10-00 3 32921 Rev A
G141 SERIES B-VENT GAS APPLIANCE
A. PREPARATION
1. CERTIFICATION.
he G141 Series Gas Fireplace has been tested in
accordance with the standard ANSI Z21.50-1998-
CGA 2.22-M98. he G141 has been certified by
Underwriters Laboratories Inc. for installation and
operation as described in these Installation
Instructions. All components are AGA or UL safety
certified.
2. LOCAL CODES.
Check with your local building code agency prior
to installing this appliance to ensure compliance
with local codes, including the need for permits
and follow-up inspections. his appliance must
conform with local codes, or in the absence of local
codes, comply with the National Fuel Gas Code,
ANSI Z223.1-latest edition in the U.S.; in Canada,
the CANI-B149-latest edition.
3. OPTIONAL COMPONENTS.
his gas appliance has been tested and listed for
use with the optional components listed below.
Many optional components may be purchased
separately and installed at a later date. However,
installation of a remote control will require electrical
power. o avoid costly reconstruction, a separate
The G141 B-Vent Gas Appliance
must consist of the following:
1. Fireplace
2. B-Vent System
3. ermination
Optional components include:
1. Remote Control
2. Outside Air Kit
3. Glass Doors
4. Refractory Upgrade
5. Quick ile rim
6. ID4
7. UD4
course of electrical power should be supplied to
the fireplace at the time of initial installation of the
system for possible addition of these accessories
at a later date.
4. FUEL.
Any additions, changes or conversions required
in order for the appliance to satisfactorily meet
the application needs, must be made by a
qualified service technician using factory
specified and approved parts.
his product is manufactured to use natural gas or
propane gas, depending on model purchased. A
natural gas fireplace can be converted to use
propane gas later, but only if done by a qualified
service technician and only if the CKP Natural Gas
to Propane Gas Conversion Kit is used. In the event
your appliance must be converted to natural gas
from propane, you must use a CKN Propane Gas
to Natural Gas Conversion Kit.
If any assistance is required during installation, please
contact your local dealer or contact Heatilator, echnical
Services Department, 1915 W. Saunders Street, Mt.
Pleasant, Iowa 52641.
HEA ILA OR® is a registered trademark of Heatilator,
a Division of Hearth echnologies Inc.
he G141 Series is a vented gas fireplace. While a significant amount of heat is created by the G141, it is not
intended to be and, therefore, should not be used as a heater.
Note: Illustrations throughout these instructions
reflect typical installations and are for design
purposes only. Actual installation may vary slightly
due to individual design preferences. However,
minimum and maximum clearances must be
maintained at all times.
Tools and building supplies normally required
for installation:
Saw Wall-finishing materials
Pliers Framing material
Hammer Fireplace surround
Phillips screwdriver Caulking material
ape measure Plumb line
Level Electric drill/bits
Square
