then auto close if enabled*
* If Door Close Retry is
enabled (SW 5 off) door will
close immediately after
obstruction behaviour
concludes
ON ON Stop then auto close if enabled*
Door Close Retry SW5
Factory Set> OFF Door will close after obstruct behaviour concludes
ON Door Close Retry DISABLED, only Auto Close will close the door after
obstruction behaviour, and time out concludes
Vehicle Close SW6
Factory Set> OFF Vehicle Close DISABLED
ON Door will close after obstruction clears, whilst open, opening or closing
Open Button Behaviour SW7 SW8
Factory Set> OFF OFF Door will go to open limit and remain while input remains held* when
released auto close will time out and close door
OFF ON Reverse direction during opening and closing
ON OFF Stop then reverse during opening, reverse during closing
* Door will remain open if auto
close is disabled
ON ON Press to Stop, then again to reverse during opening and closing
Receiver Behaviour SW9 SW10
Factory Set> OFF OFF Open only, stop then reverse during closing
OFF ON Reverse direction during opening and closing
ON OFF Stop then reverse during opening, reverse during closing
ON ON Press to Stop, then again to reverse during opening and closing
*Trigger Input Behaviour SW11 SW12
Factory Set> OFF OFF Close
OFF ON Door will open to upper most limit (then auto close if enabled)
ON OFF Door will go to open limit** and remain while input remains held (then auto
close if enabled)
* Trigger is 24VDC input
** When three limits are set
open limit becomes mid-limit
ON ON Custom Input via Parameters (Default - delay close as per timer pot)
Status Relay 3 Function SW13 SW14
Factory Set> OFF OFF ON when Door Moving
OFF ON ON when Door Moving, with 1Hz Oscillation
ON OFF ON Door Moving, 1 minute Time Extension
ON ON Custom (Default- on during obstruction, stays on for 2 sec after clear)
Status Relay 4 Function SW15 SW16
Factory Set> OFF OFF Relay is on when Service Required
OFF ON Relay flashes every second when service is required
ON OFF Unlock function
ON ON Custom Settings (Default – On if door has not closed for >5mins)
