GuestLink Powerwave pw1 Bedienungsanleitung

PowerWave PW1 (AV69005) Desktop Model

Installation Guide

8820-00062 AV69005-XXX

PowerWave PW1 Desktop Model

SECTIONS 12345678Table of Contents

TABLE OF CONTENTS

5. PW1 Lock Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

6. PW1 Rear Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

7. PC Resolutions Supported through the PowerWave Unit . . . . 11

8. Hospitality TV Tested and Supported . . . . . . . . . . . . . . . . . . . . . 12

1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Important Safety Instructions...............................1

Important Safety Symbols and Definitions ....................3

FCC Declaration Statement ................................3

Electrical Requirements ...................................4

2. Overview and Uses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

3. PW1 Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

4. PW1 Clamping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 23456781

INTRODUCTION

Congratulations and thank you for purchasing the guestLINK™PowerWave PW1. This audio video switch allows you to connect your

TV display to standard- and high-definition (HD) video sources from across the room. Please review this User Manual carefully.

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Installation should be performed by a qualified installer.

8. During installation, observe all governing codes and ordinances.

9. This device must be electrically grounded in accordance with local

codes or, in their absence, with the National Electrical Code ANSI/

NFPA No. 70—latest edition in United Sates, or with CSA Standard

C22.1, Canadian Electrical Code, Part 1, in Canada.

10. The electrical power to the device must be shut off while line

connections are being made. Failure to do so could result in serious

injury or death.

11. Do not block any of the ventilation openings. Install in accordance

with the manufacturer’s instructions.

12. Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including amplifiers) that

produce heat.

Important Safety Instructions

Read before operating equipment.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 23456781

INTRODUCTION

13. Do not defeat the safety purpose of the polarized or grounding-type

plug. A polarized plug has two blades with one wider than the other.

A grounding type plug has two blades and a third grounding prong.

The wide blade or third prong are provided for your safety. When the

provided plug does not fit into your outlet, consult an electrician for

replacement of the obsolete outlet.

14. Protect the power cord from being walked on or pinched particularly

at plugs, convenience receptacles, and the point where they exit

from the apparatus.

15. Only use attachments/accessories specified by the manufacturer.

16. Unplug this apparatus during lightning storms or when unused for

long periods of time.

17. Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way. Such

damage includes: damage to the power-supply cord or plug; liquid

spilled into, or objects fallen onto, the apparatus; the apparatus has

been exposed to rain or moisture and does not operate normally; or

the apparatus has been dropped.

18. This product may contain lead or mercury. Disposal of these

materials may be regulated due to environmental considerations.

For disposal or recycling information, please contact your local

authorities or the Electronic Industries Alliance: www.eiae.org.

19. Objects and Liquid Entry – Care should be taken so that objects

do not fall and liquids are not spilled into the enclosure through

openings.

Warning: To reduce the risk of fire or electric shock, this apparatus

should not be exposed to rain or moisture, and objects filled with

liquids, such as vases, should not be placed on this apparatus.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 23456781

INTRODUCTION

FCC Declaration Statement

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions:

1. this device may not cause harmful interference, and

2. this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

Important Safety Symbols and Definitions

Alternating current Protective earth (ground) Attention, consult

accompanying documents

Dangerous voltage

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from

that which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Communication Integrators, Inc., is not responsible for any interference

caused by unauthorized modifications to this equipment. Such

modifications could void the user’s authority to operate this equipment.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 23456781

INTRODUCTION

Electrical Requirements

This appliance must be supplied with the proper voltage and frequency,

and connected to an individual, properly grounded branch circuit,

protected by a circuit breaker, having amperage as noted on the rating

plate (the rating plate is located on back of the unit).

Observe all governing codes and local ordinances

1. A 120-volt, 60Hz, 15-Amp electrical supply is required.

2. Wire sizes and connections must conform to the rating of the

appliance in accordance with the American National Electrical

Code ANSI/NFPA No. 70—latest edition, or with Canadian CSA

Standard C22.1, Canadian Electrical Code, Part 1, and local codes

and ordinances.

WARNING

3. An extension cord should not be used with this appliance. Such

use may result in a fire, electrical shock, or other personal

injury.

WARNING

4. Electrical Shock Hazard

• Electrical ground is required on this appliance.

• Do not connect to the electrical supply until appliance is

permanently grounded.

• Disconnect power to the junction box before making the

electrical connection.

• This appliance must be connected to a grounded, permanent

wiring system.

Failure to do any of the above could result in a fire, personal injury, or

electrical shock.

These appliances are manufactured with a white neutral power supply

wire and a green grounding wire.

The mains plug is regarded as the disconnect device; it must remain

accessible at all times.

This device is to be connected to a mains outlet with a protective

earth connection.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 1 345678

OVERVIEW AND USES

The PW1 is a desktop version of the PW1A, sharing the same electronic components, connectors, and user interaction. It has been developed to offer a

very convenient audio video hub where users are able to connect all their audio video equipment, including Blu-ray® players, DVD or gaming consoles,

iPod or iPhone devices for audio or video displays, laptops, and legacy components. Digitizing all analog and video sources, the PW1 connects to an

HDTV via a single HDMI™ cable. Via an RJ45 jack, it can be connected to the in-room Internet port. It can also charge up to two phones or MP3 players

thanks to its USB ports. It also provides two extra power plugs to power devices up to 10 Amperes.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 12 45678

PW1 CONNECTIONS

Via the following connectors, users can connect their audio video devices.

• The HDMI connector is ideal for Blu-ray players, Sony®PlayStation®3, Microsoft®Xbox®, as well as up-converter DVD players. The maximum

resolution supported by the PW1 is 1080p at 60 frames per second (1920x1080 progressive). The PW1 is HDMI 1.3*-compliant and displays True

Color when available. The resolution displayed by the PW1 depends on the source resolution as well as on the TV resolution.

• Laptops can display a resolution of up to SXGA (1280x1024 at 60Hz) via the VGA connector. Specificities of multiple video cards present in

laptops, and resolution supported by sinks (TVs), can limit the display output to a lower resolution (as low as 640x480 if the video card of the

laptop supports it). The VGA connector does not conduct audio signal. A 3.5mm cable is necessary to connect the audio output of the laptop to

the PW1. A VGA cable meeting the full VESA specifications is required. As such, pin-9 needs to be present on the VGA connector to enable the

automatic detection of a source.

*The PW1 HDMI input complies with the following standards: HDMI V.1.3

and HDCP V.1.2. Older versions of these standards may not be supported.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 12 45678

PW1 CONNECTIONS

• The S-Video connector can display resolutions of up to 480i (NTSC) and 576i (PAL). As such, devices such as DVD players, and iPod and iPhone

devices can be connected and will display the resolution of the source up to 480i or 576i. The S-Video connector does not conduct audio. A 3.5mm

cable or a Left & Right RCA cable will be necessary to connect the audio output of the device to the PW1.

• The composite connector can display resolutions of up to 480i (NTSC) and 576i (PAL). As such, devices such as DVD players, digital cameras, and

iPod and iPhone devices can be connected and will display the resolution of the source at up to 480i or 576i. The composite connector does not

conduct audio. A 3.5mm cable or a Left & Right RCA cable is necessary to connect the audio output of the device to the PW1.

• The 18-pin connector supports all models of iPod, iPhone, and iPod touch via a 30-pin to 18-pin cable. It displays video resolution at up to 480i

(maximum iPod/iPhone output resolution) or 576i. It also charges iPod and iPhone devices.

• RJ45 pass-through. A CAT5 or CAT6 cable needs to be connected at the back of the unit to enable a hard-wire network connection.

• Both USB connectors will charge popular cellular phones such as the BlackBerry®. The original cable supplied by the cellular phone manufacturer

needs to be used to charge certain models.

• The 3.5mm audio connector can be used to connect any devices with a 3.5mm audio output to generate music through the PW1 into the speakers

of the HDTV.

• Power plugs and circuit breaker: The power within the PW1 system is distributed through the 15-Amp circuit breaker. The circuit breaker trips when

the total current drawn by the two AC plugs and the PW1 power supply board becomes equal to or greater than 15 Amps.

PowerWave PW1 Desktop Model

SECTIONSTable of Contents 123 5678

PW1 CLAMPING

The PW1 is supplied with a clamp that inserts into a cavity located on the right back panel.

Inhaltsverzeichnis

Andere guestLink Schalten Handbücher

guestLink

guestLink powerwave pw4 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

guestLink powerwave pw1 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken