Hama Cube Series Bedienungsanleitung
Mobile Speaker
RadioControlledAlarm Clock“Cube”
Funkwecker
NL
RUS
GR
PL
CZ
I
ALARM
SNOOZE/LIGHT
MODE +/RCC
-/°C/°F
14:06
DIE
21.5
C
1
1-
DATE
DAY TEMP
MONTH
E
Gebruiksaanwijzing
Οδηγίες χρήσης
Instrukcja obsługi
Használati útmutató
Návod kpoužití
Návod na použitie
Manual de instruções
Manual de utilizare
Bruksanvisning
Käyttöohje
Работна инструкция
F
D
GB Operating Instructions
Bedienungsanleitung
Mode d‘emploi
Instrucciones de uso
Руководство по эксплуатации
Istruzioni per l‘uso
H
SK
P
S
RO
FIN
BG
00186304
00186305
00176910
00176911
00176912
Technical data/Technische Daten
Power supply /Stromversorgung/Alimentation
électrique /Alimentación de corriente/ Питание
/Alimentazione elettrica /Stroomvoorziening /
Ηλεκτρική τροφοδοσία /Zasilanie elektryczne /
Tápellátás /Napájení /Napájanie /Alimentação
elétrica /Alimentarecucurent /Strömförsörjning
/Virransyöttö / Електрозахранване
2xAAA batteries
Battery /Batterie/ pile /pila /
батарея /batteria /batterijen
/μπαταρίες/bateria /elem /
baterie/batéria /pilha /baterie/
batteri /paristo / батерия
Frequenz/Frequenz /fréquences/frecuencia
/частот /frequenza /Frequentie / συχνοτήτων/
Częstotliwość/frekvencia /Frekvence /Frekvencia
/frequências /frecvențe/frekvensband /
Radiotaajuudet / Радиочестотни
77.5 kHz
Temperaturemeasuring range/ Messbereich
Temperatur/ Plage de mesuredelatempérature/
Rango de medición de temperatura/
Диапазон измерения температуры/Campo
di misurazione temperatura/ Meetbereik
temperatuur/ Εύρος μέτρησης θερμοκρασίας/
Zakres pomiaru temperatur/ Hőmérséklet mérési
tartomány/ Rozsah měření teploty/ Rozsah
merania teploty/ Amplitude de medição da
temperatura/ Domeniu măsuraretemperatură/
Mätområde temperatur/ Lämpötilan mittausalue/
Диапазон на измерване на температурата
0°C –+50°C
32°F –122°F
14-
MON
21.4 C
11
AM
DST
DATE
DAYTEMP
MONTH
12:26
1
2
34
5
7
6
ALARM MODE
SNOOZE /LIGHT
+/RCC -/°C/°F
8
910
11
12
13
2
1. Controls and display
1. Time
2. Date
3. Day
4. Temperature
5. DCF radio signal
6. DST–summer time
7. Alarm symbol
8. ALARM button
=sets the alarm/activates and
deactivates the alarm clock
9. MODE button
=settings/conrms the setting
10. +/RCC button
=activates and deactivates manual
radio signal reception/switches
between 12 and 24-hour format/
increases the current setting
11. -/°C/°F button
=decreases the current setting/
switches between °C and °F
12. SNOOZE/LIGHT button
=activates the backlight/interrupts the
alarm for approximately 10 minutes
13. Battery compartment
GOperating instruction
2. Package Contents
•Cube radio-controlled alarm clock,
•2xAAA batteries
•These operating instructions
3. Safety Notes
•Do not use the product in areas wherethe use of electronic devices is not permitted.
•Only connect the product to asocket that has been approved for the device. The
socket must be installed close to the product and easily accessible.
•Do not attempt to service or repair the product yourself.Leave any and all service
work to qualied experts.
•Do not modify the product in any way.Doing so voids the warranty.
3
Warning –Batteries
•Only use batteries (or rechargeable batteries) that match the specied type.
•Do not mix old and new batteries or batteries of adifferent type or make.
•When inserting batteries, note the correct polarity (+ and -markings) and insert the
batteries accordingly.Failure to do so could result in the batteries leaking or exploding.
•Only use batteries (or rechargeable batteries) that match the specied type.
•Do not overcharge batteries.
•Do not short circuit the batteries/rechargeable batteries and keep them away from
uncoated metal objects.
4. Getting started
4.1 Inserting the batteries
Open the battery compartment (13), remove the contact breaker and then close the
battery compartment (13).
4.2. Replacing the batteries
•Open the battery compartment (13), remove and properly dispose of the dead
batteries and insert two new AAA batteries with the correct polarity.Replace the
battery compartment (13) cover.
5. Operation
5.1 Automatic date/time setting using the DCF signal
•Once you have inserted the battery,the display is switched on, an acoustic signal
sounds and the alarm clock automatically starts searching for aDCF signal. During
the search, the radio symbol ashes.
•
Once radio signalreceiving is successful, the displayshows the symbol “radio tower“
continuously.no ashing. This process cantake7to5minutes.
•When the wireless signal is received, the date and time areautomatically set.
4
Display Searching for the DCF signal
Display ashing Active
Display steady Successful -signal reception
Not displayed Inactive –nosignal reception
Note –Cancellation of search process
•The search for the DCF signal can be cancelled by pressing the +/RCC button (10).
•Then set the time and date as described in 5.2 Manually setting the date/
time.
•Asearch for aDCF signal is nonetheless carried out daily (between 1amand 5
am) in order to update the time and date. If the signal is received successfully,the
time and date areautomatically overwritten.
Note –Time settings
•If,during initial setup of the device, no DCF radio signal is received within the rst
few minutes, the search is aborted. The radio icon (6) will go out.
•If thereare reception problems, we recommend leaving the clock to sit overnight,
since interference is generally less at night.
•In the meantime, you can start amanual search for the DCF radio signal at
another location or you can manually set the time and date.
•The clock automatically continues to search for the DCF signal on adaily
basis (at 1amand 5am). If the signal is received successfully,the manually
set time and date areoverwritten.
5
Press and hold the +/RCC button (10) for approx. 3seconds to start amanual search
for the DCF radio signal.
Note –Manual search
•The manual search is automatically aborted after 7minutes.
•Using the RCC button (10) frequently will drain the battery.Werecommend only
using this function to seek out an optimal location for the device.
Note –Summer time
•The clock automatically switches to summer time. DST (6) appears on the display
as long as summer time is activated.
5.2 Manually setting the date/time
•Press and hold the MODE button(9) for approximately3seconds until thehours display
beginstoash.
•Set thefollowinginformation in the order listed:
Time zone (+12/-12), Hours, Minutes, Year,Month,Day,Language
•Toselectthe individualvalues, press the +/RCC button (10)orthe -/°C/°F button(11),
andconrm each selectionbypressingthe MODE button(9).
•Press the MODE button (9) immediately to adopt the setvalue displayed and skip ahead.
•Ifyou do notmake an entry for 20 seconds,you automatically exit thesetting mode.
Note –Day of the week
•For the weekday display (3), you can choose from the following languages:
German (GER), English (ENG), Italian (ITA), Spanish (ESP), Dutch (NET), Danish
(DAN)and French (FRE).
6
Note –Time zone
•The DCFsignal canbereceivedover long distances,but alwaystransmitsthe current
CentralEuropeanTime in Germany.Make sure youaccount forthe time difference in
countries in othertimezones.
•Ifyou areinMoscow,the timeis3hours later than in Germany.Thismeans that
you should set+3for the timezone. The clockthensetsthe timeautomatically to 3
hoursahead after receiving theDCF signaloraccordingtothe manuallyset time.
Selecting 12 or 24-hour format
•Press the +/RCC button (10) to switch between the 12 and 24-hour formats.
Backlight
•Press the SNOOZE/LIGHT button (12) to light up the display for approximately 5
seconds.
5.3 Alarm clock
Setting the alarm time
•Press the ALARM button (8) to go to alarm mode.
•Press and hold the ALARM button (8) to set the alarm time for the alarm displayed.
The hours display begins to ash.
•Press the +/RCC button (10) or the -/°C/°F button (11) to select the hour for the
alarm time, and conrm your selection by pressing the ALARM button (8). The
minutes display begins to ash.
•Repeat the process to set the minutes for the alarm time.
•Press the ALARM button (8) repeatedly to go back to the time display.
•Ifyou do not make an entry for 20 seconds, the device automatically exits the
settings mode and the settings you made aresaved.
Activating/deactivating the alarm clock
•Press the Alarm button (8) repeatedly to activate/deactivate the alarm time.
