D. Pairing IEM’s blood pressure monitor
i. Turn off all mobile devices nearby, especially Bluetooth.
ii. Set the mode selection switch at “P2.”
iii. Let the IEM’s blood pressure monitor at pairing mode.
iv. Count 30 seconds.
v. Turn on the gateway.
vi. The gateway shows the number of currently paired devices with LEDs for 5
seconds.
vii. The “Readings” LED turns GREEN.
viii. Wait for about a few minutes.
ix. At success, the “Readings” LED blinks GREEN 5 times.
x. At failure, the “Readings” LED blinks RED 5 times.
xi. The gateway goes to the step “v.”
xii. You can pair another device at P2 mode successively.
xiii. After completion of pairing, you should turn off, set the mode selection switch
at “N” and turn on the gateway for normal operation.
E. Pairing ForaCare’s thermometer
i. Set the mode selection switch at “P2.”
ii. Take a reading with the thermometer.
iii. Turn on the gateway.
iv. The gateway shows the number of currently paired devices with LEDs for 5
seconds.
v. The “Readings” LED turns GREEN.
vi. Wait for about a few minutes.
vii. At success, the “Readings” LED blinks GREEN 5 times.
viii. At failure, the “Readings” LED blinks RED 5 times.
ix. The gateway goes to the step “iv.”
x. You can pair another device at P2 mode successively.
xi. After completion of pairing, you should turn off, set the mode selection switch
at “N” and turn on the gateway for normal operation.
F. Pairing Beijing Choice’s Pulse oximeter
i. Set the mode selection switch at “P2.”
ii. Take a reading with the oximeter.
iii. When the Bluetooth icon of the oximeter flashes, remove the finger.
iv. Turn on the gateway.
v. The gateway shows the number of currently paired devices with LEDs for 5
seconds.
vi. The “Readings” LED turns GREEN.
vii. Wait for about a few minutes.
viii. At success, the “Readings” LED blinks GREEN 5 times.
ix. At failure, the “Readings” LED blinks RED 5 times.
x. The gateway goes to the step “v.”
xi. You can pair another device at P2 mode successively.
xii. After completion of pairing, you should turn off, set the mode selection switch
at “N” and turn on the gateway for normal operation.
3) Pairing
A. General process
