6
4.1 Antenna connection /alternative solutions
Note
•To optimise reception, the glass adhesive antenna
should be tted such that it is in contact with the
vehicle body.
•If your vehicle’sApillar is covered with fabric or other
insulating material, tthe metal foil thereanyway.
•Consult alocal car workshop regarding the antenna’s
contact with the vehicle body.
•Fit the antenna at the edge of the windscreen (preferably
on the passenger side) and connect the metal foil to your
vehicle’sApillar.
•Then connect the SMB connector of the antenna cable to
the antenna input (14) of the adapter.
Note
•The included glass adhesive antenna can be replaced
by an alternative antenna solution.
•The existing vehicle antenna can continue to be used
with an adapter.
•Consult acar workshop or visit www.hama.comfor
suitable accessories.
4.2 Mounting
Warning –Risk of injury
•Take carethat components such as airbags, safety
areas, controls, instruments, etc. and visibility arenot
blocked or restricted.
•Do not allow yourself to be distracted by the product,
for example when driving avehicle or operating sports
equipment. Always pay attention to the surrounding
tracand your environment.
Note
•Beforemounting the holder,check the installation
options in your vehicle. If in doubt, consult the manual
for your vehicle or contact the manufacturer.
•Strictly avoid using undue force when using the
product or during installation.
A) Mounting to ventilation grille
•Fit the mounting adapter for ventilation apertures to the
back of the product. (FigureA)
•Now insert the device into the ventilation grille.
•The peg for the mount in the ventilation grille can be
turned 360° so that you can adjust alignment.
B) Mounting using the adhesive pad
Note –Mounting surface
Please note that the selected mounting surface (e.g.
dashboard) should be free of dust and grease. Use a
suitable cleaning agent from aspecialised dealer to
clean the surface.
•Fit the mounting adapter with the adhesive pad to the
back of the product (FigureB).
•Clean the surface to which the adhesive pad is to be
axed.
•Now remove the protective lm from the adhesive pad
and mount the adapter on the chosen surface.
4.3 Connection
Note
•Only use original accessories (or accessories approved
by Hama), to prevent damage to the product.
•Connect the supplied USB charging cable to the USB port
(16) of the device.
•Connect the unused plug on the USB cable to a12V
socket of your vehicle.
4.4 Switching on /Standby /Initial setup
Switching on the product
•Press and hold [ ](2) for about 3seconds to switch on
the device.
Switching off the product
•Press and hold [ ](2) for about 3seconds to activate
the standby mode.
Note
To switch off the radio completely,disconnect it from the
power supply.