•Ifthe alarm is activated, the corresponding symbol is displayed.
7
Stopping the alarm clock/snooze function
•Ifthe alarm is triggered, an alarm signal will sound for 2minutes. The frequency of
the alarm signal increases the longer the alarm continues.
•Press the ALARM button (8) to stop the alarm.
Note –Snooze function
•While the alarm signal is sounding, press the SNOOZE/LIGHT button (12) to
activate the snooze function.
begins to ash on the display.The alarm signal will be stopped for 10 minutes,
after which it will sound again.
5.4. Temperature indicator
•Press the -/°C/°F button (11) to choose between °C and °F for the temperature
display.
6. Care and Maintenance
•Only clean this product with aslightly damp, lint-free cloth and do not use aggressive
cleaning agents.
•Make surethat water does not get into the product.
7. Warranty Disclaimer
Hama GmbH &CoKG assumes no liability and provides no warranty for damage resulting
from improper installation/mounting, improper use of the product or from failuretoobserve
the operating instructions and/or safety notes.
8. Declaration of Conformity
Hereby,Hama GmbH &CoKG declares that the radio equipment type
[00176910, 00176911, 00176912, 00186304, 00186305] is in compliance
with Directive 2014/53/EU.The full text of the EU declaration of conformity
is available at the following internet address: www.hama.com -> 00176910, 00176911,
00176912, 00186304, 00186305->Downloads.
8
1. Bedienungselemente und Anzeigen
1. Uhrzeit
2. Datum
3. Tag
4. Temperatur
5. DCF-Funksignal
6. DST–Sommerzeit
7. Alarmsymbol
8. ALARM-Taste
=Einstellung Wecker /Aktivierung/
Deaktivierung Wecker
9. MODE-Taste
=Einstellungen/Bestätigung des
Einstellungswerts
10. +/RCC-Taste
=Aktivierung/Deaktivierung
manueller Funksignal-Empfang/
Wechsel 12-/24-Stundenformat
/Erhöhung des aktuellen
Einstellungswerts
11. -/°C/°F-Taste
=Verminderung des aktuellen
Einstellungswerts/Wechsel zwischen
°C und °F
12. SNOOZE/LIGHT-Taste
=Aktivierung
Hintergrundbeleuchtung/
Unterbrechung des Wecksignals für
ca. 10 Minuten
13. Batteriefach
DBedienungsanleitung
2. Packungsinhalt
•Funkwecker Cube
•2AAA Batterien
•diese Bedienungsanleitung
3. Sicherheitshinweise
•Benutzen Sie das Produkt nicht in Bereichen, in denen elektronische Produkte nicht
erlaubt sind.
•Positionieren Sie das Produkt nicht in der Nähe von Störfeldern, Metallrahmen,
Computern und Fernsehern etc. Elektronische Geräte sowie Fensterrahmen
beeinträchtigen die Funktion des Produktes negativ.
•Versuchen Sie nicht, das Produkt selbst zu warten oder zu reparieren. Überlassen Sie
jegliche Wartungsarbeit dem zuständigen Fachpersonal.
Dieses Handbuch passt für folgende Modelle
5
Inhaltsverzeichnis
Sprachen:
Andere Hama Wecker Handbücher
Hama
Hama The Cube Bedienungsanleitung
Hama
Hama 00123174 Bedienungsanleitung
Hama
Hama Wave Bedienungsanleitung
Hama
Hama A400 Bedienungsanleitung
Hama
Hama Classic Bedienungsanleitung
Hama
Hama Fashion Bedienungsanleitung
Hama
Hama Nostalgie Bedienungsanleitung
Hama
Hama Elegance Duo Bedienungsanleitung
Hama
Hama Elegance Duo Bedienungsanleitung
Hama
Hama RC 170 Bedienungsanleitung
Hama
Hama Elegance Duo Bedienungsanleitung
Hama
Hama Sheep Bedienungsanleitung
Hama
Hama RC400 Bedienungsanleitung
Hama
Hama Nostalgie Bedienungsanleitung
Hama
Hama Nostalgie Bedienungsanleitung
Hama
Hama Message Bedienungsanleitung
Hama
Hama RC 750 Bedienungsanleitung
Hama
Hama Elegance Duo Bedienungsanleitung
Hama
Hama RC 170 Bedienungsanleitung
Hama
Hama Fashion Plus Bedienungsanleitung
