RF-Switch V2 – LED/button indication Installing the RF-Switch V2
Overriding the outputs
Output status LED’s
– Output active
when lit.
Power
status
LED
Pairing/override
buttons
Retaining Screw
To override an output on the RF-Switch V2, simplypress the override button once, the
output& LED will then be activated.
To override the output o, pressthe button once.
Rev 1.1 Model: RF-Switch V2
Want More Information?
PDF FAQ VIDEO
Call our support team on: +44 (0)1254 669090
Or view technical specications directly on our website:
www.heatmiser.com
Twitter: @heatmiseruk Facebook: facebook.com/thermostats
1 2
3
1. Using a small screwdriver,
slightly loosen the screw
located at the base of the
RF-Switch. You can then
carefully separate the front
panel from the back plate.
2. Position the RF-Switch back
plate on the wall, xing
into place using the screws
provided.
3. Terminate the cables to the
RF-Switch as shown in the
wiring diagram (section6).
4. Mount the front panel onto
the back plate, tighten the
retaining screw on the base.
5. Switch on the power supply,
the power LED will illuminate.
Heatmiser UK Ltd
Units 1-5 Hurstwood Court, Mercer Way
Shadsworth Business Park, Blackburn,
Lancashire, BB1 2QU, United Kingdom.
