H3C ANT-5014P-M4 Bedienungsanleitung

Contents

H3C ANT-5014P-M4 patch antenna installation guide···································1

Technical specifications·····································································································································1

Safety precautions ·············································································································································3

Installation guidelines·········································································································································3

Choosing a mounting location····························································································································3

Mounting the antenna ········································································································································4

Installation accessories and tools ··············································································································4

Mounting the antenna on a pole·················································································································4

Installing the lightning arrester···················································································································5

Recommended cable·································································································································6

H3C ANT-5014P-M4 patch antenna

installation guide

Technical specifications

The ANT-5014P-M4 antenna is designed for use in outdoor environments. Use an antenna cable

with a type N connector to connect the antenna to a 5 GHz antenna port on an H3C outdoor AP.

Figure 1 Antenna view

Table 1 Technical specifications

Item

ANT-5014P-M4

Frequency range 5150 MHz to 5850 MHz

Gain 14 dBi

Horizontal beamwidth (HBW) 30 degrees

Vertical beamwidth (VBW) 30 degrees

Voltage standing wave ratio (VSWR) ≤ 1.8

Isolation ≥ 23 dB

Item

ANT-5014P-M4

Front and back ratio ≥ 20 dB

Polarization type ± 45

Maximum power 50 W

Impedance 50 Ω

Connector Type N female connectors

Dimensions (H × W × D) 210 ×120 × 42 mm (8.27 × 4.72 × 1.65 in)

Weight 0.45 kg (0.99 lb)

Operating temperature –55°C to +70°C (–67°F to +158°F)

Pole diameter 30 to 50 mm (1.18 to 1.97 in)

Installation method Pole mounting

Figure 2 and Figure 3 show the horizontal and vertical radiation patterns.

Figure 2 Horizontal pattern

Figure 3 Vertical pattern

Safety precautions

WARNING

•

Installing antennas carries some level of risk. For your safety, read the following safety

precautions carefully before your operation.

•

Keep the antenna away from power sources, street lamps, power distribution boxes, or other

places that might cause electrical shock.

•Do not touch any power lines for your safety.

•

Keep safety in mind when you select your installation site. Keep away from electric power lines

and other lines.

•

Do not work alone when you install the antenna.

•

If you need to raise a pole, work with other people to avoid bodily injury.

•

Do not use a metal ladder. Do not work on a wet or windy day. Dress properly, for example,

shoes with rubber soles. Wear rubber gloves.

•

If the antenna, antenna cable, or any other installation accessory drops, get away from it to

avoid bodily injury.

•

To avoid any potential hazards, always have a professional handle power connection rather

than attempting it yourself.

•

If an accident, for example, electrical shock, occurs, immediately call for qualified emergency

help.

Installation guidelines

To ensure optimal performance of the antenna, follow these guidelines:

•

Install the antenna vertically with the connector side facing downwards.

•

Keep the antenna away from metal obstacles, such as heating pipes and air conditioners.

•

The material and thickness of walls determine the number of walls that the RF signal can

penetrate. 5 GHz signal attenuation is large. Avoid signal penetration through solid walls.

•

As a best practice, ground the AP and the lightning arrester separately. If the AP is already

grounded, you can do not ground the lightning arrester.

Choosing a mounting location

To ensure optimal coverage, follow these guidelines when choosing a mounting location for the

antenna:

•

Perform site surveys to determine the antenna mounting location and height. Make sure no

obstruction, especially no solid walls and metal plates, exists between the antenna and the

target coverage area.

•

The antenna installation location must be as close as possible to the AP to reduce the antenna

cable length and signal loss.

•

The AP must be installed at a location where wires (cables or fibers) and power (local power

supply or PoE) can reach.

•

As a best practice, use an H3C RG-8/U low-loss antenna cable to connect the AP and the

antenna, and make sure the cable length does not exceed 10 m (32.81 ft).

Mounting the antenna

You can mount the ANT-5014P-M4 antenna on a pole. The installation accessories are provided

(installation tools are user supplied). If you intend to install your antenna in a way other than what is

described in this document, you must provide the appropriate installation accessories.

