HighPoint SSD7140 Bedienungsanleitung

Dieses Handbuch passt für folgende Modelle

1

Inhaltsverzeichnis

Andere HighPoint Computerhardware Handbücher

HighPoint

HighPoint rDrive 6114VM-4T Bedienungsanleitung

HighPoint

HighPoint SSD7000 Series Bedienungsanleitung

HighPoint

HighPoint U.2 Series Bedienungsanleitung

HighPoint

HighPoint SRD Series Bedienungsanleitung

HighPoint

HighPoint SRD Series Bedienungsanleitung

HighPoint

HighPoint RocketRAID 1640 Bedienungsanleitung

HighPoint

HighPoint SSD7110 Bedienungsanleitung

HighPoint

HighPoint SSD7505 Bedienungsanleitung

HighPoint

HighPoint rDrive 6628AW Bedienungsanleitung

HighPoint

HighPoint RocketAIC 7505HW Series Bedienungsanleitung

HighPoint

HighPoint RR3740 Bedienungsanleitung

HighPoint

HighPoint RR3700 Series Bedienungsanleitung

HighPoint

HighPoint SRD Series Bedienungsanleitung

HighPoint

HighPoint RocketRAID 840A Bedienungsanleitung

HighPoint

HighPoint SSD7140A Bedienungsanleitung

HighPoint

HighPoint SSD7103 Bedienungsanleitung

HighPoint

HighPoint RocketStor 6661A-mSAS1 Bedienungsanleitung

HighPoint

HighPoint RocketRAID 4520 Bedienungsanleitung

HighPoint

HighPoint HighPoint RocketRAID 2700 Series Bedienungsanleitung

HighPoint

HighPoint SRD Series Bedienungsanleitung

HighPoint

HighPoint SRD Series Bedienungsanleitung

HighPoint

HighPoint SSD7103 Bedienungsanleitung

HighPoint

HighPoint rDrive 6114VW-4T Bedienungsanleitung

HighPoint

HighPoint SSD7540 Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

1

SSD7140

8x M.2 Port to PCIe 3.0x16 NVMe RAID Controller

Quick Installation Guide

V1.02

2

System Requirements

PC Requirements

•System with a free PCIe3.0 (or 4.0) x16 slot

•Windows 10 , Windows Server 2016 and Windows Server 2019

•Linux kernel 3.10 and later

•macOS 10.13 and later

SSD7140 Kit Content

•SSD7140 Controller Card

•Quick Installation Guide

SSD7140 Hardware

Front View

3

Hardware Installation:

Step 1. On the rear of the SSD7140, remove the six screws that secure

the unit’s heat sink to the PCB.

Step 2. Carefully remove fan’s power cable from the right-side of the

heatsink as shown below, then carefully flip the heatsink to the

left (like turning a page from a book).

Note: Take care when moving the heatsink to prevent damaging

the left fan’s power cable.

4

Step 3. These 8 screws are used to install the NVMe SSD’s.

Step 4. Please remove these screws from each of the M.2 slots.

Step 5. Gently insert the SSD into the slot.

Step 6. Refasten the screw to secure the SSD.

5

Repeat Steps 4 to 6 to install the remaining SSDs.

The following example shows eight SSD Samsung 970 EVO PLUS

PCIe Gen3 SSDs installed into Ports 1-8:

Step 7. After installing all SSDs, carefully flip the heatsink to the right.

Note: Make sure each SSD is carefully aligned and fastened to the

SSD7140 using the supplied screws. Loosely attached SSDs may

not be detected by the SSD7140 or host system.

Step 8. Carefully reinsert in the power supply cable of the cooling fan

that was removed in step 2.

6

Step 9. On the rear of the SSD7140, refasten the 6 screws that were

removed in step 1.

Step 10. Power up the SSD external power supply

Note: If the external power supply is not powered on, the SSDs

may drop offline or remain undetected, which could lead to data

loss.

7

SSD7140 relies on two power sources to support eight SSDs;

power supplied through the PCIe bus, and power from the

system’s PSU via an external power cable. If the external cable is

not connected, there will be insufficient power to support all 8

SSD’s; this may cause the SSDs to drop offline.

Note

：

The SSD7140 does not require the external power cord

when used with 2019 Macpro systems.

8

Note: Please be sure to connect NVMe before using the product to

reduce the occurrence of unnecessary errors!

Note: Install the driver in the system first and then install the board

Resources

A variety of manuals, guides and FAQ’s are available for the SSD7140

RAID controller.

In addition, we recommend visiting the Software Downloads webpage

for the latest drivers, management interfaces, and installation guides.

Software Download:

SSD7140 Driver, WebGUI, Installation Guides

https://highpoint-tech.com/USA_new/series-ssd7140-download.htm

Other Reference Information:

Mother Board & NVMe SSD Compatibility List

SSD7140 User Guides

https://highpoint-tech.com/USA_new/series-ssd7140-resource.htm

9

Customer Support

If you encounter any problems while utilizing the SSD7140, or have

any questions about this or any other HighPoint Technologies, Inc.

product, feel free to contact our Customer Support Department.

Web Support:

https://www.highpoint-tech.com/websupport/main.php

HighPoint Technologies, Inc. websites:

https://www.highpoint-tech.com

© Copyright 2020 HighPoint Technologies, Inc. All rights reserved.