Heatwagon DG250 Handbuch

Andere Handbücher für DG250

2

Dieses Handbuch passt für folgende Modelle

1

Inhaltsverzeichnis

Andere Heatwagon Heizung Handbücher

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

DG250/DG400

C US

Ductable

Construction

Heater

Installation and Maintenance Manual

Please retain this manual for future reference.

342 N. Co. Rd. 400 East

Va paraiso, IN 46383

219-464-8818 • Fax 219-462-7985

www.heatwagon.com

Revision 5-18

For your safety: Do not use this heater in

a space where gaso ine or other iquids

having f ammab e vapors are stored.

All manuals and user guides at all-guides.com

all-guides.com

2

All manuals and user guides at all-guides.com

3

All manuals and user guides at all-guides.com

4

Temp Rise 170º 180º

Recommended Duct WD1625HT5 WD2025HT5

Duct Adaptor AR250 AR400

Thermostat (confirm correct thermostat with serial number p.10-11) DIGTHIDF-5 DIGTHIDF-5

DIGTHIDF DIGTHIDF

TAB 1

NOTE

or or

All manuals and user guides at all-guides.com

5

pg.4

pg.4

pg.9

meeting electrical requirements. Tab 1, pg. 4 NOTE: Max incoming gas pressure

is 1/2 PSI (14” .C.) recommend

installation of install kit. Part#

INSTKIT (optional)

See page 16.

All manuals and user guides at all-guides.com

6

Fig. 3

tested and set-up

set-up

will it

Fig. 4

Pg. 8

Pg. 8

again

put

All manuals and user guides at all-guides.com

all-guides.com

page 9 and find the cause.

• Stop the machine as indicated in HEATI G MODE section

(Turning OFF)

• Stop the machine as indicated in HEATI G MODE section

(Turning OFF)

is operated with (DIGTHIDF) thermostat

ote: Jumper plug must be installed.

DO NOT UNPLUG TO STOP HEATER!

14 Pg. 8

shield

7

All manuals and user guides at all-guides.com

8

(see Heating Mode, Page 7)

(see Heating Mode, Page 7)

(Reverse Polarity)

Note: To measure manifold ressure use

gas ressure test set Part #G24507

Always check the regulations of local authorities.

•

Excessive pressures over 1/2 psi

(

Check for proper

b

S







#)63;1B16/+0):<

768)/-

!

" 

"  

  

  

  

  

  

  

  

  

  

  

  







 ! 

" 

"    

    

    

    

    

    

    

    

    

    

    

    

All manuals and user guides at all-guides.com

9

• The heater fails to start/ignite

• Defective transformer or electronic

control unit

• Faulty air switches • Check the air switch, filter & tube,

replace if defective

• Call Tech Service

• Control board or overheat limit

needs reset

• Push button to reset (see below)

(Confirm “H” Mode)

• Call Tech Service

• Confirm correct supply & manifold

gas pressure

• Make sure the warm air can exit freely

• Call Tech Service

• Faulty operation of room thermostat

Connect thermost t (option l) or blind plug to

thermost t recept cle. Unit will not run without

one of these items plugged into recept cle.

All manuals and user guides at all-guides.com

10

For mod l DG250, starting from SN 43300101

For mod l DG400, starting from SN 43400201

Not : 5 pin th rmostat plug

iring Diagram

P/N - BIE E10325

All manuals and user guides at all-guides.com