© 2022 Hatco Corporation 1
2. Verify the mounting position of the posts on each base plate.
The posts are pre-installed on each base plate in the center
position. They can be moved to the offset position, if necessary:
a. Use the included hex wrench to loosen the set screw
securing the post to the base plate flange. Remove the base
plate from the post.
b.Usinga7/16″ socket wrench,removethe nutonthe bolt
inside the base plate flange that secures the flange to the
base plate. Then, reinstall the posts in the offset position
of the base plate. Use a torque wrench to tighten the nut to
20 ft-lbs.
Legs in offset position.Legs in center position.
Base Plate
Flange Post
3. Open up the stabilizer tabs on the base plates.
• The base plate of each post assembly has retractable
stabilizer tabs that can be pivoted out for extra stability during
installation or operation.
Tabs in retracted postion. Tabs pivoted to open postion.
4. Prepare to install the glass panel.
• There are two mounting holes provided on each side of the
glasspanel.Choosetheholepositionthatwillworkforthe
installation. Install the provided filler cap assembly in the
unused holes using a coin to hand-tighten.
Filler Cap
Cover
Filler Cap
Cover
Use coin
here.
Underside
of glass
panel.
Filler Cap
Assembly
installed.
Top side
of glass
panel.
P/N 07.14.007.00-1222 [B950P_IG]
INSTALLATION GUIDE
Hatco / ADM Sneezeguards
Portable Sneeze Guards
Model B-950P
Model B-950P Portable Sneeze Guards are available in single bay
widthsfrom24″–66″(610–1676mm).Alloftheavailablewidths
areheightadjustablefrom13″–24″(330–610mm)andhave a
commonbaseplatedepthof14″(356mm).
For additional information regarding Model B-950P, scan the QR
Code below:
https://www.sneezeguard.com/info.php?
Model=B-950P-GLASS&pid=79&osCsid=q3ksj3df96tqad14o2vhcqrnu6
Important Safety Information
To avoid injury and damage to equipment or property, read the
following safety information before installing this equipment.
Do not attempt to assemble and install sneeze guards
alone. Installation of sneeze guards requires two or
more people, dependent upon unit.
Do not place anything on top of sneeze guard. It is not
designed to be a weight-bearing component.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit,
marring its appearance and making it susceptible to
soil accumulation. Use of abrasive materials will void
warranty.
Assembly and Installation
1. Unpackallcomponents.Verifythattheappropriatenumberof
the items below are present.:
•GlassPanel,3/8″
•PostandBasePlateAssembly,BrushedStainlessSteel
•EndPanel,3/8″Glassx2(optional)
•HardwarePacket(includeshexwrenchandextrasetscrews)
Glass Panel
Post and
Base Plate
Assembly
Height
Adjustment
Twist-Lock Nut
Glass
Clamp
