GENERAL INFORMATION
TECHNICAL DATA
This product is fitted with a low voltage LED
(DC 3.7V) bulb fitting and supplied with a suitable
LED bulb. HAY recommends using the supplied
bulb with this lamp.
FITTING TYPE | Low voltage LED G4
POWER W | 3 W
COLOUR TEMPERATURE | 3000K warm white
For replacements of LED bulbs, please contact
HAY or an authorised dealer. HAY will not accept
any responsibility for any accidents, injuries or
damages that occur due to the use of incorrect
bulbs.
∆ Max. charge voltage of battery: 4.25V
∆ Max. charging current: 1000mA
∆ Max. discharge current: 520mA
ATTENTION
The product must not be modified in any way.
HAY accepts no responsibility for any products
that have been modified or tampered with. If the
external USB charging cable is damaged it should
be replaced immediately. This lamp is designed
for indoor and outdoor use. HAY recommends
that the lamp is not kept outside while raining.
This lamp has an integrated high-performance
lithiumion battery. When charging the battery,
use a USB power source/driver with low voltage
(SELV) output with a constant voltage of 5V, input
current not more than 2A, according to IEC/
EN 61347213. After 300 charging cycles, it will
maintain a capacity of 75% or more.
To extend battery life, it is recommended to
regularly charge it with the supplied USB cable.
The battery in this lamp is non-replaceable. The
battery must be removed from the lamp and
disposed of safely before the lamp is disposed of.
Before removing the battery, make sure that the
lamp is not plugged into a power source. Please
read all instructions before installing the lamp.
NOTE | This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
∆ Reorient or relocate the receiving antenna.
∆ Increase the distance between the
equipment and receiver.
∆ Connect the equipment to an outlet on a
different circuit to the one the receiver is
connected to.
∆ Consult the dealer or an experienced
radio/TV technician for help.
