HAMPBACK ACE-Short Bedienungsanleitung
Installation Instruction
for ACE-Short Drum Cavity Series
Technology speed up the spread of music
1.Assemble the stand
Middle bend + one side
820mm straight pipe
Install the other 820mm
straight pipe
630mm bend pipe + 700mm
straight pipe on the right
630mm bend pipe + 820mm
straight pipe on the left
Install 350mm straight pipe
and 200mm straight pipe -A Apply to 3 cymbals
According to above figure, to assemble the stand and pad in turn
Pad Mount Holder
-B Apply to 4 cymbals -C 4 cymbals and Hi-Hat
Expand the stand according
to the arrow
According to above figure, to assemble the stand and pad in turn
Insert pad mount and tighten the wing nut
2.Assemble the pad
Wing nut
Pad nut
-A Apply to 3 cymbals -B Apply to 4 cymbals -C 4 cymbals and Hi-Hat
3-A . Attach the cymbals
Knob nut
Check bracket
Tighten screw
Felt washer
3.-B Install the Hi-Hat stand
The screw should be
the same side of the
hole
The screw should be
the same side of the
hole
4.Attach the Sound Module
connect DB25 Audio cable and fix it.
insert sound module and adjust wing konb to fix it
5.Attach the Kick Pedal
Open the kick drum stand entirely and lock the screw at sides
Install the beater into the holder securely by fixing the screw
Install the kick pedal securely
On the blanket
On the floor Position beater at the
center of kick drum
6.Power Connection & Wiring
To connect the jacks as shown in the figure, and using cable clip to organize the cables
AC Adapter DB25 Audio Cable
7.Power Connection & Wiring
Pads: (Snare, Tom 1/2/3)
Cymbals: (Hi-Hat, Crash, Ride)
Head shot Rim shot
Edge sensor Bow shot
Edge shot Bell shot
Pedal
Open Hi-Hat Half-open Hi-Hat Closed Hi-Hat
Adjust the beater
Adjust the center
of gravity of beate
Adjust the
gradient of beater
Adjust the
tightness of spring
Inhaltsverzeichnis
Andere HAMPBACK Trommel Handbücher
