Henri Studio 4946F1 Gebrauchsanweisung

SETTING UP THE

4946F1

1) Prepare a suitable location for your new fountain. Set the

fountain in place with the pump reservoir facing away from your preferred viewing point.

2) Unwind the power cords for the three lights. If barbed fittings are attached under the light

rings, remove them. Insert the power cord of one light into the open hole in the center of the

lowest dish. Push most of that cord through the hole, pulling it back into the pump reservoir.

3) Repeat step 2 in the middle dish to slip another light into place in the center of the dish. Open

the slit in the small stopper and place the light power cord inside the groove in the stopper. This

should be within two or three inches of

the light. Close the stopper over the

power cord. Firmly press the

stopper into place in

the same hole.

4) Slip the remaining

light cord through the

side hole in

the center

of the

upper

dish. Seal

this hole with

another small stopper

just as you did in the middle

dish, making this dish

water-tight. In this case, you will want

about five inches of power cord to remain inside the dish between the stopper and the light.

5) Thread the clear standpipe down into the top dish’s center hole. Position the light in the low

space in front of the standpipe.

6) Use silicone sealant to affix the three copper spill plates. They should overhang the edge

perhaps about 3/16” or so to help the water break freely downward.

7) From behind the fountain, gather the three light power cords. For orderliness, you may want to

wind each of them up and fasten with a tie wrap. Plug all three of them into the wide side of the

light cord adapter, making sure to turn the locking nut snug but not to strip it. This locking nut

allows the adapter to be placed underwater if it is clean and tight.

8) To the remaining opening in the light cord adapter attach one end of the 5 meter long light

extension cord and tighten the nut. Then push the other end of the extension cord down the large

hole in the pump reservoir. Run it out from under the back of the fountain through the power cord

exit notch, which is immediately behind the exit hole.

9) Set your pump down in the reservoir as shown and run its power cord down and out as you did

with the light extension cord. Open the slit in the large two-hole stopper. Line the pump cord up

through the larger hole and the light extension cord through the smaller hole. Close the stopper up

and press it firmly, down into the hole in the floor to make the fountain water-tight

Make sure to place your fountain on a firm

area which will not settle. Note: Always

follow local electrical codes and use a

110V GFCI protected outlet.

10) Thread the smaller

barbed adapter into the

top of the pump.

Thread the

remaining,

larger

barbed

adapter into the

back wall of the

highest dish as

shown. Push

the water tube

onto both barbed

adapters

11) Read your

pump and light

instructions.

Fill the bottom bowl with water. Then plug in the pump and connect to the light transformer to

enjoy your fountain. If the pump does not immediately begin working, there may be an “airlock”

within the impeller chamber. Simply unplug and plug in a few times and it should start

csd 9/2020

IMPORTANT – WINTER CARE

Winter ice build-up can cause damage to concrete statuary. Follow

these tips to reduce winter weathering to your fountain:

* Disconnect power to pumps and lights.

* Remove plugs/stoppers/standpipes in all fountain bowls to open

drains and let all moisture out. Keep drains open throughout winter.

* Cover with a Henri fountain cover. Keep tight and do not let snow

or water collect in sagging areas.

* Do not allow snow or ice to build up on or against the concrete.

Remove snow before it turns to ice. Do not use antifreeze, salt or

chemical ice removers as these may damage concrete.

Online Resources

Products: www.henristudio.com/products

FAQs: www.henristudio.com/faq

Warranty: www.henristudio.com/warranty

Contact :

www.henristudio.c

om/contact

Caution: The use of Chlorine or Chlorine Bleach or water

coloring additives may damage the finish of your fountain.

Andere Henri Studio Freiluftbrunnen Handbücher

Henri Studio

Henri Studio 4012F2 Bedienungsanleitung

Henri Studio

Henri Studio 5231F21 Gebrauchsanweisung

Henri Studio

Henri Studio Large Rock Falls Fountain Bedienungsanleitung

Henri Studio

Henri Studio 5649F15 Bedienungsanleitung

Henri Studio

Henri Studio 4005F3 Gebrauchsanweisung

Henri Studio

Henri Studio Rock Falls 5887F2 Bedienungsanleitung

Henri Studio

Henri Studio 5887F3 Gebrauchsanweisung

Henri Studio

Henri Studio 5452F Kurzanleitung

Henri Studio

Henri Studio 5501F6 Gebrauchsanweisung

Henri Studio

Henri Studio 4006F17 Gebrauchsanweisung

Henri Studio

Henri Studio 5701F2 Bedienungsanleitung

Henri Studio

Henri Studio Palazzo Venus Bedienungsanleitung

Henri Studio

Henri Studio 5705F7 Bedienungsanleitung

Henri Studio

Henri Studio 5661F Bedienungsanleitung

Henri Studio

Henri Studio 4875A Handbuch

Henri Studio

Henri Studio 5513F20 Gebrauchsanweisung

Henri Studio

Henri Studio 5595F14 Gebrauchsanweisung

Beliebte Freiluftbrunnen Handbücher anderer Marken

Sunnydaze Decor

Sunnydaze Decor XSS-578 Bedienungsanleitung

Campania International

Campania International Bibendum FT-400 Bedienungsanleitung

Elkay

Elkay FLEXI-GUARD EFHA8 1M Series Installationshandbuch

S.R.Smith

S.R.Smith Color Light Stream 2CLSLBK Bedienungsanleitung

Hozelock Cyprio

Hozelock Cyprio Cascade 1500 Bedienungsanleitung

Campania International

Campania International Juliet Fountain Bedienungsanleitung

YARDART

YARDART FT-155 Bedienungsanleitung

Alpine

Alpine WIN732 Bedienungsanleitung

Campania

Campania Valencia Bedienungsanleitung

Campania International

Campania International FT-320 Bedienungsanleitung

GardenWize

GardenWize SWGSL230 Bedienungsanleitung

Kelkay

Kelkay Easy Fountain Rustic Windmill Bedienungsanleitung

Alpine

Alpine WIN258 Bedienungsanleitung

Bond

Bond Signature Series Bedienungsanleitung

Kenroy Home

Kenroy Home 51112COPBL Installationsanleitung

EasyPro

EasyPro Tranquil Décor HBB39 Bedienungsanleitung

Angelo Decor

Angelo Decor Castillo Bedienungsanleitung

Campania International

Campania International Girona FT-102A Bedienungsanleitung