9
English
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the
battery and recharge it after it has cooled for a while.
CAUTION
has been left for a long time in a location subject to
direct sunlight or because the battery has just been
used, the charge indicator lamp of the charger lights
then start charging.
0.2-second intervals), check for and take out any
foreign objects in the charger’s battery connector.
If there are no foreign objects, it is probable that the
battery or charger is malfunctioning. Take it to your
authorized Service Center.
with UC18YTSL is taken out, wait for a minimum of
3 seconds before reinserting it to continue charging. If
the battery is reinserted within 3 seconds, the battery
may not be properly charged.
HOW TO RECHARGE USB DEVICE
WARNING
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
port with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
USB device and battery are being simultaneously
charged.
recharging.
USB device from the charger.
of a USB device, but may also result in unexpected
accidents.
depending on the type of device.
2 A for the two USB charging ports.
Doing so may cause the charger to malfunction.
(1) Select a charging method
Depending on the charge method selected, either the
battery is inserted into the charger or the power cord
is plugged into an outlet.
(Fig. 5-a)
electrical outlet (Fig. 5-b)
(2) Connect the USB cable. (Fig. 6)
commercially available USB cable (appropriate to the
device being charged) into the USB port.
(3) When charging is completed (Fig. 7)
USING AS AN AC POWER SUPPLY
The product includes a convenient AC outlet for use as a
power supply for AC devices. (Current capacity is 8 A.)
AC devices can be used by plugging them into the AC
outlet on the charger with the charger power supply plug
plugged into an electrical outlet. (Fig. 8)
NOTE
exceed 8 A.
Doing so may cause the charger to malfunction.
Read the instruction manual carefully for the device to
be used, and check the current rating before use.
into an electrical outlet while using an AC device.
electrical outlet. (Fig. 9-a)
power supplied from an electrical outlet. (Fig. 9-b)
MAINTENANCE AND INSPECTION
1. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws
could result in serious hazard.
2. Cleaning of the charger
When the charger is stained, wipe with a soft dry cloth
or a cloth moistened with soapy water. Do not use
chloric solvents, gasoline or paint thinner, for they melt
plastics.
3. Transportation after use
WARNING
Detach any batteries from the charger before
transporting.
(Fig. 10)
A carrying handle is provided for easy carrying after
use. The handle can be stowed in the main unit for
compactness when not in use. (Fig. 11)
4. Store idle charger
When not in use, the charger should be stored in dry,
high or locked-up place — out of reach of children.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
NOTE
Due to HiKOKI’s continuing program of research and
change without prior notice.
