3
Installation
3Install the reader on the four
mounting studs being certain that
the reader is correctly oriented so
that the plastic card bezel on the
front of the reader fits through the
card slot opening in the front of
the panel. Do not over-tighten.
4Attach the card reader cable to the
card reader as shown. The locking tab
on the harness connector should be
aligned with the small protrusion on
top of the reader connector. Press the
connector in place until the tab locks.
5Connect the white Molex connector
on the opposite end to the machine’s
control board at the interface
connector shown as “B” at right. Now
install the “Reader Present Jumper”
at the location marked “A” at right.
AB
6Close the back panel on the machine while ensuring
that none of the wiring is pinched between the front
panel and the console housing. Replace the two panel
screws and tighten them snugly..
www.heartlandmicropayments.com DOC-DSLIM-MDC/Q-S/F-INST
