H3C LSPM1FAN Bedienungsanleitung

H3C LSPM1FAN and LSPM1FANB

Installation Manual

Hangzhou H3C Technologies Co., Ltd.

http://www.h3c.com

Document version: 6W100-20111031

No part of this manual may be reproduced or transmitted in any form or by any means without prior

written consent of Hangzhou H3C Technologies Co., Ltd.

Trademarks

H3C, , Aolynk, , H3Care,

, TOP G, , IRF, NetPilot, Neocean, NeoVTL,

SecPro, SecPoint, SecEngine, SecPath, Comware, Secware, Storware, NQA, VVG, V2G, VnG, PSPT,

XGbus, N-Bus, TiGem, InnoVision and HUASAN are trademarks of Hangzhou H3C Technologies Co.,

Ltd.

All other trademarks that may be mentioned in this manual are the property of their respective owners

Notice

The information in this document is subject to change without notice. Every effort has been made in the

preparation of this document to ensure accuracy of the contents, but all statements, information, and

recommendations in this document do not constitute the warranty of any kind, express or implied.

Environmental protection

This product has been designed to comply with the environmental protection requirements. The storage,

use, and disposal of this product must meet the applicable national laws and regulations.

Conventions

This section describes the conventions used in this documentation set.

Convention Description

WARNING An alert that calls attention to important information that if not understood or followed can

result in personal injury.

CAUTION An alert that calls attention to important information that if not understood or followed can

result in data loss, data corruption, or damage to hardware or software.

IMPORTANT An alert that calls attention to essential information.

NOTE An alert that contains additional or supplementary information.

TIP An alert that provides helpful information.

Obtaining documentation

You can access the most up-to-date H3C product documentation on the World Wide Web at

http://www.h3c.com.

Click the links on the top navigation bar to obtain different categories of product documentation:

[Technical Support & Documents > Technical Documents] – Provides hardware installation, software

upgrading, and software feature configuration and maintenance documentation.

[Products & Solutions] – Provides information about products and technologies, as well as solutions.

[Technical Support & Documents > Software Download] – Provides the documentation released with the

software version.

Technical support

customer_service@h3c.com

http://www.h3c.com

Documentation feedback

You can e-mail your comments about product documentation to [email protected].

We appreciate your comments.

Contents

Fan trays overview······················································································································································· 1

LSPM1FAN fan tray ··························································································································································1

Overview···································································································································································1

Specifications····························································································································································1

LSPM1FANB fan tray························································································································································2

Installing and removing a fan tray······························································································································ 4

Safety guidelines ·······························································································································································4

Tools required····································································································································································4

Installing a fan tray ···························································································································································4

Removing a fan tray ·························································································································································5

Fan trays overview

LSPM1FAN fan tray

Overview

The LSPM1FAN fan tray blows cool air from the power module side to the network port side. It comprises

two separate fans. The LSPM1FAN features small size, fast heat dissipation, and hot swapping. It can

automatically adjust the fan speed, providing powerful heat dissipation for the device.

Figure 1 LSPM1FAN fan tray

(1) Captive screw (2) Airflow direction label

(3) Fan tray handle

Specifications

Table 1 LSPM1FAN specifications

Item Specifications

Fans Two 40 × 40 × 28 mm (1.57 × 1.57 × 1.10 in) fans

Airflow direction Fans blow air from the power module side to the

network port side

Max fan speed 18500 R.P.M

Max airflow 45 CFM

Max power consumption 19.5 W

Voltage 12 V

Item Specifications

Operating temperature –10°C to 70°C (14°F to 158°F)

Relative humidity 5% to 95% (non condensing)

Storage temperature –40°C to 75°C (–40°F to 167°F)

Relative humidity 5% to 95% (non condensing)

LSPM1FANB fan tray

Overview

The LSPM1FANB fan tray draws in hot air from the network port side to the power module side. It

comprises two separate fans. The LSPM1FANB features small size, fast heat dissipation, and hot

swapping. It can automatically adjust the fan speed, providing powerful heat dissipation for the device.

Figure 2 LSPM1FANB fan tray

(1) Captive screw (2) Airflow direction label

(3) Fan tray handle

Specifications

Table 2 LSPM1FANB specifications

Item Specifications

Fans Two 40 × 40 × 28 mm (1.57 × 1.57 × 1.10 in) fans

Airflow direction Fans draw in air from the network port side to the

power module side

Max fan speed 18500 R.P.M

Max airflow 45 CFM

Item Specifications

Max power consumption 19.5 W

Voltage 12 V

Operating temperature –10°C to 70°C (14°F to 158°F)

Relative humidity 5% to 95% (non condensing)

Storage temperature –40°C to 75°C (–40°F to 167°F)

Relative humidity 5% to 95% (non condensing)

Installing and removing a fan tray

The installation and removal procedures for the LSPM1FAN and LSPM1FANB are similar. For more

information, see “Installing a fan tray”and “Removing a fan tray.”

Safety guidelines

To avoid fan tray and device damage, and bodily injury, note the following guidelines when installing or

removing a fan tray:

•Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin contact.

•Do not touch any wire or connector on a fan tray.

•Do not place a fan tray on a moist area, and avoid liquid flowing into the fan tray.

•Do not remove any component on a fan tray. If a failure occurs on the internal wires or units, contact

the technical stuff to troubleshoot the problem.

Tools required

Prepare the following tools when installing and removing a fan tray:

•Phillips screwdriver

•ESD-preventive wrist strap

Installing a fan tray

TIP:

Before installing a fan tray, make sure the air flow of the fan tray is as required.

Step1 Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.

Step2 Take the fan tray from the package and check that the fan tray model is as required.

Step3 Face the slot into which the fan tray is to be installed. Grasp the handle of the fan tray with one hand and

support the fan tray bottom with the other, and then slide the fan tray along the guide rails into the slot

until the fan tray seats into the slot and has a firm contact with the connector on the backplane (see

callout 1 in Figure 3).

Step4 Fasten the captive screws on the fan tray with a Philips screwdriver until the fan tray is fixed into the

chassis (see callout 2 in Figure 3).

Figure 3 Install a fan tray

(1) Slide the fan tray into the slot (2) Fasten the captive screws

CAUTION:

•To prevent damage to the fan tray or the connector on the backplane, insert the fan tray

ently. If you

encounter a hard resistance while inserting the fan tray, pull out the fan tray and then insert it again.

•If the captive screws cannot be tightly fixed, check the installation of the fan tray.

Removing a fan tray

CAUTION:

•When replacing a fan tray with the device running, note safety with electricity.

•Do not touch rotating fans when replacing a fan tray with the device running.

Step1 Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.

Step2 Face the fan tray to be removed from the device. Loosen the captive screws on the fan tray with a Philips

screwdriver until the captive screws fall off the device, as shown in callout 1 in Figure 4.

Step3 Grasping the handle of the fan tray with one hand, pull the fan tray part way out the slot. Supporting the

fan tray bottom with the other hand, pull the fan tray slowly along the guide rails out of the slot, as shown

in callout 2 in Figure 4.

Step4 Put the removed fan tray on an anti-static mat or in its original package.

Figure 4 Remove a fan tray

(1) Loosen the captive screws on the fan tray (2) Pull the fan tray out of the slot

CAUTION:

•When removing a fan tray, take out the fan tray after the fans stop rotating.

•Do not touch the fans even if the fans stop rotatin

to avoid affectin

the fan balance, which can cause

greater fan operation noise.

•To ensure normal operation of the device, install a new fan tray within two minutes after the fan tray is

removed if you replace a fan tray with the device running.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere H3C Computerhardware Handbücher

H3C

H3C LSXM1SFF08B1 Bedienungsanleitung

H3C

H3C LSPM6G4T6 Bedienungsanleitung

H3C

H3C SecPath F5000-A5 NSQ1MPUA0 Bedienungsanleitung

H3C

H3C LSVM1FANSC Bedienungsanleitung

H3C

H3C LSXM1SFF16C1 Bedienungsanleitung

H3C

H3C BT1004E Bedienungsanleitung

H3C

H3C LSXM108CFAN Bedienungsanleitung

H3C

H3C NIC-FC730i-Mb-2-32G Bedienungsanleitung

H3C

H3C FAN-40-5-A Bedienungsanleitung

H3C

H3C H3C S7500E-X Bedienungsanleitung

H3C

H3C LSWM116Q Bedienungsanleitung

H3C

H3C SecPath FAN-120B-2-A16 Bedienungsanleitung

H3C

H3C SecPath M9000 NSQM1ADEDFGA0 Bedienungsanleitung

H3C

H3C LSWM124TG2H Bedienungsanleitung

H3C

H3C LSWM116FC Bedienungsanleitung

H3C

H3C LSXM112XFANH Bedienungsanleitung

H3C

H3C LSWM124XG2QFC Bedienungsanleitung

H3C

H3C LSPM6QP2PS Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung