H3 Falcon 4118 Bedienungsanleitung
Falcon 4118
Quick Installation Guide
Release Date
Note
March 29th, 2021
May 26th, 2021
Firmware update process
Falcon 4118 Default Settings:
IP Address: 169.254.100.100
Gateway: 0.0.0.0
Administrator Username: admin
Administrator Password: admin
Dear Users
Thank you for choosing our product-Falcon 4118.
The excellent quality and performance make our products superior in the like product. For you to have
the good understanding to Falcon 4118, please read the installation guide and user manual, and operate
according to the suggested steps for each feature.
If you have any questions when using our machine, please feel free to contact us. We are more than
happy to serve you constantly.
Technical Support: support@h3platform.com
FAQ: https://www.h3platform.com/
H3 Platform Inc. mainly researches and develops PCIe switch-based technology and solutions.
---- H3 Platform Inc.
Contents
Chassis Overview ................................................................................................. 2
PCIe Port Number ................................................................................................ 3
Device Installation................................................................................................ 4
Cabling Guide....................................................................................................... 8
Additional Host Ports..........................................................................................10
Booting Process ..................................................................................................11
Set Up GUI ..........................................................................................................13
2
Chassis Overview
3
PCIe Port Number
Please refer to the image below to find the physical PCIe slots that is corresponding to the port numbers
displayed on the GUI.
E.g.
The device installed on the slot 1:1 will be shown on GUI as “1:1 – [device name]”.
Chassis rear view
GUI view
Device name may vary.
4
Device Installation
1. Pull out the drawer
1. Loosen the hand screws.
2. Pull the handle all the way down.
3. Pull the drawer out.
2. Remove the stabilization plate
1. Unscrew the stabilization plate (both sides).
2. Lift the plate up to remove.
5
3. Install Device
1. Plug the device to the PCIe slot.
2. Screw the bracket to hold the device in place.
Connect the PCIe power cable to the device if needed.
Caution:
The slots are single width. Oversized devices may not fit.
6
The power connectors are PCIe slot specific, only slot 1,2 and 7,8 can access the extra 225W PCIe power.
Please do not cross connect power cables to the devices on other PCIe slots.
The position of the power connector holder is adjustable.
Adjust the position of the power connectors for smooth device installation.
1. Loosen the screws.
2. Move the holders to desired position.
3. Tighten the screws to hold it in position.
7
4. Put the stabilization plate back
1. Place the stabilization plate back.
2. Screws on both sides to hold the plate in place.
There are three positions available for the stabilization plate, pick the ones that would not block the power
connectors of your DEVICE.
5. Insert the drawer back to the chassis
1. Push the drawer all the way into the drawer socket until slight resistance.
2. Lift the handle, the drawer will be pushed into the position.
3. Tighten the hand screws.
Inhaltsverzeichnis
Andere H3 Chassis Handbücher