Installation accessories and tools

•

Installation accessories provided with the antenna:

One L-mounting bracket.

Two U-bolts.

Two pole-mount clamps.

Eight M6 nuts.

Eight flat washers with an inner diameter of 6 mm (0.24 in).

Eight spring washers with an inner diameter of 6 mm (0.24 in).

•

User-supplied installation tools:

One adjustable wrench.

One pole with a diameter of 30 to 50 mm (1.18 to 1.97 in).

Mounting the antenna on a pole

1. Use four M6 nuts, four flat washers, and four spring washers to attach the L-mounting bracket to

the antenna. (See callout 6 in Figure 4.)

2. Place a U-bolt around the pole, and pass the U-bolt through the target installation holes on a

pole-mount clamp.

3. Place a spring washer and flat washer on each end of the U-bolt, start an M6 nut on each end of

the U-bolt, and then fasten the nuts.

4. Repeat steps 2and 3to attach the other U-bolt to the other pole-mount clamp.

5. To change the vertical orientation of the antenna, select different installation holes in the

L-mounting bracket as needed.

Figure 4 Mounting the antenna on a pole

(1) Pole

(2) U-bolt

(3) Pole-mount clamp

(4) L-mounting bracket

(5) ANT-5014P-M4 antenna (6) M6 nut/flat washer/spring washer used for

securing the antenna

(7) M6 nut/flat washer/spring washer used for securing the pole

Installing the lightning arrester

No lightning arrester is provided with the antenna. Purchase one yourself.

The antenna is mounted outdoors. You must install a lightning arrester for it. To install a lightning

arrester, install it on the AP or on an outdoor antenna connector, connect an antenna cable to it, and

then ground it. Make sure the grounding terminals are grounded reliably.

Recommended cable

The ANT-5014P-M4 antenna has four antenna connectors. Use an antenna cable with a type N

connector to connect the antenna to a 5 GHz antenna port on an H3C outdoor AP. As a best practice,

use a high-quality and low-loss cable with the antenna. A coaxial cable loses efficiency as the

frequency increases, causing signal loss. Keep the cable as short as possible because cable length

also causes signal loss (the longer the run, the greater the loss).

Inhaltsverzeichnis

Andere H3C Antenne Handbücher

H3C

H3C ANT-5029D-M2 Bedienungsanleitung

H3C

H3C ANT-2009Y Bedienungsanleitung

H3C

H3C ANT-2503C-S4 Bedienungsanleitung

H3C

H3C ANT-2503C Bedienungsanleitung

H3C

H3C ANT-2503C-M6 Bedienungsanleitung

H3C

H3C ANT-2507P-S4 Bedienungsanleitung

H3C

H3C ANT-2503C-M2 Bedienungsanleitung

H3C

H3C ANT-5010Y Yagi Bedienungsanleitung

H3C

H3C ANT-2503CM Bedienungsanleitung

H3C

H3C ANT-2510P-M4 Bedienungsanleitung

H3C

H3C ANT-2510P-M4 Bedienungsanleitung

H3C

H3C ANT-2003CM Bedienungsanleitung

H3C

H3C ANT-2015P-M2 Bedienungsanleitung

H3C

H3C ANT-5011P-M3 Bedienungsanleitung

H3C

H3C ANT-2011P Bedienungsanleitung

H3C

H3C ANT-2015P Bedienungsanleitung

H3C

H3C ANT-2015Y Bedienungsanleitung

H3C

H3C ANT-2506V-M6-E Bedienungsanleitung

H3C

H3C ANT-2503C-S Bedienungsanleitung

H3C

H3C ANT-2503C-M3 Bedienungsanleitung

H3C

H3C Yagi ANT-5015Y Bedienungsanleitung

H3C

H3C ANT-2547V Bedienungsanleitung

H3C

H3C ANT-2015P-M3 Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

IWCS

IWCS iriBelt II Einrichtungshandbuch