QUICK SETUP FROM iRC UI
STEP 3B.
Equipment Discovery
After polling for connected units, the
iRC UI will display the number of EV
that are found to be wired together.
If all connected EVs were found, press
Enter knob to continue.
# EV FOUND
Continue?
STEP 5.
Choose Box Temp Sensor
If more than 1 Evap was congured,
turn knob to change primary evap
which will be sensing the box temp.
Push knob to choose primary evap.
SELECT PRIMARY EV?
NAME Freezer 2B
STEP 4A.
Choose Unit Base Name
The Unit being named will have its
LED flashing white. Turn knob to
change base name: [Freezer, Cooler,
Unit, Box]. Push the knob to choose
the base name.
UNIT ADDRESS 123
NAME: Freezer 2 A
STEP 1.
Enter Expert PIN
First digit in PIN automatically flashes
for edit. Turn dial to change rst PIN
digit 0-9. Push Enter to choose digit.
Repeat with all digits. The Default
Expert PIN is 999999.
ENTER EXPERT PIN
X X X X X X
STEP 2.
Select Conguration Mode
Select EV to proceed with conguring
the system from the iRC UI.
CONFIG FROM?
EV
STEP 3A.
Equipment Discovery
After Conguration Mode is selected
as ‘EV’, the iRC will automatically
attempt to discover all units in the
system.
DISCOVERING
Equipment...
STEP 4B.
Choose Unit Sufx
Turn knob to change unit name
sufx: [ 1A, 1B, ..., 8H ]. Push the knob to
choose unit name sufx.
(Repeat this step with all your EV’s as
necessary)
UNIT ADDRESS 123
NAME: Freezer 2 A
STEP 6A.
Select if Condensing Unit
Wired
Press the knob to select YES, if there
is a condensing unit wired to an
evaporator.
CU WIRED?
NAME Yes
STEP 6B.
Select EV wired to Condensing
Unit
Turn the knob to select the evaporator
wired to the condensing unit.
Press the knob to choose the
evaporator.
CU WIRED TO EV?
NAME Freezer 2A
