IMPORTANT SAFETY INSTRUCTIONS:
When picking the location, keep in mind that there should be no visual obstructions between the Startastic
unit and the surface where the projection will show. This will ensure best results. Projection coverage - approx.
40ft distance. When using outdoors always plug into waterproof outlet.
Before using the electrical appliance, these basic
precautions should always be followed:
1. Read all instructions.
2. This unit is not intended for use by individuals (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the unit by a person responsible
for their safety. Children should be supervised to ensure that they do not play with the unit.
3. Do not operate the laser projector with the damaged cord or plug.
4. Do not operate the laser projector if it has been damaged in any way.
5. To reduce the risk of electric shock, unplug the laser projector from the outlet when not in use.
6. Do not intentionally shine into eyes or face.
7. Do not attempt to open the housing of LED light under any circumstance.
8. Do not use near infants/cribs and keep away from children.
Please read all instructions prior to use and save instructions for future reference.
1.
Locate the curved piece on the top part of the
stake. Hold the stake so that its angled piece is
pointing directly at the surface for LED projection.
Insert the stake into the ground.
Make sure you
insert the pointy end deep enough for unit’s stability.
2. Insert the adjustment screw of the stake into the
other side of the Connector opening. Hold the nut
in place with one hand, while turning the knob
clockwise to tighten. See Main Diagram.
3. Loosen the knob to adjust the angle (up or down) of
the LED projector. Tighten the knob to secure the position.
4. Run the extension cord to the projector. Connect to
the unit’s plug. You should use the waterproof outdoor
electrical outlet to connect to AC adaptor.
5.
When on, the LED projector will appear brightest in
complete darkness,
and will appear dimmer in
areas with additional light sources.
• Pressing the ON/OFF switch once, LED projector will
emit fast rotating images in 4 different colors.
• Press the ON/OFF switch twice, LED projector will
emit images slow rotating images in 4 different colors.
• Press the ON/OFF switch 3 times, LED projector will
emit fixed images, no rotation.
• Press the ON/OFF again will turn off.
SELECT THE LOCATION FOR STARTASTIC LED PROJECTOR
ASSEMBLY AND USAGE
INCLUDES: Main unit, adaptor, 12 holiday slides, Stake, Indoor Tripod Stand.
HOLIDAY SLIDES
ATTENTION: StarTastic LED projector is intended to
operate in temperatures from -35°C to 37°C.
At or below freezing temperature, it may take approx.
10 min to warm up and reach its full projection strength.
MOTION:
To activate motion, press ON/OFF switch
ONCE for high speed or TWICE for low speed.
Press the ON/OFF switch THREE times to
return to non-motion display.
SLIDE
CARTRIDGE
ON/OFF SWITCH
(HIGH/LOW
SPEED)
SLIDE SLOT
INTERCHAGABLE
SCENE
SIDE VIEW
ANGLE
ADJUSTER
KNOB
PLUG
STAKE
ADAPTOR
Slides are interchangeable by
changing the scenes.
Select the scene and place it
into the slide cartridge.
Next, insert the slide cartridge
into the slot of the unit.
Operation: Outdoor/Indoor
Maximum LED Power: 10W
AC Adapter Power Input: 100–240V 50/60Hz Output: DC5V/1.5A
Operating Temperature: -35°C to 37°C
Projection Coverage: 40 feet (distance)
SPECIFICATIONS:
